Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1988 Buick Regal, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE. Remedy: HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).
VEHICLE DESCRIPTION: PASSENGER VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WEST VIRGINIA, WISCONSIN, AND THE DISTRICT OF COLUMBIA, WHERE ROAD SALT USE IS HEAVY. A CONDITION WHERE ONE OR BOTH FRONT ENGINE CRADLE BOLTS CAN PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINERS. Remedy: DEALERS WILL REPLACE THE FRONT AND REAR FRAME/CRADLE BOLTS AND RETAINERS.
TWISTED COMPONENTS COULD ALLOW THE LEFT FRONT BRAKE HOSE TO CONTACT THE FENDER LINING/RAIL AREA; OVER TIME THE BRAKE HOSE COULD WEAR THROUGH. Remedy: INSPECT LEFT FRONT BRAKE HOSE FOR PROPER INSTALLATION AND REPLACE, AS NECESSARY.
CRACKS DEVELOP IN THE WHEEL MOUNTING SURFACE. IF THESE CRACKS BECOME SEVERE ENOUGH, THE WHEEL WILL COMPLETELY SEPARATE FROM THE VEHICLE. Remedy: DEALERS WILL INSPECT THE MANUFACTURING DATE CODES STAMPED ON EACH WHEEL OF THE VEHICLE AND IF A WHEEL FALLS WITHIN THE SPECIFIED DATE CODE RANGE, THE DEALER WILL REPLACE THAT WHEEL ASSEMBLY.
CRACKS DEVELOP IN THE WHEEL MOUNTING SURFACE. IF THESE CRACKS BECOME SEVERE ENOUGH, THE WHEEL WILL COMPLETELY SEPARATE FROM THE VEHICLE. Remedy: DEALERS WILL INSPECT THE MANUFACTURING CODES STAMPED ON EACH WHEEL OF THE VEHICLE AND IF A WHEEL FALLS WITHIN THE SPECIFIED DATE CODE RANGE, THE DEALER WILL REPLACE THAT WHEEL ASSEMBLY.
VEHICLE DESCRIPTION: PASSENGER VEHICLES AND MINI VANS ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT AND WISCONSIN. THE REAR CRADLE BOLTS PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINER. IF BOTH BOLTS PULL THROUGH, THE REAR CRADLE WOULD NOT LONGER BE SUPPORTED AT THESE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT CAN SEPARATE FROM THE STEERING GEAR. Remedy: DEALERS WILL REPLACE THE REAR CRADLE BOLTS AND RETAINERS.
FRONT SHOULDER BELT GUIDE LOOP ATTACHMENT FASTENER MAY PULL THROUGH DOOR MOUNTED ANCHOR PLATE. Remedy: REPLACE FRONT SHOULDER BELT GUIDE LOOP ATTACHMENT NUTS AND INSTALL NEW GUIDE COVER.
LOWER CONTROL ARM TO BALL JOINT ATTACHMENT CAN BECOME LOOSE. ALSO, CERTAIN CARS COULD HAVE TIE ROD BALL STUD NUTS THAT WERE NOT PROPERLY TORQUED AND COULD LOOSEN. Remedy: REPLACE BOTH LOWER CONTROL ARMS; ALSO, CHECK TIE ROD BALL STUD NUT TORQUE.
THE SECONDARY HOOD LATCH MAY NOT PROPERLY ENGAGE. Remedy: REPLACE SECONDARY LATCH WITH A NEW LATCH.
AN INTERFERENCE BETWEEN THE TRANSMISSION SHIFT CABLE AND THE BELLCRANK CLIP IN THE STEERING COLUMN CAN RESULT IN DISENGAGEMENT OF THE TRANSMISSION CABLE. Remedy: A NEWLY DESIGNED BELLCRANK CLIP WILL BE INSTALLED.
THE STOP LAMP SWITCH MAY HAVE A LOOSE ELECTRICAL CONTACT. THE LOOSE CONTACT CAN OVERHEAT AND MELT THE SURROUNDING PLASTIC CAUSING THE CONTACT TO STICK OPEN. Remedy: THE ROTARY SOPLAMP SWITCH WILL BE REPLACED ON ALL INVOLVED VEHICLES.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Vehicles located in the high corrosion provinces east of the Manitoba/Ontario border. Certain vehicles may exhibit a condition in which the frame/cradle retainer bolts pull through the retainers due to corrosion of the retainer. If both front bolts or both rear bolts pull through, the frame/cradle would not be properly supported and the intermediate steering shaft may separate from the steering gear. If this were to occur while the vehicle was in motion, a vehicle crash could result without prior warning. Correction: Dealers will replace the front and rear frame/cradle bolts and retainers. Note: This recall superceedes TC recall 1995-010.
On certain vehicles, cracks may develop in the wheel mounting surface, and, should the cracks become severe enough, the wheel could completely separate from the vehicle. This could adversely affect steering and braking control and result in a crash without prior warning. Correction: Vehicles will be inspected and wheels falling within a specified date code range will be replaced.
On certain vehicles, the rear engine cradle bolts may pull through due to corrosion of the retainers. If this should occur, the cradle would no longer be supported at these mounting locations and the steering shaft may separate from the steering gear. This could result in loss of steering control. Correction: Rear cradle bolts and retainers will be replaced.
On certain vehicles, the steel wheels may develop cracks in the wheel mounting surface and, should the cracks become severe enough, the wheel could completely separate from the vehicle. This could adversely affect steering and braking control and result in a vehicle crash. Correction: Wheels will be inspected and replaced if required.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Certain vehicles do not comply with CMVSS 210 - Seatbelt Assembly Anchorages. Anchor bolt may pull through the upper anchorage plate. Correction: Nut assembly with a larger diameter flanged nut will be installed in place of the existing nut assembly.
THE LEFT FRONT BRAKE HOSE COULD CONTACT THE FENDER LINING/RAIL AREA AND EVENTUALLY WEAR THROUGH. THIS COULD CAUSE A LOSS OF BRAKE FLUID AND A PARTIAL LOSS OF BRAKING CAPABILITY RESULTING IN INCREASED STOPPING DISTANCES. THIS COULD RESULT IN A VEHICLE CRASH. CORRECTION: LEFT FRONT BRAKE HOSE WILL BE INSPECTED FOR PROPER INSTALLATION AND REPLACED AS REQUIRED.
THE SECONDARY HOOD LATCH MAY NOT PROPERLY ENGAGE ON THESE VEHICLES. IF THE PRIMARY HOOD LATCH WERE TO DISENGAGE, THE HOOD COULD UNEXPECTEDLY OPEN. IF THIS WERE TO OCCUR WHILE THE VEHICLE WAS IN MOTION, THE HOOD COULD FLY UP AND OBSTRUCT THE FORWARD VISION OF THE DRIVER POSSIBLY RESULTING IN A VEHICLE CRASH. CORRECTION: SECONDARY HOOD LATCH WILL BE REPLACED ON ALL INVOLVED VEHICLES.
THE LOWER CONTROL ARM TO BALL JOINT ATTACHMENT COULD BECOME LOOSE ON THESE VEHICLES. ALSO, THE TIE ROD BALL STUD NUTS MAY NOT HAVE BEEN PROPERLY TORQUED AND COULD LOOSEN. EITHER CONDITION COULD RESULT IN A BALL JOINT SEPARATION AND CAUSE LOSS OF STEERING CONTROL AND A VEHICLE CRASH WITHOUT PRIOR WARNING. CORRECTION: BOTH LOWER CONTROL ARMS WILL BE REPLACED AND THE TIE ROD BALL STUD NUT TORQUE WILL BE CHECKED ON ALL INVOLVED VEHICLES.
A POTENTIAL INTERFERENCE BETWEEN THE TRANSMISSION SHIFT CABLE AND THE PRNDL BELLCRANK CLIP CAN RESULT IN DISENGAGEMENT OF THE TRANSMISSION CABLE FROM THE STEERING COLUMN BALL STUD. THIS COULD ALLOW THE TRANSMISSION TO BE IN A GEAR OTHER THAN THAT DISPLAYED ON THE PRNDL INDICATOR. THIS CONDITION COULD CAUSE A VEHICLE CRASH WITHOUT PRIOR WARNING. CORRECTION: A NEWLY DESIGNED BELLCRANK CLIP WILL BE INSTALLED ON AFFECTED VEHICLES.
A LOOSE ELECTRICAL CONTACT ON THE ROTARY STOP LAMP SWITCH CAN OVERHEAT AND MELT THE SURROUNDING PLASTIC CAUSING THE CONTACT TO STICK OPEN. THIS WOULD RESULT IN INOPERATIVE BRAKE LIGHTS WHEN THE BRAKE PEDAL IS DEPRESSED. ALSO, THE TRANSMISSION CLUTCH CONTROL AND CRUISE CONTROL WOULD REMAIN ENGAGED RESULTING IN A "CRUISE RESUME" CONDITION WHEN THE BRAKE PEDAL IS RELEASED AT SPEEDS ABOVE 12 MPH WITH THE CRUISE CONTROL SWITCH "ON" AND TCC ENGAGEMENT UNTIL NORMAL DROP OUT SPEED. UNEXPECTED "CRUISE RESUME" OR INOPERATIVE BRAKE LIGHTS COULD RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING. CORRECTION: ROTARY STOP LAMP SWITCH WILL BE REPLACED ON AFFECTED VEHICLES.