Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1985 Ford Ranger, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK. Remedy: FEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700.
EQUIPMENT DESCRIPTION: AFTERMARKET BRAKE ROTORS FOR USE ON CERTAIN FORD AND MAZDA TRUCKS. CRACKED CASTINGS CAUSED CRACKS TO APPEAR ON THE OUTER DIAMETER OF THE ROTOR HAT OR AROUND THE STUD HOLE. Remedy: AIMCO WILL REIMBURSE CONSUMERS/INSTALLERS FOR THE COST OF REPLACEMENT ROTORS AND INSTALLATION. CONSUMERS ARE REQUESTED TO RETURN TO THE LOCATION WHERE THE ROTORS WERE ORIGINALLY PURCHASED/INSTALLED FOR REPLACEMENT.
THE NYLON FUEL SUPPLY AND RETURN LINES ARE IMPROPERLY ROUTED ALONG THE FRAME SIDE RAIL AND COULD CONTACT THE UNIVERSAL JOINT ON THE FRONT DRIVESHAFT. CONSEQUENCE OF DEFECT: SUCH CONTACT COULD CAUSE ABRASION OF THE LINES AND LOW PRESSURE FUEL LEAKAGE CREATING THE POTENTIAL FOR A FIRE. Remedy: REROUTE OR REPLACE AFFECTED FUEL LINES.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
4X4 VEHICLES WITH 2.3L ENGINES AND ELECTRONIC FUEL INJECTION. THE NYLON FUEL SUPPLY AND RETURN LINES MAY BE IMPROPERLY ROUTED ALONG THE FRAME SIDE RAIL. UNDER CERTAIN CONDITIONS, A MISROUTED LINE COULD MOVE OUT OF ITS INSTALLED POSITION AND COME IN CONTACT WITH A UNIVERSAL JOINT ON THE FRONT DRIVE-SHAFT. SUCH CONTACT COULD RESULT IN ABRASION OF THE LINES AND EVENTUAL LOW PRESSURE FUEL LEAKAGE. IN THE PRESENCE OF AN IGNITION SOURCE, THE POTENTIAL FOR A VEHICLE FIRE WOULD EXIST.
ON VEHICLES WITH FRONT-DRIVE AUTOMATIC LOCKING HUBS THE CAM IN THE FRONT HUB LOCKING MECHANISM MAY BE INCORRECTLY HEAT TREATED. THE CAM COULD FRACTURE UPON ENGAGEMENT OF THE FRONT DRIVE AXLES. IF A PIECE OF THE CAM BECAME EMBEDDED IN THE WHEEL HUB NUT IT COULD CAUSE THE NUT TO LOOSEN AND EVENTUALLY RESULT IN WHEEL SEPARATION AND POSSIBLE VEHICLE CRASH.
We checked the EU Safety Gate for recall alerts naming this model and its production years.
Source: EU Safety Gate (European Commission) · CC BY 4.0, © European Union
The coupling device was not installed at the correct height. As a result, an attached trailer could detach while driving, or components of the coupling device or drawbar could break, potentially causing loss of vehicle control or overturning and increasing the risk of accidents and injuries. Production dates not stated in the alert. Types: 2AB.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain