Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1994 Ford B Series, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain B600, F600 and P800 vehicles, engine resonance can cause elevated stress conditions and a fatigue failure of the accelerator return springs. A failed return spring could result in the engine not fully returning to idle when the accelerator pedal is released. Correction: Accelerator return springs will be replaced with a torsion spring design.
On certain B700, F700, F800, FT900, L8000, LA8000, LN7000, LN8000, LNT8000, LS8000, LT8000 and LTS8000, the Hand throttle cable may wear the brass swivel block on the governor lever through which it passes. In some cases the wear may result in the cable jamming in the damaged swivel, which could prevent the governor lever from returning to the idle position. Correction: A revised governor lever with a stainless steel swivel will be installed on affected vehicles.
On certain B600, B700, F600, F700, F800, FT900, LA9000, LL9000, LTA9000 and LTL9000 vehicles, a connector where the wiring for lamps mounted on the tilt hood attaches to the vehicle wire harness was built without sealing plugs in the unused cavities of the connector. Road salt, moisture or other contaminants may enter the connector, which could result in crossed circuits, shorts or corrosion of the wiring in the connector and a malfunction of the headlamps or other front-end lighting systems. Correction: Sealing plugs will be installed in the unused connector cavities. If corroded, a new connector will be installed.
On certain B600 and B700 vehicles, the battery power junction block mounted on the right front fender apron might be susceptible to road splash and corrosion from calcium chloride and sodium chloride. This could result in eventual fracture of the main terminal or other terminals at the junction block causing the loss of vehicle power supply or loss of power to a particular system such as the engine, power steering or hydraulic brake boost. Correction: Dealers will replace the junction block, main power terminal from the starter or starter relay and terminals at the existing block. The hydraulic brake circuit will be modified by bypassing the junction block. New terminals will be made from an alloy material more resistant to salt corrosion.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain