Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1990 Jeep Wagoneer, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
THERE MAY BE HYDRAULIC FLUID CONTAMINATION FROM CONDENSATION FORMATION THAT CAN PLUG THE ABS BRAKE BOOSTER PUMP FILTER; STRESS CORROSION OF THE MASTER CYLINDER SNAP RING HAS BEEN TRACED TO CHLORINE LEAKING FROM THE LOW PRESSURE HYDRAULIC HOSE WHICH MAY CAUSE IT TO BREAK; FRONT BRAKE HOSE TO TIRE INTERFERENCE WHICH MAY CAUSE FAILURE OF THE BRAKE HOSE. Remedy: REPLACE ABS LOW PRESSURE HOSE; REBUILD MASTER BRAKE CYLINDER; INSPECT, SERVICE INTERFERENCE PROBLEMS, AND REPLACE FRONT BRAKE HOSE AS NECESSARY.
IMPROPER INSERTION/CRIMPING OF THE HOSE-TO-END FITTINGS OF THE HIGH PRESSURE HOSE ON THE ANTI-LOCK BRAKE SYSTEM CAN CAUSE DETACHMENT OF THE HOSE FROM THE ABS SYSTEM, AND DISCHARGE OF HYDRAULIC FLUID. Remedy: REPLACE THE ABS HIGH PRESSURE HOSE.
VEHICLE DESCRIPTION: VEHICLES EQUIPPED WITH ANTILOCK BRAKE SYSTEM (ABS). THE ANTILOCK BRAKE SYSTEM (ABS) HYDRAULIC CONTROL UNIT CAN EXPERIENCE EXCESSIVE BRAKE ACTUATOR PISTON SEAL WEAR WHICH COULD CAUSE PUMP-MOTOR DETERIORATION. Remedy: DEALERS WILL TEST THE VEHICLE'S ABS AND REPAIR AS NECESSARY. THE WARRANTY ON ALL ABS COMPONENTS WILL BE EXTENDED TO 10 YEARS OR 100,000 MILES (EXCEPT FOR THE BRAKE ACTUATOR PISTON ASSEMBLY AND THE PUMP-MOTOR ASSEMBLY WHICH WILL HAVE A LIFETIME COVERAGE). OWNERS WILL BE REIMBURSED FOR PREVIOUS ABS COMPONENT REPAIR COSTS.
VEHICLE DESCRIPTION: PASSENGER AND MULTI-PURPOSE VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, ILLINOIS, INDIANA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, OR WISCONSIN, AND THE DISTRICT OF COLUMBIA. THE FRONT DISC BRAKE ROTORS CAN EXPERIENCE SEVERE CORROSION IF OPERATED FOR AN EXTENSIVE PERIOD IN THE "SALT BELT." IF THE ROTORS ARE NOT REPLACED, THE CORROSION CAN EVENTUALLY COMPROMISE THE STRUCTURAL INTEGRITY OF THE STAMPED STEEL CENTER HUB SECTION OF THE ROTOR. Remedy: DEALERS WILL REPLACE THESE ROTORS WITH ROTORS THAT ARE COATED WITH A CORROSION PROTECTION.
MALFUNCTION OF FUEL INJECTION SYSTEM THROTTLE POSTITION SENSOR COULD CAUSE INTERMITTENT HIGH ENGINE IDLE SPEED IMMEDIATELY AFTER STARTING ENGINE. Remedy: REPLACE THROTTLE POSITION SENSORS WITH SENSORS THAT WOULD SEND CORRECT SIGNALS TO THE FUEL INJECTION SYSTEM.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Vehicles with ABS brakes may experience premature actuator piston seal wear in the ABS hydraulic control unit and/or actuator pump motor deterioration. If this occurs, the abs function may be lost and reduced power assist may be experienced during vehicle braking. Correction: Vehicles with ABS malfunction will be repaired as necessary. Warranty on all abs components will be extended to 10 years or 160,000 km (except for the brake actuator piston assembly and the pump-motor assembly which will have lifetime coverage).
NOTE: JEEP VEHICLES WITH 4.0 LITRE ENGINES, RENAULT VEHICLES WITH 2.0 LITRE ENGINES AND EAGLE PREMIER VEHICLES WITH 2.5 AND 3 LITRE ENGINES. THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. FAULTY OXYGEN SENSOR COULD LEAD TO POOR FUEL/AIR CONTROL AND REDUCED CATALYST EFFICIENCY WHICH MAY INCREASE TAILPIPE EMISSIONS. CORRECTION: OXYGEN SENSOR WILL BE REPLACED WITH ONE OF AN IMPROVED DESIGN.
ON VEHICLES WITH ANTI-LOCK BRAKES (ABS), IMPROPER INSERTION/CRIMPING OF THE ABS HIGH PRESSURE HOSE AND FITTINGS COULD RESULT IN HYDRAULIC FLUID LEAKAGE. THIS IN TURN COULD RESULT IN A LOSS OF ASSIST FOR THE BRAKE SYSTEM AS WELL AS A POTENTIAL FOR AN ENGINE COMPARTMENT FIRE. CORRECTION: THE ABS HIGH PRESSURE HOSE WILL BE REPLACED WITH A PROPERLY MANUFACTURED HOSE.
ON VEHICLES EQUIPPED WITH THE ANTI-LOCK BRAKE SYSTEM (ABS), MATERIALS USED IN THE MANUFACTURE AND INSTALLATION OF THE ABS LOW PRESSURE HOSE MAY CONTAMINATE THE BRAKE FLUID IN TWO DIFFERENT WAYS AND IMPAIR THE PROPER FUNCTIONING OF THE ABS SYSTEM. ONE FORM OF CONTAMINATION COULD RESULT IN PLUGGING OF THE ABS BOOSTER PUMP FILTER RESULTING IN LOSS OF ABS FUNCTION. THE OTHER COULD CAUSE STRESS CORROSION FAILURE OF A MASTER CYLINDER SNAP RING RESULTING IN BRAKE DRAG. CORRECTION: ABS LOW PRESSURE HOSE WILL BE REPLACED WITH ONE HAVING A DIFFERENT MATERIAL AND THE MASTER CYLINDER WILL BE REBUILT WITH A NEW PISTON ASSEMBLY CONTAINING A THICKER SNAP RING.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S 1103(2) EXHAUST EMISSIONS. - MISSING EMISSION MAINTENANCE TIMER FUSE. CORRECTION: FUSE WILL BE INSTALLED ON AFFECTED VEHICLES.