Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1990 Eagle Premier, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
REAR BRAKE TUBE ROUTING IS CONTACTED BY FUEL TANK HEAT SHIELD WHEN SUSPENSION IS IN FULL JOUNCE POSITION. THIS DAMAGES THE BRAKE FLUID TUBE, CAUSING A LEAK. Remedy: MODIFY HEAT SHIELD TO ELIMINATE POTENTIAL FOR SHIELD CONTACTING BRAKE TUBE.
THE END CAP CONNECTING THE HEAT EXCHANGER'S CORE TO THE ENGINE COOLING SYSTEM COULD RUPTURE AND ALLOW HOT COOLANT TO ESCAPE INTO THE PASSENGER COMPARTMENT. Remedy: A COOLANT TEMPERATURE CONTROLLED HEATER CORE FLUID BYPASS VALVE WILL BE INSTALLED.
ROUTING OF THE FRONT BRAKE HOSE MAY CAUSE EXCESSIVE HOSE FLEXING RESULTING IN PREMATURE FATIGUE CRACKING OF THE OUTER HOSE COVER. Remedy: REPLACE FRONT BRAKE HOSES WITH HOSES REDESIGNED TO PROVIDE A MODIFIED ROUTING CONFIGURATION.
THE AUTOMATIC SHOULDER BELT SYSTEMS CAN MALFUNCTION AND BECOME INOPERATIVE. Remedy: DEALERS WILL REPLACE THE SYSTEM TRACK AND DRIVE ASSEMBLY ON AUTOMATIC SHOULDER BELT SYSTEMS WHICH ARE CURRENTLY INOPERATIVE AND THOSE SYSTEMS WHEN THEY BECOME INOPERATIVE IN THE FUTURE.
VEHICLE DESCRIPTION: PASSENGER AND MULTI-PURPOSE VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, ILLINOIS, INDIANA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, OR WISCONSIN, AND THE DISTRICT OF COLUMBIA. THE FRONT DISC BRAKE ROTORS CAN EXPERIENCE SEVERE CORROSION IF OPERATED FOR AN EXTENSIVE PERIOD IN THE "SALT BELT." IF THE ROTORS ARE NOT REPLACED, THE CORROSION CAN EVENTUALLY COMPROMISE THE STRUCTURAL INTEGRITY OF THE STAMPED STEEL CENTER HUB SECTION OF THE ROTOR. Remedy: DEALERS WILL REPLACE THESE ROTORS WITH ROTORS THAT ARE COATED WITH A CORROSION PROTECTION.
LOWER INTERMEDIATE STEERING SHAFT MAY SEPARATE AT THE RUBBER ISOLATED COUPLING OF THE SHAFT. Remedy: REPLACE INTERMEDIATE STEERING SHAFT WITH A SHAFT CONTAINING A RESTRAINED COUPLING.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
NOTE: VEHICLES ORIGINALLY RETAILED IN ONTARIO, QUEBEC AND THE MARITIME PROVINCES. THE COMPOSITE FRONT DISC BRAKE ROTORS ON THESE VEHICLES MAY FAIL DUE TO CORROSION. THE CAST IRON WEAR SURFACE MAY SEPARATE FROM THE HUB REDUCING THE BRAKING EFFECTIVENESS OF THE VEHICLE. CORRECTION: FRONT COMPOSITE ROTORS WILL BE REPLACED WITH ONES HAVING A REVISED CORROSION PROTECTION COATING.
NOTE: VEHICLES EQUIPPED WITH 3.0 LITRE ENGINES. THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S 1103 - EXHAUST EMISSIONS. CATALYSTS AND OXYGEN SENSORS MAY BE DEFECTIVE. CORRECTION: CATALYTIC CONVERTER AND OXYGEN SENSOR WILL BE REPLACED.
THE HEATER CORE END CAP MAY FAIL (SPLIT/TEAR) ALLOWING THE DISCHARGE OF COOLING SYSTEM STEAM INTO THE PASSENGER COMPARTMENT WHICH MAY CAUSE REDUCED DRIVER VISIBILITY. CORRECTION: A COOLANT TEMPERATURE-CONTROLLED FLUID BYPASS VALVE WILL BE INSTALLED ON AFFECTED VEHICLES. THIS VALVE WILL ISOLATE THE HEATER CORE DURING PERIODS OF HIGH COOLANT TEMPERATURE.
NOTE: JEEP VEHICLES WITH 4.0 LITRE ENGINES, RENAULT VEHICLES WITH 2.0 LITRE ENGINES AND EAGLE PREMIER VEHICLES WITH 2.5 AND 3 LITRE ENGINES. THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. FAULTY OXYGEN SENSOR COULD LEAD TO POOR FUEL/AIR CONTROL AND REDUCED CATALYST EFFICIENCY WHICH MAY INCREASE TAILPIPE EMISSIONS. CORRECTION: OXYGEN SENSOR WILL BE REPLACED WITH ONE OF AN IMPROVED DESIGN.
THE FUEL TANK HEAT SHIELD MAY CONTACT THE REAR BRAKE TUBE WHEN THE SUSPENSION IS IN THE FULL JOUNCE POSITION. CONTINUED CONTACT COULD CAUSE THE BRAKE TUBE TO WEAR THROUGH CAUSING LOSS OF BRAKE FLUID AND A PARTIAL BRAKE SYSTEM LOSS WHICH WOULD RESULT IN INCREASED STOPPING DISTANCES. CORRECTION: HEAT SHIELD WILL BE MODIFIED TO ELIMINATE POTENTIAL FOR HEAT SHIELD TO REAR BRAKE TUBE CONTACT. ALL BRAKE TUBES DAMAGED DUE TO CONTACT WITH THE HEAT SHIELD WILL BE REPLACED.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
NOTE: VEHICLES LOCATED IN ONTARIO, QUEBEC, NEW BRUNSWICK, NOVA SCOTIA, PRINCE EDWARD ISLAND AND NEWFOUNDLAND. THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 108 - LIGHTING DUE TO CORROSION FAILURE OF THE DAYTIME RUNNING LIGHT MODULE. CORRECTION: DRL MODULE WILL BE REPLACED WITH ONE HAVING ADDITIONAL POTTING MATERIAL THAT COVERS ALL PREVIOUSLY EXPOSED COMPONENTS.
EXCESSIVE FLEXING AT THE FRONT BRAKE HOSE END FITTINGS COULD RESULT IN PREMATURE FATIGUE CRACKING OF THE OUTER RUBBER HOSE COVER. THIS COULD EVENTUALLY LEAD TO HOSE FAILURE AND A PARTIAL BRAKE SYSTEM FAILURE DUE TO LOSS OF FLUID. CORRECTION: FRONT BRAKE HOSES WILL BE REPLACED WITH REDESIGNED HOSES THAT PROVIDE A MODIFIED ROUTING CONFIGURATION:
THE STEERING COLUMN LOWER INTERMEDIATE SHAFT MAY SEPARATE AT THE RUBBER ISOLATED COUPLING. THIS COULD RESULT IN LOSS OF STEERING CONTROL AND A VEHICLE CRASH WITHOUT PRIOR WARNING. CORRECTION: INTERMEDIATE STEERING SHAFT WILL BE REPLACED WITH ONE CONTAINING A RESTRAINED COUPLING.