Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1985 Buick Somerset, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE. Remedy: HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
THE HEADLAMP SWITCH PANEL CIRCUITRY MIGHT EXPERIENCE EXCESSIVE HEAT BUILD UP THAT COULD CAUSE THE HEADLIGHTS TO CYCLE ON AND OFF. SUDDEN LOSS OF HEADLIGHTS AT NIGHT OR UNDER SEVERE DRIVING CONDITIONS COULD REDUCE VISIBILITY AND RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING. CORRECTION: DEALERS WILL INSPECT AND/OR REPLACE THE HEADLIGHT SWITCH AND/OR WINDSHIELD WIPER SWITCH PANELS ON SUSPECTED VEHICLES. NOTE: THE WINDSHIELD WIPER SWITCH PANEL WILL BE REPLACED ONLY TO MAINTAIN STYLING UNIFORMITY WITH THE NEW HEADLAMP SWITCH PANEL.
ON TWO DOOR MODELS, CRACKS MAY DEVELOP IN THE BODY PILLAR AROUND THE DOOR STRIKER BOLT HOLE. IF UNCORRECTED, THE CRACKS WOULD PROPOGATE SUCH THAT THE DOOR WOULD OPEN IN THE EVENT OF A VEHICLE CRASH. CORRECTION: REINFORCEMENT PLATES WILL BE INSTALLED ON THE LEFT AND RIGHT BODY PILLARS.
THE CARBURETOR RETURN SPRING ASSEMBLY MAY FAIL. THIS COULD PREVENT THE DECELERATION OF THE VEHICLE EVEN THOUGH THE DRIVER HAS REMOVED HIS FOOT FROM THE ACCELERATOR PEDAL. LOSS OF ACCELERATOR CONTROL COULD RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING.
THESE VEHICLES DO NOT COMPLY WITH CMVSS 1101 - EMISSION DEVICE.
VEHICLES WERE ASSEMBLED WITH INADEQUATE CLAMP LOAD ON THE TIE ROD ADJUSTER. THIS WOULD ALLOW THE TIE ROD TO LOOSEN AND SEPARATE FROM THE TIE ROD ADJUSTER. TIE ROD SEPARATION COULD CAUSE A LOSS OF STEERING CONTROL WHICH COULD RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain