Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1979 Chevrolet Malibu, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES. Remedy: HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.
EXCESSIVE ENLARGEMENT OF THE WHEEL CYLINDER PILOT HOLE IN THE REAR BRAKE BACKING PLATE COULD ALLOW THE WHEEL CYLINDER TO ROTATE AND CAUSE LOSS OF BRAKE FLUID. CONSEQUENCE OF DEFECT: A LOSS OF BRAKE FLUID LEADS TO LOSS OF REAR BRAKE ACTION, CREATING THE POTENTIAL FOR AN ACCIDENT. FRONT BRAKES WOULD REMAIN OPERATIONAL. Remedy: ADD A PART TO PREVENT WHEEL CYLINDER FROM ROTATING.
REAR AXLE ASSEMBLY MAY HAVE AXLES THAT WERE IMPROPERLY MANUFACTURED. THIS CONDITION MAY RESULT IN SEPARATION OF THE AXLE SHAFT AND WHEEL ASSEMBLY FROM THE VEHICLE. Remedy: THE DEALER WILL INSPECT THE REAR AXLE TO DETERMINE WHETHER IT WAS MANUFACTURED AT THE BUFFALO PLANT. IF SO, THEY WILL MAKE AXLE MEASUREMENTS AND IF NECESSARY REPLACE OR MODIFY AFFECTED AXLE COMPONENTS WITHOUT CHARGE.
THE INVOVLED VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACTS". INCORRECT HEAD RESTRAINTS MAY HAVE BEEN INSTALLED. Remedy: DEALER WILL INSPECT AND, IF NECESSARY, INSTALL NEW HEAD RESTRAINTS AT NO COST TO OWNER.
THE BOLTS THAT ATTACH THE LOWER REAR CONTROL ARM TO THE FRAME MAY FRACTURE. THE REAR CONTROL ARM SUPPORTS AND POSITIONS THE REAR AXLE. FRACTURE OF THE BOLTS WOULD ALLOW THE CONTROL ARM TO DROP FREE. Remedy: BOTH REAR CONTROL ARM ATTACHMENT BOLTS WILL BE REPLACED WITHOUT CHARGE.
THE ELECTRO-CLEAR REAR WINDOW DEFOGGERS CONTAIN A DEFECT WHICH CAUSES THE GLASS TO SHATTER WITHOUT IMPACT DURING OR SOME TIME AFTER USE OF THE DEFOGGER. VERTICAL ELECTRICAL STRIPS MAY DETERIORATE AND CAUSE HOT SPOTS THAT CAN RESULT IN BREAKAGE OF THE REAR GLASS. Remedy: VEHICLES WILL BE INSPECTED FOR PRESENCE OF A PARTICULAR WEATHERSTRIP. IF PRESENT, A LAYER OF A SPECIAL CONDUCTIVE EPOXY WILL BE ADDED TO THE VERTICAL BAR ON THE REAR WINDOW GLASS. THIS EPOXY IS A NEW CONDUCTIVE MATERIAL WHICH WILL NOT REACT WITH THE WEATHERSTRIP.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, excessive enlargement of a pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate possibly leading to loss of brake fluid in the rear brakes and loss of rear braking capability.this Would result in increased stopping distances and possible crash. note: vehicles in ontario and quebec only.
On certain vehicles, excessive enlargement of a pilot hole in the rear backing plate could allow the wheel cylinder to rotate possibly leading to loss of rear braking action.
On certain vehicles, the heads of the rear seatbelt anchor bolts may break off during normal vehicle use and in the event of an accident in which the rear seatbelts are in use, the probability of injury to the wearer will be increased.
THE AXLE RETAINING "C" CLIP IN THE DIFFERENTIAL MAY DISLODGE AND ALLOW THE AXLE, WHEEL AND BRAKE DRUM TO SEPARATE FROM THE VEHICLE WHEN SUBJECTED TO SIDE FORCES. AXLE SEPARATION COULD RESULT IN LOSS OF VEHICLE CONTROL AND POSSIBLE CRASH.
On certain vehicles, the rear brake backing plates may develop a corrosion condition which could result in loss of rear brake fluid and loss of rear braking capabilities. This recall affects vehicles sold in the Maritime provinces only.
THESE VEHICLES MAY NOT COMPLY WITH CMVSS 1103 - EXHAUST EMISSIONS.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
THESE VEHICLES MAY NOT COMPLY WITH CMVSS 1103 - EXHAUST EMISSIONS. VEHICLES WITH 3.8 L ENGINES.
ON VEHICLES EQUIPPED WITH ELECTRIC DEFOGGERS THE TAILGATE GLASS MAY BREAK WHEN THE DEFOGGER IS ENERGIZED. STATION WAGONS ONLY.
On certain vehicles, the lower rear control arm to frame bolts may fracture causing lower control arm to drop free. If this happens vehicle damage or crash without warning may occur.
On certain vehicles equipped with cruise control. The brake stop light and cruise control switch may be assembled with incorrect lubrication on the actuating plunger. This results in adverse wear between the internal contacts of the switch which can cause the plunger to stick and cause the rear brake stop lights to become inoperative and if the cruise control is actuated, to stay electrically engaged. Without stop light operation, a vehicle approaching from the rear would not be aware that the brake was being applied. If the cruise control would not disengage through brake pedal operation vehicle sp