Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1993 Jeep Grand Cherokee, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
Chrysler Group LLC (Chrysler) is recalling certain model year 1993-1998 Jeep Grand Cherokee and 2002-2007 Jeep Liberty vehicles. The fuel tanks in these vehicles are at risk of failure and leakage in certain rear impacts. Remedy: Owners may take their vehicles to dealers and the dealers will perform a free inspection of the rear structure. On vehicles in the recall that are not equipped with a tow hitch, Chrysler will install a Chrysler designed tow hitch free of charge, provided the condition of the vehicle can support proper installation. On vehicles in the recall that are equipped with an aftermarket tow hitch, Chrysler will assess whether the hitch and surrounding areas show evidence of sharp edges or other puncture risks. If so, Chrysler will replace the tow hitch with a Chrysler designed tow hitch free of charge, provided the condition of the vehicle can support proper installation. On vehicles already equipped with a Chrysler designed tow hitch, Chrysler will inspect the area around the tow hitch installation, and if any installation issues are identified, they will be repaired free of charge. The recall began on August 1, 2014. Owners may contact Chrysler at 1-800-247-9753. Chrysler's recall campaign numbers are N45 (for the Grand Cherokee vehicles) and N46 (for the Liberty vehicles).
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT. Remedy: PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.
GREASE APPLIED TO THE LIFTGATE LATCH RUBBER BUMPERS TO EASE COMPONENT ASSEMBLY CAUSED THE BUMPER TO SWELL, INTERFERING WITH THE MOVEMENT OF THE LIFTGATE LATCH PAWL. THIS PREVENTS THE LIFTGATE LATCHING WHEN CLOSED AND DIFFICULT TO OPEN WHEN LATCHED. Remedy: REPLACE THE LIFTGATE ASSEMBLY ON AFFECTED VEHICLES.
THE ECCENTRIC CAM ADJUSTER BOLTS IN BOTH FRONT LOWER SUSPENSION ARM-TO-FRONT AXLE BRACKET ATTACHMENTS MAY FAIL DUE TO ASSEMBLY MISALIGNMENT. Remedy: REPLACE THE FRONT SUSPENSION CAM BOLTS, CAM WASHERS, AND NUTS WITH COMPONENTS OF A DIFFERENT DESIGN.
ON CERTAIN SPORT UTILITY VEHICLES, IF A DRIVER HAS NOT PLACED THE SHIFTER LEVER FULLY INTO THE "PARK" POSITION AND LEAVES THE VEHICLE RUNNING, THE VEHICLE MAY UNEXPECTEDLY MOVE REARWARD AFTER SEEMING TO BE STABLE. Remedy: DEALERS WILL INSTALL A SECONDARY DETENT SYSTEM TO THE FLOOR SHIFTER ASSEMBLY. DAIMLERCHRYSLER SENT INTERIM NOTICES TO OWNERS CONCERNING THIS PROBLEM ON MARCH 22, 2002. OWNER NOTIFICATION BEGAN SEPTEMBER 23, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
THE RETAINER CLIP WHICH SECURES THE MASTER CYLINDER INPUT ROD TO THE BRAKE PEDAL WAS NOT INSTALLED PROPERLY, AND COULD WORK LOOSE. Remedy: IMPROPERLY INSTALLED RETAINER CLIPS WILL BE REMOVED AND NEW RETAINER CLIPS WILL BE PROPERLY INSTALLED.
VEHICLE DESCRIPTION: PASSENGER AND MULTI-PURPOSE VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, ILLINOIS, INDIANA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, OR WISCONSIN, AND THE DISTRICT OF COLUMBIA. THE FRONT DISC BRAKE ROTORS CAN EXPERIENCE SEVERE CORROSION IF OPERATED FOR AN EXTENSIVE PERIOD IN THE "SALT BELT." IF THE ROTORS ARE NOT REPLACED, THE CORROSION CAN EVENTUALLY COMPROMISE THE STRUCTURAL INTEGRITY OF THE STAMPED STEEL CENTER HUB SECTION OF THE ROTOR. Remedy: DEALERS WILL REPLACE THESE ROTORS WITH ROTORS THAT ARE COATED WITH A CORROSION PROTECTION.
THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. THE CENTER REAR SEAT BELT BUCKLE MAY NOT BE ACCESSIBLE WHEN THE RIGHT (PASSENGER) SIDE OF THE REAR SEAT BACK IS FOLDED DOWN IN THE CARGO STOWAGE POSITION. Remedy: DEALERS WILL REPLACE THE SEAT BELT BUCKLE ASSEMBLY.
VEHICLE DESCRIPTION: MULTIPURPOSE PASSENGER VEHICLES EQUIPPED WITH AUTOMATIC TRANSMISSIONS. THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. DRIVERS CAN MISTAKENLY STEP ON THE ACCELERATOR PEDAL WHEN THEY INTEND TO STEP ON THE BRAKE PEDAL. Remedy: DEALERS WILL INSTALL A SHIFT INTERLOCK ON THE AUTOMATIC TRANSMISSION OF THESE VEHICLES.
THE MOLDED PLASTIC PIN WHICH CONNECTS THE UPPER STEERING COLUMN SHAFT AND THE LOWER COLUMN SHAFT MAY HAVE BEEN SHEARED PRIOR TO INSTALLATION OF THE STEERING COLUMN ASSEMBLY INTO THE VEHICLE. IF THIS OCCURRED, THE UPPER STEERING SHAFT WILL SEPARATE FROM THE LOWER STEERING SHAFT. Remedy: A RESTRAINING SLEEVE WILL BE ADDED TO THE INTERMEDIATE SHAFT TO LIMIT THE AMOUNT OF STEERING SHAFT MOVEMENT AVAILABLE.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Chrysler Canada has determined that an opportunity to incrementally improve performance in certain types of low-speed impacts may exist in certain vehicles. The company will carry out a voluntary customer satisfaction campaign to offer a structural improvement to mitigate the risks of fuel leakage in certain low-speed collisions. Chrysler will inspect the affected vehicles and install a Chrysler trailer hitch if appropriate. This action is not being conducted under the requirements of the Motor Vehicle Safety Act.
As a Customer Satisfaction Campaign DaimlerChrysler has initiated the following action: With certain Grand Cherokees, if a driver has not placed the shifter lever fully into the "park" position and leaves the vehicle running, the vehicle may unexpectedly move rearward after seeming to be stable. Inadvertent movement of the vehicle could result in a crash. Correction: Dealers will install a secondary detent system to the floor shifter assembly.
NOTE: VEHICLES ORIGINALLY RETAILED IN ONTARIO, QUEBEC AND THE MARITIME PROVINCES. THE COMPOSITE FRONT DISC BRAKE ROTORS ON THESE VEHICLES MAY FAIL DUE TO CORROSION. THE CAST IRON WEAR SURFACE MAY SEPARATE FROM THE HUB REDUCING THE BRAKING EFFECTIVENESS OF THE VEHICLE. CORRECTION: FRONT COMPOSITE ROTORS WILL BE REPLACED WITH ONES HAVING A REVISED CORROSION PROTECTION COATING.
NOTE: APPLIES TO VEHICLES WITH 5.2 LITRE ENGINE. THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S 1103 - EXHAUST EMISSIONS. VEHICLE EMISSION CONTROL INFORMATION LABEL SPECIFIES AN INCORRECT SPARK PLUG FOR THIS APPLICATION. CORRECTION: CORRECT LABELS AND INSTALLATION INSTRUCTIONS WILL BE MAILED TO OWNERS.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
THE PLASTIC RETAINING PINS IN THE COLLAPSIBLE STEERING COLUMN SHAFT WERE SHEARED PRIOR TO INSTALLATION OF THE COLUMN INTO THE VEHICLE. THIS COULD CAUSE THE UPPER STEERING COLUMN SHAFT TO SEPARATE FROM THE LOWER COLUMN SHAFT, WHICH COULD RESULT IN A LOSS OF STEERING CONTROL. CORRECTION: A RESTRAINING SLEEVE WILL BE ADDED TO THE INTERMEDIATE SHAFT TO LIMIT THE AMOUNT OF STEERING COLUMN SHAFT MOVEMENT.
THE LIFTGATE MAY BECOME DIFFICULT TO UNLATCH OR MAY NOT LATCH WHEN SHUT DUE TO AN INTERNAL RUBBER BUMPER INTERFERING WITH THE MOVEMENT OF THE LATCH PAWL. IF THE LIFTGATE DOES NOT LATCH PROPERLY WHEN CLOSED, THE LIFTGATE MAY OPEN WITHOUT WARNING WHILE THE VEHICLE IS BEING DRIVEN. CORRECTION: LATCH WILL BE INSPECTED AND REPLACED IF REQUIRED.
THESE VEHICLES MAY CONTAIN FRONT SUSPENSION CAM BOLTS WHICH MAY FAIL DUE TO ASSEMBLY MISALIGNMENT WHICH COUULD CAUSE THE BOLT TO BEND AND POSSIBLY CRACK DURING INSTALLATION. FAILURE OF THE BOLT MAY CAUSE THE VEHICLE TO PULL TO ONE SIDE WHEN THE BRAKES ARE APPLIED. THIS COULD RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING. CORRECTION: FRONT SUSPENSION CAM BOLTS, CAM WASHERS AND NUTS WILL BE REPLACED WITH COMPONENTS OF A DIFFERENT DESIGN.
THE RETAINER CLIP THAT SECURES THE MASTER CYLINDER INPUT ROD TO THE BRAKE PEDAL MAY NOT BE PROPERLY INSTALLED, POSSIBLY PREVENTING FULL CLIP ENGAGEMENT. THIS COULD RESULT IN THE INPUT ROD SEPARATING FROM THE BRAKE PEDAL WITH SUBSEQUENT LOSS OF SERVICE BRAKES. CORRECTION: VEHICLES WILL BE INSPECTED FOR PROPER CLIP INSTALLATION AND IMPROPERLY INSTALLED CLIPS WILL BE REPLACED.