Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1994 Volkswagen Jetta, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE REAR BRAKE LINE ON THE PASSENGER SIDE WAS ROUTED TOO CLOSE TO THE CORNER OF THE FUEL TANK. THE LINE COULD BE DAMAGED BY CHAFING AGAINST THE FUEL TANK. Remedy: DEALERS WILL INSPECT THE BRAKE LINE AND REPLACE ANY DAMAGED LINES.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE BOLTS SECURING THE FRONT HOOD LATCH CAN LOOSEN OVER TIME. THE LATCH WOULD MOVE CAUSING DISENGAGEMENT OF THE HOOD STRIKER FROM THE LATCH. Remedy: DEALERS WILL INSPECT THE HOOD LATCH AND SECURING BOLTS AND REPLACE THEM IF NECESSARY.
THE SHEET METAL PANELS OF BOTH REAR DOORS HAVE OPENINGS FOR THE ROUTING OF THE ELECTRICAL WINDOW REGULATOR WIRING. THE PANEL OPENINGS HAVE SHARP EDGES THAT CAN DAMAGE THE INSULATION OF THE WIRING HARNESS. Remedy: DEALERS WILL INSTALL A PROTECTIVE EDGE COVER IN BOTH REAR DOOR INNER PANEL OPENINGS.
WHEN INSTALLED IN THE VEHICLES, A TIE WRAP IS USED TO GUIDE THE CRUISE CONTROL CABLE IN THE ENGINE COMPARTMENT. SOME TIE WRAPS HAVE BEEN INSTALLED WITH A LARGE LOOP OPENING IMPROPERLY GUIDING THE CABLE WHICH COULD PREVENT THE THROTTLE FROM RETURNING TO ITS FULL IDLE POSITION. Remedy: DEALERS WILL REMOVE THE CRUISE CONTROL TIE WRAP AND INSTALL A NEWLY DESIGNED GUIDE.
THE JACKS SUPPLIED WITH THESE VEHICLES WERE ASSEMBLED WITH AN IMPROPERLY MACHINED SPINDLE, SO THAT A SHARP RIDGE ON THE EDGE OF SPINDLE'S THREAD WOULD HAVE REMAINED. Remedy: OWNERS WILL BE PROVIDED WITH A NEW JACK.
IMPROPER MATERIAL WAS USED IN MANUFACTURING THE RADIATOR FAN MOTOR SHAFT CAUSING THE SHAFT TO WEAR AND BECOME NOISY. Remedy: DEALERS WILL REPLACE THE COMPLETE COOLING FAN ASSEMBLY ON VEHICLE HAVING THE POTENTIAL SHAFT MATERIAL PROBLEM. DEALERS WILL INSTALL A NEW FAN BLADE INCLUDING A NEW LOCK NUT ON VEHICLE WITH LOOSE FAN BLADE LOCK NUTS.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, the rear brake line on the passenger side could be routed too close to the corner of the fuel tank. An improperly routed brake line could be damaged by chafing against the fuel tank during extreme axle movement. Such chafing could result in a leaking brake line causing a partial brake system failure and increased stopping distances. Correction: Dealers will check the routing of the right rear brake line and replace any damaged brake line.
THE BOLTS SECURING THE FRONT HOOD LATCH MAY LOSE THEIR SPECIFIED FASTENING TORQUE OVER TIME. SHOULD THIS HAPPEN, THE LATCH COULD MOVE OUT OF ITS DESIGN POSITION AND CAUSE DISENGAGEMENT OF THE HOOD STRIKER FROM THE LATCH. IN SOME VEHICLES THE LATCH MAY NOT HAVE BEEN PROPERLY ALIGNED DURING PRODUCTION. REPEATED OPENING AND CLOSING OF THE HOOD WITH AN IMPROPERLY ALIGNED LATCH COULD RESULT IN DAMAGE TO THE LATCH. EITHER CONDITION COULD RESULT IN HOOD FLY UP AND OBSTRUCTION OF THE DRIVER'S VISION. CORRECTION: HOOD LATCHES AND SECURING BOLTS WILL BE INSPECTED AND REPLACED IF NECESSARY.
NOTE: INCLUDES PASSAT, GOLF AND JETTA TURBO DIESEL. ON 1993-94 MODELS, THE RADIATOR FAN MOTOR SHAFT COULD SEIZE AND RENDER THE FAN MOTOR INOPERATIVE. 1994-95 MODELS COULD EXPERIENCE A CONDITION WHEREBY THE LOCK NUT SECURING THE RADIATOR FAN BLADE HUB TO THE MOTOR COULD LOSE ITS REQUIRED TORQUE. A LOOSE LOCK NUT COULD CAUSE THE FAN HUB TO LOOSEN FROM THE SHAFT AND CAUSE THE BELT PULLEY TO RUN "OFF-CENTER". THIS IN TURN COULD CAUSE THE FAN BELT TO DISCONNECT OR BREAK. EITHER OF THE ABOVE CONDITIONS COULD RESULT IN ENGINE OVERHEATING AND STALLING. A VEHICLE STALLING IN TRAFFIC COULD CAUSE AN ACCIDENT. CORRECTION: VEHICLES WITH EITHER HAVE THE COMPLETE COOLING FAN ASSEMBLY REPLACED OR A NEW FAN BLADE WITH A NEW LOCK NUT INSTALLED.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
A SHARP RIDGE ON THE JACK SPINDLE COULD DAMAGE THE INSIDE THREAD OF THE SCISSOR SHOE WHEN THE JACK IS USED TO LIFT THE VEHICLE. IF THE DAMAGE TO THE THREAD OF THE SCISSOR SHOE IS SERIOUS ENOUGH, THE JACK COULD COLLAPSE WITH THE POSSIBILITY THAT A PERSON STANDING TOO CLOSE THE VEHICLE COULD BE INJURED. CORRECTION: JACKS WILL BE REPLACED ON AFFECTED VEHICLES.