Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1985 Volkswagen Jetta, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN HYDRAULIC BRAKE HOSES, P/N 171.611.107B, SOLD AS REPLACEMENT EQUIPMENT FOR 1975-1985 VOLKSWAGEN (VW) RABBIT; 1985-1992 VW GOLF; AND 1980-1992 VW JETTA PASSENGER VEHICLES. POSSIBLE BRAKE HOSE RUPTURE COULD OCCUR WHICH FAILS TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 106, "BRAKE HOSES." Remedy: FOREIGN PARTS DISTRIBUTORS WILL NOTIFY OWNERS AND REPLACE THE BRAKE HOSES WITH COMPLIANT BRAKE HOSES. THE RECALL BEGAN ON MARCH 30, 2006. OWNERS MAY CONTACT FOREIGN PARTS DISTRIBUTORS AT 305-885-8646 EXT. 11.
THE END CAP CONNECTING THE HEAT EXCHANGER'S CORE TO THE ENGINE COOLING SYSTEM COULD RUPTURE AND ALLOW HOT COOLANT TO ESCAPE INTO THE PASSENGER COMPARTMENT. Remedy: REPLACE THE HEATER CORE WITH AN IMPROVED HEATER CORE.
FUEL PUMP, LOCATED INSIDE FUEL TANK, COULD SEIZE DURING HIGH AMBIENT TEMPERATURES BECAUSE OF AN EXTREME FINE MESH FUEL FILTER RESTRICTING THE FUEL FLOW. Remedy: INSTALL A MODIFIED FUEL PUMP AND FILTER.
THE CLIP LOCATED ABOVE THE EXHAUST PIPE WHERE IT ENTERS THE PRE-MUFFLER MAY MELT FROM EXCESSIVE HEAT CAUSED BY ENGINE IDLING. Remedy: THE DEALER HAS INITIATED A TWO STEP CORRECTIVE PROCEDURE: THE FIRST STEP CONSISTS OF IMMEDIATE REMOVAL OF THE PLASTIC CLIP ON ALL AFFECTED VEHICLES. STEP TWO INVOLVES REPLACEMENT OF THE PLASTIC CLIP WITH A METAL ONE WHEN PARTS ARE AVAILABLE.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
CORROSION DUE TO ROAD SALT MAY PREVENT THE HOOD LATCH AND THE SAFETY CATCH FROM WORKING PROPERLY. THIS COULD RESULT IN HOOD FLY-UP WHILE THE VEHICLE IS IN MOTION RESULTING IN OBSCURED DRIVER VISION AND A POSSIBLE CRASH. CORRECTION: OWNERS OF AFFECTED VEHICLES WILL BE ADVISED BY MAIL REGARDING THE NECESSITY FOR PERIODIC LUBRICATION OF THE ENGINE HOOD LATCH MECHANISM. DEALERS WILL BE ADVISED TO LUBRICATE THE ENGINE HOOD MECHANISM WHENEVER AN AFFECTED VEHICLE IS BEING SERVICED.
IF THE ENGINE OVERHEATS, IT IS POSSIBLE THAT THE WALL OF THE END CAP CONNECTING THE HEAT EXCHANGER'S CORE TO THE ENGINE COOLING SYSTEM COULD RUPTURE AND ALLOW HOT COOLANT TO ESCAPE. SHOULD THIS HAPPEN, SOME OF THE COOLANT COULD CONTACT THE DRIVER'S FEET, CAUSING INJURY AND STEAM UP THE INTERIOR OF THE VEHICLE, IMPAIRING VISIBILITY. CORRECTION: HEAT EXCHANGER WILL BE REPLACED.
The fuel pump located inside the fuel tank could seize during high ambient temperatures because of an extreme fine mesh fuel filter restricting the fuel flow. This could cause the vehicle to stall posing a threat to traffic safety. Correction: A modified fuel pump and filter will be installed.
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. - INOPERATIVE EGR VALVE -
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain