Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1990 Ford Crown Victoria, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
THE REAR BRAKE LINES HAVE INADEQUATE CLEARANCE BETWEEN THE BRAKE TUBE AND THE VEHICLE UNDERBODY IN THE AREA OF THE LEFT REAR WHEEL OPENING. Remedy: REPAIR ANY BRAKE LINES THAT HAVE AN INDICATION OF CONTACT OR HAVE THE POTENTIAL FOR CONTACT WITH THE BODY OF THE VEHICLE. RELOCATE LINES, IF NECESSARY.
VEHICLE DESCRIPTION: CERTAIN 1996-1999 FORD CROWN VICTORIA POLICE, FLEET, NATURAL GAS, AND 1996-1999 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT WERE PRODUCED WITH A LOWER CONTROL ARM BALL JOINT CONTAINING A ONE PIECE BEARING; AND 1990-1996 FORD CROWN VICTORIA POLICE, FLEET, AND NGV VEHICLES AND 1990-1996 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT HAVE BEEN SERVICED WITH EITHER A BALL JOINT CONTAINING THE ONE-PIECE BEARING OR A FRONT LOWER CONTROL ARM CONTAINING A BALL JOINT WITH A ONE-PIECE BEARING. THE ONE-PIECE BEARING WITHIN THE LOWER CONTROL ARM BALL JOINT CAN WEAKEN SLOWLY DURING USE AND EVENTUALLY CRACK. THIS COULD RESULT IN SEPARATION OF THE BALL AND CAP OF THE JOINT, ALLOWING THE CONTROL ARM TO DROP TO THE GROUND. Remedy: DEALERS WILL REPLACE THE LOWER CONTROL ARM BALL JOINTS (2).
THREADED INFLATOR COMPONENTS MAY HAVE BEEN DAMAGED DURING ASSEMBLY WHICH MAY ALLOW COMPONENTS TO SEPARATE WHEN INFLATOR RECEIVES A SIGNAL TO DEPLOY THE AIR BAG. Remedy: REPLACE AIR BAG MODULES CONTAINING POTENTIALLY DEFECTIVE INFLATORS.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Note: 1996-99 crown victoria police, fleet and ngv and lincoln town car limousine equipped with a lower control arm ball joint containing a one piece bearing and 1990-96 crown victoria police, fleet and ngv and lincoln town car limousine that were serviced with either a ball joint containing an one piece bearing or a front lower control arm with a one piece bearing. High bearing loads can lead to thinning and eventual cracking of the lower control arm ball joint. This can result in separation of the ball and cap of the joint. Should this occur, the control arm to which the cap is mounted will drop to the ground. Should this occur while the vehicle is moving, reduced steering control could result in a collision. Correction: Lower control arm ball joints will be replaced.
ON VEHICLES EQUIPPED WITH POLICE OPTION AND 5.8 LITRE ENGINES, THE REAR BRAKE TUBE COULD ABRADE AGAINST THE VEHICLE'S UNDERBODY. THIS COULD RESULT IN A FLUID LEAK AND LOSS OF REAR BRAKES CAUSING A REDUCTION OF BRAKE PERFORMANCE AND INCREASED STOPPING DISTANCES. CORRECTION: A SERVICE REPAIR WILL BE PERFORMED ON ANY BRAKE LINES THAT HAVE AN INDICATION OF CONTACT OR HAVE THE POTENTIAL FOR CONTACT WITH THE UNDERBODY.
ON VEHICLES EQUIPPED WITH A DRIVER SIDE SUPPLEMENTAL AIR BAG, THE CENTRE POST THREADS OF THE AIR BAG MODULE MAY HAVE BEEN DAMAGED DURING ASSEMBLY. IN A DEPLOYMENT LEVEL COLLISION, THE CENTRE POST HOUSING MAY SEPARATE FROM THE AIR BAG ADAPTER CAUSING THE AIR BAG NOT TO INFLATE PROPERLY. IN ADDITION, HOT COMBUSTION GASES WOULD FLOW DIRECTLY THROUGH THE AIR BAG RATHER THAN THROUGH THE NORMAL FILTERING AND COOLING DEVICES, PRESENTING THE POSSIBILITY OF BURN INJURY TO VEHICLE OCCUPANTS. CORRECTION: AIR BAG MODULES WILL BE INSPECTED AND REPLACED IF NECESSARY.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain