Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1979 Chevrolet Camaro, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES. Remedy: HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.
ON CERTAIN VEHICLES, THE LOWER CONTROL ARM BALL JOINT TO STEERING KNUCKLE ATTACHING NUT MAY NOT HAVE BEEN TORQUED TO SPECIFICATIONS. THIS CONDITION COULD CAUSE THE NUT TO BACK OFF, RESULTING IN JOINT SEPARATION. Remedy: THE DEALER WILL PERFORM A TORQUE CHECK OF THE ATTACHING NUT, AND, IF NECESSARY, TIGHTEN IT. IN SOME CASES AN INADEQUATE TORQUE LEVEL MAY HAVE CAUSED BALL STUD OR STEERING KNUCKLE DAMAGE; IF SO, THE AFFECTED COMPONENTS WILL BE REPLACED AT NO CHARGE TO OWNER.
ON THE INVOLVED VEHICLES THE BRAKE STOPLIGHT AND CRUISE CONTROL SWITCH WHICH IS OPERATED BY THE BRAKE PEDAL MAY HAVE BEEN ASSEMBLED WITH AN INCORRECT LUBRICANT ON THE ACTUATING PLUNGER. THIS CAN CAUSE THE REAR BRAKE STOPLIGHTS TO BECOME INOPERATIVE AND THE CRUISE CONTROL, IF ACTIVATED, TO STAY ELECTRICALLY ENGAGED. Remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE BRAKE STOPLIGHT AND CRUISE CONTROL SWITCH AT NO COST TO OWNER.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles equipped with cruise control. The brake stop light and cruise control switch may be assembled with incorrect lubrication on the actuating plunger. This results in adverse wear between the internal contacts of the switch which can cause the plunger to stick and cause the rear brake stop lights to become inoperative and if the cruise control is actuated, to stay electrically engaged. Without stop light operation, a vehicle approaching from the rear would not be aware that the brake was being applied. If the cruise control would not disengage through brake pedal operation vehicle sp
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain