Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1993 Freightliner FL-70, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
THE BRAKE CHAMBER MOUNTING STUDS CAN LOOSEN OR PULL THROUGH DUE TO FATIGUE IN THE BRAKE CHAMBER HOUSING CAUSED BY FOUNDATION BRAKE CHATTER. Remedy: DEALERS WILL CHANGE THE BRAKE LINING MATERIALS, REPLACE THE WING BRACKET WITH A REINFORCED BRACKET AND INSTALL BRAKE CHAMBERS WITH REINFORCED CHAMBER HOUSING AND LARGER (1/2") MOUNTING STUDS.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCK. THE SHOULDER BOLT WHICH HOLDS THE GROTE TURN SIGNAL SWITCH CASE AND COMPONENTS TOGETHER CAN LOOSEN RESULTING IN THE TURN SIGNAL MALFUNCTIONING. Remedy: DEALERS WILL INSPECT THESE VEHICLES AND TIGHTEN ANY LOOSE BOLTS AND IN THE TURN SIGNAL SWITCH WITHIN 2 YEARS FROM THE DATE OF THE RECALL NOTIFICATION LETTER. THE SHOULDER BOLT WILL BE REMOVED, CLEANED, AND REINSTALLED WITH LOCTITE. OWNERS CAN ALSO REQUEST LOCTITE AND REPAIR INSTRUCTIONS SO THEY CAN FIX THE VEHICLES THEMSELVES.
THE PARKING BRAKE LEVER MAY NOT TRAVEL FAR ENOUGH OVER CENTER TO ASSURE THAT IT REMAINS IN THE PROPER POSITION ALLOWING THE VEHICLE TO ROLL AWAY WHILE PARKED. Remedy: DEALERS WILL REMOVE AND REPLACE THE PARKING BRAKE LEVER WITH A LEVER THAT REQUIRES A 25 LB. EFFORT TO RELEASE.
AS THE BRAKE PADS WEAR, THE BRAKE CALIPER TRAVEL MAY BE LIMITED BY INTERFERENCE WITH THE MAIN SUPPORT MEMBER (Z-BAR SPRING) OF THE SUSPENSION. Remedy: BENDIX WILL SUPPLY REPLACEMENT BRAKE CALIPERS FOR AFFECTED VEHICLES.
AIR SYSTEM BLOCKAGE IN THE AIR DRYER OCCURS DEGRADING THE MOISTURE REMOVING CAPABILITIES OF THE DRYER WHEN THE VEHICLE IS OPERATED IN A COLD ENVIRONMENT AND MOISTURE ACCUMULATES AND FREEZES IN THE AIR DRYER OR IN THE LINE BETWEEN THE DRYER AND THE AIR SYSTEM RESERVOIR. THE AIR DRYER CAN BECOME OVER PRESSURIZED CAUSING THE AIR DRYER CARTRIDGE TO SEPARATE FROM THE MOUNTING BASE. Remedy: DEALERS WILL EQUIP AIR SYSTEMS WITH A PRESSURE RELIEF VALVE TO BE LOCATED BETWEEN THE COMPRESSOR AND THE AIR DRYER. THIS PRESSURE RELIEF VALVE IS INTENDED TO VENT IF EXCESSIVE PRESSURE DEVELOPS IN THE AIR DRYER.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
THESE VEHICLES ARE EQUIPPED WITH 12" AND 16" FRONT BRAKE CHAMBERS MOUNTED ON ROCKWELL FOUNDATION BRAKES. THE BRAKE CHAMBER MOUNTING STUDS MAY LOOSEN OR PULL THROUGH DUE TO FATIGUE IN THE BRAKE CHAMBER HOUSING CAUSED BY FOUNDATION BRAKE CHATTER. CORRECTION: BRAKE LINING MATERIALS WILL BE CHANGED. THE WING BRACKET WILL BE REPLACED WITH A REINFORCED BRACKET AND BRAKE CHAMBERS WITH REINFORCED CHAMBER HOUSINGS AND LARGER MOUNTING STUDS WILL BE INSTALLED.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain