Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1986 Buick Lesabre, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE. Remedy: HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).
A SMALL NYLON BUSHING IN THE CRUISE CONTROL SERVO BAIL MAY SLIP OUT OF PLACE, CAUSING INTERMITTENT AND UNEXPECTED INCREASES IN ENGINE SPEED OR DIESELING (ENGINE RUN ON WITH IGNITION OFF). Remedy: INSTALL A NEW BUSHING IN CRUISE CONTROL SERVO BAIL.
THE PUSH PULL HEADLIGHT SWITCH MAY HAVE ELECTRICAL CONTACTS WHICH ALLOW AN INTERMITTENT HEADLIGHT CIRCUIT CAUSING HEADLIGHT TO FLICKER OR SUDDENLY GO OUT. CONSEQUENCE OF DEFECT: SUDDEN LOSS OF THE HEADLIGHTS UNDER SEVERE WEATHER OR NIGHTTIME DRIVING CONDITIONS COULD REDUCE DRIVER VISIBILITY WHICH MIGHT RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING. Remedy: REPLACE HEADLIGHT SWITCH AS NECESSARY.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
A SMALL NYLON BUSHING IN THE CRUISE CONTROL SERVO BAIL (BRACKET) MAY SLIP OUT OF PLACE RESULTING IN POSSIBLE INTERMITTENT INCREASES IN ENGINE SPEED OR DIESELING. THIS CONDITION COULD ALSO CAUSE THE SERVO ROD ASSEMBLY TO WEAR THROUGH THE BALL AND CATCH ON OTHER COMPONENTS POSSIBLY RESULTING IN A STUCK THROTTLE. THIS COULD RESULT IN LOSS OF VEHICLE CONTROL AND A POSSIBLE CRASH. CORRECTION: A BUSHING KIT WILL BE INSTALLED ON THE CRUISE CONTROL SERVO BAIL.
ON VEHICLES WITH ANTILOCK BRAKES,BRAKE FLUID MAY SEEP FROM THE ABS PRESSURE/WARNING SWITCH,EVENTUALLY LEADING TO THE LOSS OF THE HYDRAULIC PUMP MOTOR.ALSO THE PUMP MOTOR AND ABS ELECTRICAL RELAYS MAY HAVE BEEN CONTAMINATED DURING ASSEMBLY.THIS CAN CAUSE LOSS OF THE HYDRAULIC PUMP MOTOR &/OR THE ABS FUNCTION.LOSS OF THE PUMP MOTOR WOULD EVENTUALLY LEAD TO LOSS OF THE REAR BRAKES & LOSS OF POWER ASSIST TO THE FRONT BRAKES.THIS WOULD RESULT IN INCREASED STOPPING DISTANCE.AN INOPERATIVE ABS RELAY COULD CAUSE LOSS OF THE ABS FUNCTION.ABS,PUMP MOTOR RELAYS,& 30 AMP FUSES WILL BE REPLACED.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain