Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1986 Freightliner Conventional, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
STEERING ARM MAY FAIL IF USED ON EATON EFA12F4 FROM AXLE IN CONJUNCTION WITH ROSS HFB70 POWER STEERING GEAR. Remedy: INSTALL A NONADJUSTABLE 1500 PSI POWER STEERING PUMP PRESSURE RELIEF VALVE TO LIMIT STEERING ARM FORCES. REPLACE STEERING ARM WITH A DESIGN CAPABLE OF WITHSTANDING HIGHER FORCES. ADJUST MAXIMUM POPPET VALVE SETTINGS TO 500 PSI AND ADJUST AXLE STOPS.
INCORRECT SIZE AIR BRAKE ACTUATOR CHAMBERS WERE INSTALLED ON THE DRIVE AXLES. Remedy: REPLACE DRIVE AXLE BRAKE CHAMBERS WITH CORRECT SIZE CHAMBERS.
UNDER CERTAIN CONDITIONS, AN ELECTRICAL SHORT CIRCUIT CAN DEVELOP. Remedy: REPLACE EXISTING PICTURE FRAME TYPE BATTERY RETAINER WITH AN I FRAME RETAINER AND INSTALL CONVOLUTED TUBING OVER POSITIVE BATTERY CABLE.
FASTENER THAT CONNECTS THE HARNESS BELT D RING TO THE B PILLAR MAY NOT BE LONG ENOUGH TO PROVIDE FULL THREAD ENGAGEMENT WITH THE ANCHORAGE WELD NUT. Remedy: REPLACE MOUNTING HARDWARE WITH HEX SHOULDER BOLT AND .55 INCH SPACER.
THE HANDHOLD MOUNTING SYSTEM, WHICH CONSISTS OF A TUBULAR HANDLE HELD IN THREE PLACES BY CAST ALUMINUM BRACKETS AND ATTACHED TO THE ENGINE EXHAUST MUFFLER HEAT SHIELD. VIBRATION FROM THIS SYSTEM CAUSES THE HANDHOLD PARTS TO WEAR. CONSEQUENCE OF DEFECT: IF THE PARTS WEAR THIN THE POSSIBILITY EXISTS THAT THE HANDHOLD MIGHT GIVE WAY UNDER THE WEIGHT OF A DRIVER. THIS COULD RESULT IN PERSONAL INJURY. Remedy: REPLACE THE END BRACKETS WITH A MODIFIED DESIGN UTILIZING A RUBBER ISOLATER. ALSO, ADD A PLASTIC SLEEVE TO THE CENTER BRACKET FOR ISOLATION.
SEAT BELTS CAN LOOSEN AS THE TRUCK IS DRIVEN. CONSEQUENCE OF DEFECT: DRIVER AND PASSENGER WOULD NOT BE PROPERLY RESTRAINED IN EVENT OF A SUDDEN STOP OR CRASH. Remedy: REPLACE THE NON LOCKING RETRACTOR SEAT BELTS WITH AUTOMATIC LOCKING RETRACTOR SEAT BELTS.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
THE STEERING ARM USED ON THE EATON EFA-12FA FRONT AXLE MAY FAIL WHEN USED IN CONJUNCTION WITH ROSS HFB-70 POWER STEERING GEARS IF TORQUE LIMITING FEATURES ARE NOT MAINTAINED. A FAILED STEERING ARM WOULD CAUSE LOSS OF VEHICLE CONTROL AND COULD RESULT IN A CRASH WITHOUT PRIOR WARNING. CORRECTION: INSTALL A NONADJUSTABLE 1500 PSI POWER STEERING PUMP PRESSURE RELIEF VALVE TO LIMIT STEERING ARM FORCES. REPLACE STEERING ARM WITH A DESIGN CAPABLE OF WITHSTANDING HIGHER FORCES. ADJUST MAXIMUM POPPET VALVE SETTINGS TO 500 PSI AND ADJUST AXLE STOPS.
NOTE: MODEL FLC-112 CONVENTIONAL TRUCKS. VEHICLES WERE BUILT WITH INCORRECT SIZE AIR BRAKE ACTUATOR CHAMBERS. THIS COULD RESULT IN INCREASED STOPPING DISTANCES AND A POSSIBLE VEHICLE CRASH. CORRECTION: AIR BRAKE CHAMBERS WILL BE REPLACED WITH CHAMBERS OF THE CORRECT SIZE.
AN ELECTRICAL SHORT CIRCUIT CAN DEVELOP BETWEEN A POSITIVE BATTERY POST AND THE BATTERY RETAINER FRAME. THE POSITIVE BATTERY CABLE MAY ALSO CHAFE ON THE BATTERY RETAINER FRAME AND RESULT IN A SHORT CIRCUIT AND POSSIBLE FIRE. CORRECTION: "PICTURE FRAME" BATTERY RETAINER WILL BE REPLACED WITH "I-FRAME" TYPE BATTERY RETAINER AND CONVOLUTED TUBING WILL BE INSTALLED OVER POSITIVE BATTERY CABLE.
THE HANDHOLD MOUNTING SYSTEM CONSISTS OF A TUBULAR HANDLE HELD IN THREE PLACES BY CAST ALUMINUM BRACKETS WHICH ARE, IN TURN, ATTACHED TO THE ENGINE EXHAUST MUFFLER HEAT SHIELD. VIBRATION FROM THE EXHAUST SYSTEM CAUSES THE HANDHOLD PARTS TO WEAR THIN AND COULD CAUSE THE HANDHOLD TO GIVE WAY UNDER THE WEIGHT OF A DRIVER. THIS COULD RESULT IN PERSONAL INJURY. CORRECTION: REPLACE THE HANDHOLD WITH A MODIFIED DESIGN WHICH UTILIZES A RUBBER ISOLATOR. ADD A PLASTIC SLEEVE TO THE CENTER BRACKET FOR ISOLATION.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain