Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1991 Chevrolet Blazer, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT. Remedy: PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.
CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE. Remedy: HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES. Remedy: HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.
VEHICLE DESCRIPTION: CERTAIN 4-WHEEL DRIVE PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH ABS (ANTILOCK BRAKING SYSTEM) MANUFACTURED FROM SEPTEMBER 1989 THROUGH AUGUST 1996. UNDER CERTAIN DRIVING CONDITIONS THE SWITCH WHICH SIGNALS THE ABS SYSTEM WHETHER THE VEHICLE IS IN 2-WHEEL OR 4-WHEEL DRIVE CAN MALFUNCTION CAUSING INCREASED STOPPING DISTANCES DURING ABS STOPS WHILE IN THE TWO-WHEEL DRIVE MODE. Remedy: DEALERS WILL REPLACE OR REPAIR THE 4-WHEEL/2-WHEEL DRIVE SWITCH.
SEVERE CORROSION DUE TO ROAD SALT AT THE JOINT OF THE STAMPED STEEL CENTER SECTION AND THE CAST OUTER SECTION CAN CAUSE THE SECTIONS TO SEPARATE. Remedy: REPLACE THE FRONT BRAKE ROTORS WITH NEW ROTORS WITH A CORROSION PROTECTION COATING. HOWEVER, IF REPLACEMENT OF BRAKE LININGS ARE NECESSARY, IT WILL BE DONE AT OWNER'S EXPENSE SINCE BRAKE LININGS ARE NORMAL MAINTENANCE ITEMS.
VEHICLES HAVE BEEN SHIPPED WITH THE FUEL TANK SENDER SEAL OUT OF POSITION. Remedy: REPLACE SENDER SEALS.
THESE VEHICLES EXHIBIT A CONDITION IN WHICH A REAR SEAT BELT BUCKLE RELEASE BUTTON CAN STICK IN THE UNLATCHED (DOWN) POSITION UNDER CERTAIN CONDITIONS BECAUSE THE BUCKLE ASSEMBLY CAN MOVE INSIDE THE SEAT BELT COVER. IF THE COVER MOVES FAR ENOUGH, IT CAN CREATE AN INTERFERENCE CONDITION WITH THE LATCH RELEASE BUTTON. WHEN IT DOES, THE SEAT BELT BUCKLE CANNOT BE LATCHED. Remedy: DEALERS WILL REPLACE THE THREE REAR-SEAT BELT BUCKLES (ONE ASSEMBLY) WITH A NEW, REVISED DESIGN.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Certain four wheel drive vehicles may experience increased stopping distances during ABS stops while in the two-wheel drive mode. A switch can erroneously signal the ABS system that the vehicle is in four-wheel drive when the vehicle is actually in two wheel drive. Correction: Dealers will replace the switch on affected vehicles.
NOTE: 4-DOOR VEHICLES ONLY. THESE VEHICLES MAY EXHIBIT A CONDITION WHEREBY A REAR SEAT BELT BUCKLE RELEASE BUTTON CAN STICK IN THE UNLATCHED (DOWN) POSITION UNDER CERTAIN CONDITIONS. THE LATCH COVER CAN MOVE OUT OF POSITION RELATIVE TO THE LATCH MECHANISM AND BECOME PARTIALLY DISASSEMBLED. THIS CAN CREATE AN INTERFERENCE WITH THE LATCH RELEASE BUTTON AND WHEN IT DOES, THE SEAT BELT BUCKLE CANNOT BE LATCHED. CORRECTION: THE THREE REAR SEAT BELT BUCKLES WILL BE REPLACED.
NOTE: 4-DOOR VEHICLES. THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 301 - FUEL SYSTEM INTEGRITY. - FUEL TANK SENDER SEAL MAY BE OUT OF POSITION. CORRECTION: VEHICLES WILL BE INSPECTED AND DISPLACED FUEL TANK SENDER SEALS WILL BE REPLACED.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain