Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1978 Ford E250, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK. Remedy: FEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700.
SOME OF THE INVOLVED VEHICLES MAY HAVE DEFECTIVE CARBURETORS IN WHICH, UNDER CERTAIN CIRCUMSTANCES, THE SECONDARY THROTTLE PLATES MAY STICK OPEN. Remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE CARBURETOR AT NO CHARGE TO OWNER.
ON THE INVOLVED VEHICLES, THE STEERING TIE ROD AND LINK ASSEMBLIES WITH ADJUSTING SLEEVE CLAMPS MAY HAVE BEEN IMPROPERLY MANUFACTURED. THE CLAMPS CONTAIN A SHARP DIE MARK WHICH COULD CAUSE THE CLAMP TO FRACTURE WHEN THE CLAMP BOLT IS TIGHTENED TO SPECIFICATIONS. THE CLAMP COULD BREAK AND CAUSE SEPARATION OF THE TIE ROD ADJUSTING SLEEVES. Remedy: THE DEALER WILL REPLACE THE STEERING TIE ROD ADJUSTING SLEEVE AND CLAMP ASSEMBLY, FREE OF CHARGE, ON ALL AFFECTED VEHICLES.
ON THE INVOLVED VEHICLES, THE PARK ACTUATION SUPPORT PLATES ARE DEFECTIVE DUE TO THEIR SUSCEPTIBILITY TO CRACKING DUE TO IMPROPER HEAT TREATMENT DURING MANUFACTURE. AS A RESULT, FRAGMENTS FROM A BROKEN PLATE CAN BECOME LODGED IN THE TRANSMISSION PARKING PAWL MECHANISM. THIS COULD PREVENT THE TRANSMISSION PARKING PAWL FROM ENGAGING WHEN THE SELECTOR LEVER IS PLACED IN THE "PARK" POSITION, OR PREVENT THE PAWL FROM BEING DISENGAGED FROM THE PARK GEAR. Remedy: THE DEALER WILL REPLACE THE PARK ACTUATION CAM SUPPORT PLATES, FREE OF CHARGE, ON ALL AFFECTED VEHICLES.
ON THE INVOLVED VEHICLES, LEAKAGE MAY OCCUR AT THE THREADED CARBURETOR-TO-FUEL FILTER CONNECTION ON THE SUSPECT CARBURETORS. THIS IS DUE TO AN IMPROPERLY MACHINED CARBURETOR FUEL INLET CONNECTION. Remedy: DEALER WILL INSPECT AND, IF NECESSARY, WILL REPLACE THE CARBURETOR WITHOUT CHARGE TO OWNER.
THE SHIFT SELECTOR REACTION SPRINGS MAY BE DEFORMED AS A RESULT OF IMPROPER INSTALLATION OF SELECTOR LEVERS DURING COLUMN BUILDUP. THUS THE LEVER MAY NOT BE ABLE TO BE MOVED INTO THE INSERT DETENTS LOCATED IN THE STEERING COLUMN ASSEMBLY. THIS COULD PREVENT THE "PARK" GEAR FROM BEING ENGAGED. Remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE SHIFT SELECTOR REACTION SPRING WITHOUT CHARGE TO OWNER.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
VEHICLES EQUIPPED WITH 300 C.I.D. ENGINES AND CARTER IV CARBS. A WORN, TAPERED THREAD TAPPING TOOL WAS USED INSTEAD OF THE SPECIFIED STRAIGHT THREAD TAPPING TOOL. THE NON-UNIFORM THREAD COULD ALLOW GASOLINE LEAKAGE FROM THE FUEL FILTER TO CARBURETOR CONNECTION CREATING THE RISK OF AN UNDERHOOD FIRE.
VEHICLES ARE EQUIPPED WITH STEERING TIE ROD END LINK ASSEMBLIES WITH ADJUSTING SLEEVE CLAMPS THAT MAY HAVE BEEN IMPROPERLY MANUFACTURED. THE SLEEVE SLAMPS MAY HAVE FRACTURED WHEN THE CLAMP BOLT WAS TORQUED AND COULD BREAK ALLOWING THE TIE ROD ADJUSTING SLEEVE TO SEPARATE RESULTING IN A LOSS OF STEERING CONTROL WITHOUT PRIOR WARNING.
Certain vehicles equipped with 460 c.i.d. Engines and 4350-4v carburetors. The secondary throttle lever of the 4350-4v carburetor may experience a "hang-up" condition due to a die misalignment during the die-casting of the throttle body. The secondary throttle plates may remain open after a wide-open throttle application causing the vehicle to accelerate to high speed. The vehicle can be stopped by shifting into neutral and braking or by turning the ignition switch off.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain