Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1989 Mercury Sable, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
THE ARC WELDS ON THE SWAY BAR BRACKET, WHERE IT ATTACHES TO THE STRUT RESERVE TUBE, DID NOT FUSE PROPERLY. Remedy: MONROE DEALERS WILL REPLACE THE STRUT FREE OF CHARGE.
THE POWER SEAT SWITCH WIRING IS ROUTED OVER RATHER THAN UNDER THE FRONT SEAT SUPPORT BRACE, ALLOWING DAMAGE BY SEAT CUSHION SPRING ENDS WHEN SEAT IS OCCUPIED. Remedy: REVISE ROUTING OF POWER SEAT WIRING TO PREVENT DAMAGE FROM SEAT CUSHION SPRING CONTACT.
CHILDREN CAN ACCIDENTALLY LOCK THEMSELVES IN THE FOOTWELL AREA OF THE REAR-FACING THIRD SEAT, OR IN THE STORAGE COMPARTMENT IN STATION WAGONS NOT EQUIPPED WITH AN OPTIONAL THIRD SEAT. ONCE THE COMPARTMENT IS CLOSED IT CANNOT BE OPENED FROM THE INSIDE. Remedy: REPLACE THE SELF-LATCHING ASSEMBLY CURRENTLY USED IN THE REAR STORAGE COMPARTMENT WITH A LATCH ASSEMBLY THAT CAN ONLY BE CLOSED WITH A KEY.
THE RIGID MOUNTED SAFETY BELT BUCKLES ARE DEFECTIVE IN THREE WAYS. FIRST, A FASTENED SAFETY BELT BUCKLE WILL NOT UNLATCH WHEN THE RELEASE BUTTON IS DEPRESSED. THIS RESULTS FROM INTERFERENCE BETWEEN THE BUCKLE EJECTOR FINGER AND THE BUCKLE TONGUE WINDOW. THE SECOND DEFECT IS THE SAFETY BELT BUCKLE MAY NOT LATCH. THE THIRD POSSIBLE DEFECT IS THAT THE TONGUE MAY BE RETAINED BY THE BUCKLE, BUT IT MAY NOT BE LATCHED SUFFICIENTLY TO PROVIDE OCCUPANT PROTECTION. Remedy: FORD WILL REPLACE THE RIGID MOUNTED SAFETY BELT BUCKLES WITH END RELEASE SAFETY BELT BUCKLES DESIGNED TO PREVENT LATCH PROBLEMS.
VEHICLE DESCRIPTION: PASSENGER VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN CONNECTICUT, DELAWARE, DISTRICT OF COLUMBIA, ILLINOIS, INDIANA, IOWA, KANSAS, KENTUCKY, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEBRASKA, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, VIRGINIA, WEST VIRGNIA, AND WISCONSIN. THE REAR LOWER SUBFRAME MOUNT PLATE NUT CAN EXPERIENCE STRESS CORROSION CRACKING IF SUBJECTED TO LONG TERM EXPOSURE TO ROAD SALTS. THIS CAN RESULT IN FRACTURE AND LOSS OF THE STRUCTURAL INTEGRITY OF THE SUBFRAME MOUNT ATTACHMENT. DETACHMENT OF THE BODY MOUNTS AT THE REAR CORNERS OF THE SUBFRAME, WHICH SUPPORTS THE ENGINE AND TRANSMISSION, ALLOWS THE REAR CORNERS OF THE SUBFRAME TO DROP. Remedy: DEALERS WILL INSTALL SUBFRAME REAR MOUNT BOLTS, REINFORCEMENT PLATES, AND PLATE NUTS.
THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. FORD IS INITIATING AN OWNER NOTIFICATION PROGRAM THAT WILL PROVIDE AN EXTENDED WARRANTY, 12 YEARS AND UNLIMITED MILEAGE, FOR ALL SEAT BELT BUCKLES WITH FUNCTIONAL CONCERNS. Remedy: DEALERS WILL REPLACE THE SEAT BELT BUCKLE ASSEMBLY, FOR 12 YEARS AND UNLIMITED MILEAGE.
FRONT DISC BRAKE ROTORS OF THE SUBJECT VEHICLES MAY EXPERIENCE SEVERE CORROSION IF OPERATED IN AREAS WHERE CALCIUM CHLORIDE AND SODIUM CHLORIDE ARE USED EXTENSIVELY. Remedy: REPLACE FRONT BRAKE ROTORS WITH FULL CAST FRONT BRAKE ROTORS.
FRONT SIDE MARKER LAMPS WERE UNINTENTIONALLY EQUIPPED WITH CLEAR BULBS, INSTEAD OF AMBER COLORED BULBS AS SPECIFIED IN FMVSS 108. Remedy: REPLACE CLEAR BULBS WITH AMBER COLORED BULBS.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles located in Manitoba, Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island, and Newfoundland & Labrador, the lower sub frame mount plate nut may corrode and fail due to exposure to road salt. This could result in loss of structural integrity of the subframe mount attachment. Detachment of the body mounts at the rear corners of the sub frame which supports the engine and transmission, allows the rear corners of the sub frame to drop. Should both rear corners drop, steering control would be adversely affected. Correction: Dealers will install subframe rear mount bolts, reinforcement plate and plate nuts.
On certain vehicles with 3.0 Litre and 3.8 Litre engines, the body mounts on the rear corners of the subframe which supports the engine and transmission may become detached due to corrosion of the rear lower mount retaining plates, allowing the rear corners of the subframe to drop. Should this occur, steering could become very difficult, thereby adversely affecting vehicle control. Correction: modified lower body mounts and attaching bolts will be installed on affected vehicles.
SEAT BELT BUCKLES ON THESE VEHICLES MAY EXPERIENCE CONDITIONS WHEREBY THE BUCKLE MAY NOT UNLATCH WHEN THE RELEASE BUTTON IS DEPRESSED OR MAY NOT LATCH, OR IN SOME CASES, MAY LATCH PARTIALLY BUT NOT SUFFICIENTLY TO PROVIDE OCCUPANT RESTRAINT IN THE EVENT OF A COLLISION. NOTE: ONLY END-RELEASE BUCKLES ON "RIGID" MOUNTINGS ARE SUSCEPTIBLE TO THIS MALFUNCTION. CORRECTION: FACTORY INSTALLED END-RELEASE SEAT BELT BUCKLES WILL BE REPLACED WITH REDESIGNED BUCKLES.
NOTE: VEHICLES EQUIPPED WITH 3.8 LITRE ENGINES. THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S 1105 - EVAPORATIVE EMISSIONS. CORRECTION: PURGE VALVE AND HOSE ASSEMBLY WILL BE REPLACED ON AFFECTED VEHICLES.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Note: Station wagon vehicles only. Young children left unattended in the vehicle could lock themselves in the footwell area of the rear-facing third seat (or the underfloor storage compartment in station wagons not equipped with the optional third seat). Once the compartment is closed, it cannot be opened from the inside, and there is the danger of air deprivation, excessive body heat and panic response to a child who may have closed himself or herself in the compartment. Correction: A modified latch will be installed which does not have a self-latching feature and allows the compartment cover to be pushed open from the inside.
IMPROPER ROUTING OF THE POWER SEAT SWITCH WIRING WILL ALLOW THE WIRING TO BE CONTACTED AND POTENTIALLY DAMAGED BY THE SEAT CUSHION SPRING ENDS WHEN THE SEAT IS OCCUPIED. THIS COULD ABRADE OR PUNCTURE THE WIRING AND CAUSE AN ELECTRICAL SHORT WHICH COULD IN TURN RESULT IN A FIRE. CORRECTION: POWER SEAT SWITCH WIRING WILL BE REROUTED AND DAMAGED WIRING WILL BE REPLACED.
THIS RECALL SUPERSEDES RECALL 90-27 FOR VEHICLES IN THE MARITIMES. THE THROTTLE MAY STICK IN AN OPEN POSITION DUE TO LINKAGE BINDING CAUSED BY CORROSION. THIS WOULD CAUSE THE ENGINE TO RUN AT HIGHER THAN IDLE SPEED WHEN THE THROTTLE IS RELEASED AND COULD ADVERSELY AFFECT DRIVER CONTROL RESULTING IN A POSSIBLE CRASH. CORRECTION: A STAINLESS STEEL SLEEVE, WHICH WILL BE PLACED OVER THE HUB ON THE THROTTLE BODY ASSEMBLY, AND A SECONDARY THROTTLE LEVER TO FIT THE SLEEVE, ALONG WITH OTHER MOUNTING PARTS, WILL BE INSTALLED ON AFFECTED VEHICLES.
THE COMPOSITE CONSTRUCTION FRONT BRAKE ROTORS ON THESE VEHICLES MAY CORRODE, WEAKEN AND FRACTURE, RESULTING IN A REDUCTION OF BRAKING PERFORMANCE. SUCH A FRACTURE WOULD RESULT IN LOSS OF BRAKING AT THE CORRESPONDING FRONT WHEEL WHICH COULD IN TURN RESULT IN INCREASED STOPPING DISTANCE AND A POSSIBLE CRASH. CORRECTION: FRONT BRAKE ROTORS WILL BE REPLACED.
RANGER/BRONCO II - 2.9 LITRE ENGINES TAURUS/SABLE - 3.0 LITRE ENGINES NOTE: VEHICLES LOCATED IN NEWFOUNDLAND, NOVA SCOTIA, NEW BRUNSWICK AND PRINCE EDWARD ISLAND. THE THROTTLE MAY STICK IN AN OPEN POSITION DUE TO LINKAGE BINDING CAUSED BY CORROSION. THIS WOULD CAUSE THE ENGINE TO RUN AT HIGHER THAN IDLE SPEED WHEN THE THROTTLE IS RELEASED AND COULD ADVERSELY AFFECT DRIVER CONTROL RESULTING IN A POSSIBLE CRASH. CORRECTION: ON VEHICLES WITH 2.9 LITRE ENGINES, DEALERS WILL CLEAN, MODIFY AND LUBRICATE THE HUB PIN AND LEVER BUSHINGS WITH A MARINE-TYPE ANTI-SEIZE GREASE. ADDITIONALLY, ON VEHICLES WITH 3.0 LITRE ENGINES, THE HUB PIN LEVER ASSEMBLY WILL BE REPLACED. NOTE: THIS RECALL HAS BEEN SUPERSEDED BY RECALL NO. 91021.
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 108 - LIGHTING. VEHICLES WERE EQUIPPED WITH CLEAR FRONT SIDE MARKER LAMPS AND CLEAR BULBS INSTEAD OF AMBER BULBS. CORRECTION: CLEAR FRONT SIDE MARKER LAMP BULBS WILL BE REPLACED WITH AMBER BULBS.