Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1989 Volkswagen FOX, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
IN THE EVENT OF A COOLING SYSTEM COMPONENT FAILURE WHILE THE VEHICLE IS DRIVEN, THE COOLANT CAN OVERHEAT CAUSING THE COOLING SYSTEM PRESSURE TO RISE TO A LEVEL WHERE A LEAK IN THE HEAT EXCHANGER CAN OCCUR. Remedy: DEALERS WILL INSTALL A BYPASS VALVE KIT WHICH IS DESIGNED TO ROUTE EXCESSIVELY HOT COOLANT TO THE ENGINE WITHOUT FLOWING THROUGH THE HEAT EXCHANGER. DEALERS WILL ALSO INSTALL A PLASTIC COVER UNDERNEATH THE DASHBOARD ON THE PASSENGER SIDE TO ENSURE THAT THE PASSENGER IS NOT EXPOSED TO HOT COOLANT IN THE EVENT OF A LEAK.
STEERING WHEEL/SHAFT DESIGNED TO USE SURFACE FRICTION MAY LOOSE THIS FRICTION IF GREASE OR OIL IS PRESENT ON THE CONESHAPED SURFACE OF THE STEERING SHAFT. Remedy: REMOVE THE STEERING WHEEL OF VEHICLES AND CLEAN FRICTION SURFACE AND INSTALL A SPRING RETAINER, REPLACE THE STEERING WHEEL NUT WITH A SELF LOCKING NUT.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
DEFECT: IF THE VEHICLE IS OPERATED AFTER A COOLING SYSTEM COMPONENT HAS FAILED, THE COOLANT COULD OVERHEAT CAUSING THE COOLING SYSTEM'S PRESSURE TO RISE TO A LEVEL WHERE A LEAK IN THE HEAT EXCHANGER COULD OCCUR. THIS COULD ALLOW HOT COOLANT TO ESCAPE AND CAUSE INJURY TO THE FEET OF A PASSENGER OR STEAM UP THE INTERIOR OF THE VEHICLE. CORRECTION: A BYPASS VALVE KIT AND A PLASTIC COVER UNDERNEATH THE DASHBOARD ON THE PASSENGER SIDE WILL BE INSTALLED.
THE SECONDARY HOOD LATCH MECHANISM MAY CORRODE AND SEIZE DUE TO IMPROPER LUBRICATION. IF THE SECONDARY HOOD LATCH WAS NOT PROPERLY ENGAGED AND THE PRIMARY HOOD LATCH WAS ALSO NOT ENGAGED, THE HOOD COULD FLY OPEN WHILE THE VEHICLE WAS IN MOTION RESULTING IN IMPAIRED DRIVER VISION AND A POSSIBLE CRASH. CORRECTION: OWNERS AND DEALERS WILL BE ADVISED BY MAIL OF CORRECT MAINTENANCE PROCEDURES FOR THE HOOD LATCH MECHANISM.
THE STEERING WHEEL ON THESE VEHICLES MAY LOOSEN ON THE STEERING SHAFT. WHEN A STEERING WHEEL IS REMOVED AFTER ASSEMBLY AND REINSTALLED, GREASE OR OIL MAY HAVE BEEN INADVERTENTLY APPLIED TO THE CONE-SHAPED FRICTION SURFACE OF THE STEERING SHAFT. GREASE OF OIL ON THIS SURFACE MAY BREAK THE FRICTION LOCK IF AFTER REWORK THE TORQUE APPLIED TO THE NUT IS LOWER THAN SPECIFIED. A LOOSE STEERING WHEEL COULD RESULT IN LOSS OF VEHICLE CONTROL AND A POSSIBLE CRASH. CORRECTION: FRICTION SURFACES WILL BE CLEANED, A SPRING RETAINER WILL BE INSTALLED AND THE STEERING WHEEL NUT WILL BE REPLACED WITH A SELF LOCKING NUT. VIN RANGE: 9BW*A030*HP000001 TO KP009988
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain