Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1994 Jeep Cherokee, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
U.S. DRIVE RIGHT IS RECALLING 107 MY 1994-1998 RIGHT HAND DRIVE, 4-WHEEL DRIVE JEEP CHEROKEE VEHICLES. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 101, 'CONTROLS AND DISPLAYS;' NO. 108, 'LAMPS, REFLECTIVE DEVICES AND ASSOCIATED EQUIPMENT;' NO. 111, 'REARVIEW MIRROR;' NO. 114, 'THEFT PROTECTION;' NO. 115, 'VEHICLE IDENTIFICATION NUMBER;' NO. 118, 'POWER WINDOW SYSTEM;' NO. 120, 'TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS;' NO. 208, 'OCCUPANT CRASH PROTECTION;' AND NO. 301, 'FUEL SYSTEM INTEGRITY.' Remedy: U.S. DRIVE RIGHT WILL MAKE ALL THE REQUIRED MODIFICATIONS. A REPRESENTATIVE WILL TRAVEL TO THE CUSTOMER'S LOCATION AND MAKE THE MODIFICATIONS ON SITE. THE RECALL WILL BE PERFORMED ON A REGIONAL BASIS BEGINNING MARCH 2008. OWNERS MAY CONTACT U.S. DRIVE RIGHT AT 1-888-632-5936.
U.S. DRIVE RIGHT IS RECALLING CERTAIN MODEL YEAR 1994-1996 JEEP CHEROKEE VEHICLES IMPORTED FROM JANUARY 2007, THROUGH APRIL 2011 FOR FAILING TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT," FOR THE HIGH MOUNT BRAKE LAMP ASSEMBLY. THE VEHICLES ARE NOT EQUIPPED WITH THE REQUIRED THIRD BRAKE LAMP. Remedy: U.S. DRIVE RIGHT WILL NOTIFY OWNERS AND MAIL KITS ALONG WITH INSTRUCTIONS TO HAVE THE VEHICLE REPAIRED BY A QUALIFIED MECHANIC OF THEIR CHOICE, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON SEPTEMBER 12, 2011. OWNERS MAY CONTACT U.S. DRIVE RIGHT AT 1-888-632-5936.
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT. Remedy: PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.
VEHICLE DESCRIPTION: PASSENGER AND MULTI-PURPOSE VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, ILLINOIS, INDIANA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, OR WISCONSIN, AND THE DISTRICT OF COLUMBIA. THE FRONT DISC BRAKE ROTORS CAN EXPERIENCE SEVERE CORROSION IF OPERATED FOR AN EXTENSIVE PERIOD IN THE "SALT BELT." IF THE ROTORS ARE NOT REPLACED, THE CORROSION CAN EVENTUALLY COMPROMISE THE STRUCTURAL INTEGRITY OF THE STAMPED STEEL CENTER HUB SECTION OF THE ROTOR. Remedy: DEALERS WILL REPLACE THESE ROTORS WITH ROTORS THAT ARE COATED WITH A CORROSION PROTECTION.
DURING ASSEMBLY OF THE FRAME, A FILLET WELD THAT JOINS THE INNER STEERING GEAR ATTACHMENT REINFORCEMENT TO THE FRAME RAIL, WAS OMITTED. Remedy: DEALERS WILL INSPECT THE VEHICLES FOR CRACKS IN THE FRAME RAIL. VEHICLES THAT SHOW CRACKS WILL BE EQUIPPED WITH REINFORCEMENT PLATES. VEHICLES THAT ARE FOUND TO BE FREE OF CRACKS WILL HAVE A SLOT CUT IN THE CROSS MEMBER AND THE FILLET WELD WILL BE ADDED.
THE TWO REAR INBOARD SAFETY BELT ATTACHMENT BOLTS MAY HAVE INADEQUATE THREAD ENGAGEMENT INTO THE FLOOR PAN ANCHOR NUTS. Remedy: REPLACE THE TWO INBOARD SAFETY BELT ANCHOR BOLTS WITH LONGER BOLTS ON ALL VEHICLES.
VEHICLE DESCRIPTION: MULTIPURPOSE PASSENGER VEHICLES EQUIPPED WITH AUTOMATIC TRANSMISSIONS. THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. DRIVERS CAN MISTAKENLY STEP ON THE ACCELERATOR PEDAL WHEN THEY INTEND TO STEP ON THE BRAKE PEDAL. Remedy: DEALERS WILL INSTALL A SHIFT INTERLOCK ON THE AUTOMATIC TRANSMISSION OF THESE VEHICLES.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
NOTE: VEHICLES ORIGINALLY RETAILED IN ONTARIO, QUEBEC AND THE MARITIME PROVINCES. THE COMPOSITE FRONT DISC BRAKE ROTORS ON THESE VEHICLES MAY FAIL DUE TO CORROSION. THE CAST IRON WEAR SURFACE MAY SEPARATE FROM THE HUB REDUCING THE BRAKING EFFECTIVENESS OF THE VEHICLE. CORRECTION: FRONT COMPOSITE ROTORS WILL BE REPLACED WITH ONES HAVING A REVISED CORROSION PROTECTION COATING.
NOTE: VEHICLES EQUIPPED WITH 2.5 LITRE ENGINE. THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. THE MAT SURROUNDING THE CATALYST BISCUITS MAY ERODE DUE TO EXCESSIVE THERMAL EXPANSION OF THE CATALYST CAN. CORRECTION: CATALYTIC CONVERTER WILL BE REPLACED WITH ONE USING NEW MAT MATERIAL.
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 210 - SEAT BELT ASSEMBLY ANCHORAGES. THE TWO REAR INBOARD SEAT BELT ATTACHMENT BOLTS MAY HAVE INADEQUATE THREAD ENGAGEMENT TO THE FLOOR PAN ANCHOR NUTS. CORRECTION: TWO REAR INBOARD SEAT BELT ANCHOR BOLTS WILL BE REPLACED WITH LONGER ONES.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain