Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1994 Lincoln Town CAR, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
ON CERTAIN PICKUP TRUCKS, PASSENGER VEHICLES, SPORT UTILITY VEHICLES, AND MOTOR HOMES CHASSIS, THE SPEED CONTROL DEACTIVATION SWITCH MAY, UNDER CERTAIN CONDITIONS, LEAK INTERNALLY AND THEN OVERHEAT, SMOKE, OR BURN. Remedy: DEALERS WILL INSTALL A FUSED WIRING HARNESS. OWNERS OF THE PASSENGER CARS INCLUDED IN THIS CAMPAIGN WILL BE INSTRUCTED TO RETURN THEIR VEHICLES TO THEIR DEALERS TO HAVE THE SPEED CONTROL DEACTIVATION SWITCH DISCONNECTED AS AN INTERIM REPAIR. AS SOON AS REPAIR PARTS ARE AVAILABLE (EXPECTED OCTOBER 2007), OWNERS WILL BE INSTRUCTED TO RETURN TO THE DEALERS FOR INSTALLATION OF A FUSED WIRING HARNESS. THE RECALL BEGAN ON AUGUST 13, 2007, AND MAILING COMPLETED BY SEPTEMBER 19, 2007. OWNERS MAY CONTACT FORD AT 1-888-222-2751.
IMPROPER INSTALLATION OF THE REAR BRAKE LINE AT THE POINT AT WHICH THE EXTENDED BRAKE LINE FIRST BENDS AND EXTENDS OVER THE LEFT REAR WHEEL AREA OF THE FRAME. IF NOT INSTALLED WITH SUFFICIENT CLEARANCE, CHAFING OF THE BRAKE LINE CAN OCCUR IN AN AREA ADJACENT TO THE REAR FLOOR PAN. Remedy: DEALERS WILL INSPECT THE BRAKE LINE FOR PROPER INSTALLATION AND/OR DAMAGE AND REPLACE AS NECESSARY. ALSO A PROTECTIVE BOOT OR SLEEVE OVER THE BRAKE LINE WILL BE INSTALLED.
THE NUTS AND BOLTS THAT ATTACH THE REAR BRAKE ADAPTOR TO THE AXLE HOUSING FLANGE CAN LOOSEN AND EVENTUALLY SEPARATE. IF ONE OR MORE OF THE NUTS COME OFF THE BOLTS, DAMAGE TO THE PARKING BRAKE ASSEMBLY OR TO THE ANTILOCK BRAKE SYSTEM (ABS) SENSOR AND SENSOR RING (IF SO EQUIPPED) WILL OCCUR. IF ALL FOUR NUTS ON ONE END OF THE AXLE COME OFF THE BOLTS, DAMAGE TO THE BRAKE HYDRAULIC LINE OR THE PARKING BRAKE CABLE CAN OCCUR. Remedy: DEALERS WILL INSPECT AND, IF NEEDED, INSTALL NEW BOLTS. IF ANY OF THE FASTENERS ARE DISCONNECTED, THE PARKING BRAKE AND ABS COMPONENTS WILL BE INSPECTED AND SERVICED.
VEHICLE DESCRIPTION: CERTAIN 1996-1999 FORD CROWN VICTORIA POLICE, FLEET, NATURAL GAS, AND 1996-1999 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT WERE PRODUCED WITH A LOWER CONTROL ARM BALL JOINT CONTAINING A ONE PIECE BEARING; AND 1990-1996 FORD CROWN VICTORIA POLICE, FLEET, AND NGV VEHICLES AND 1990-1996 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT HAVE BEEN SERVICED WITH EITHER A BALL JOINT CONTAINING THE ONE-PIECE BEARING OR A FRONT LOWER CONTROL ARM CONTAINING A BALL JOINT WITH A ONE-PIECE BEARING. THE ONE-PIECE BEARING WITHIN THE LOWER CONTROL ARM BALL JOINT CAN WEAKEN SLOWLY DURING USE AND EVENTUALLY CRACK. THIS COULD RESULT IN SEPARATION OF THE BALL AND CAP OF THE JOINT, ALLOWING THE CONTROL ARM TO DROP TO THE GROUND. Remedy: DEALERS WILL REPLACE THE LOWER CONTROL ARM BALL JOINTS (2).
THE BRAKE PEDAL PUSH ROD RETAINER (HAIRPIN CLIP) MAY BE MISSING OR NOT PROPERLY INSTALLED ON THE SERVICE BRAKE PEDAL. THIS CAN CAUSE DISENGAGEMENT OF THE BRAKE PUSHROD AND LOSS OF BRAKING ABILITY. Remedy: DEALERS WILL INSPECT AND, IF NECESSARY, REPLACE THE RETAINER.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, a wiring harness that is not compatible with the vehicle circuit polarity may have been inadvertently installed during servicing for recall 2005028 or 2007258. As a result, the fuse is located in the output circuit rather than in the input power feed circuit, and will not offer the intended protection in the event of an electrical short to ground. This could result in a vehicle fire, causing property damage and/or personal injury. Correction: Dealers will install an updated wiring harness.
On certain vehicles, the speed control deactivation switch may overheat, smoke, or burn, potentially resulting in an underhood fire. The failure mode appears to be different than that of Recall 2005028 (05S28). This time, the concern is with long term durability performance issues causing the switch to fail. Correction: Initially as an interim repair, owners will be instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected. As soon as replacement parts are available, owners will be instructed to return to the dealers for installation of a fused wiring harness designed to eliminate the potential risk of fire.
Note: 1996-99 crown victoria police, fleet and ngv and lincoln town car limousine equipped with a lower control arm ball joint containing a one piece bearing and 1990-96 crown victoria police, fleet and ngv and lincoln town car limousine that were serviced with either a ball joint containing an one piece bearing or a front lower control arm with a one piece bearing. High bearing loads can lead to thinning and eventual cracking of the lower control arm ball joint. This can result in separation of the ball and cap of the joint. Should this occur, the control arm to which the cap is mounted will drop to the ground. Should this occur while the vehicle is moving, reduced steering control could result in a collision. Correction: Lower control arm ball joints will be replaced.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
NOTE: INCLUDES CROWN VICTORIA WITH POLICE PACKAGE AND TOWN CAR WITH LIMOUSINE PREP PACKAGE. THE REAR BRAKE BACKING PLATE ADAPTER FASTENERS MAY COME LOOSE AND SEPARATE. SHOULD THIS OCCUR, DAMAGE TO THE SERVICE BRAKE, PARKING BRAKE OR ABS COMPONENTS COULD RESULT. THIS COULD IN TURN DIMINISH SERVICE AND PARKING BRAKE CAPABILITY. CORRECTION: REAR BRAKE BACKING PLATE ADAPTER FASTENERS WILL BE REPLACED ON AFFECTED VEHICLES.
THE BRAKE PEDAL TO MASTER CYLINDER PUSH ROD RETAINER (HAIRPIN CLIP) MAY NOT HAVE BEEN PROPERLY INSTALLED ON THE SERVICE BRAKE PEDAL. THIS COULD RESULT IN DISENGAGEMENT OF THE BRAKE PUSH ROD AND LOSS OF SERVICE BRAKING. THIS COULD OCCUR WITHOUT WARNING AND RESULT IN A VEHICLE CRASH. CORRECTION: DEALERS WILL INSPECT, AND IF NECESSARY, REPLACE THE RETAINER.