Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1995 Buick Roadmaster, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
THESE VEHICLES WERE PRODUCED WITH AN IMPROPERLY ADJUSTED TRANSMISSION SHIFT CONTROL LINKAGE. THIS DOES NOT MEET WITH THE REQUIREMENTS OF FMVSS NO. 114, "THEFT PROTECTION." Remedy: DEALERS WILL ADJUST THE SHIFT CONTROL LINKAGE SYSTEM.
THE WHEEL LUG NUTS WERE NOT TIGHTENED TO THE PROPER SPECIFICATION DURING ASSEMBLY. Remedy: DEALERS WILL TIGHTEN THE VEHICLE'S WHEEL LUG NUTS TO THE PROPER SPECIFICATION.
DEFECTIVE LOWER CONTROL ARM BALL JOINT ATTACHMENT NUTS WERE NOT PROPERLY TORQUED AND CAN LOOSEN. Remedy: DEALERS WILL INSPECT BOTH FRONT LOWER CONTROL ARM BALL JOINT ATTACHMENT NUTS FOR PROPER TORQUE. IF THE BALL JOINT HAS LOOSENED FROM THE KNUCKLE, BOTH THE BALL JOINT AND THE KNUCKLE WILL BE REPLACED.
THESE VEHICLES WERE SHIPPED WITH BOTH THE SUPPLEMENTAL INFLATABLE RESTRAINT CAUTION LABEL AND A ROOF RACK CAUTION LABEL INSTALLED ON THE SAME SIDE OF THE SUN VISOR. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO.208, "OCCUPANT CRASH PROTECTION." Remedy: A NEW ROOF RACK CAUTION LABEL, WITH INSTALLATION INSTRUCTIONS, WILL BE SENT DIRECTLY TO OWNERS. OWNERS WILL INSTALL THE LABEL OR HAVE THEIR DEALER INSTALL THE LABEL FOR THEM.
THESE VEHICLES FAIL TO CONFORM TO FMVSS NO. 124, "ACCELERATOR CONTROL SYSTEMS." AT LOW TEMPERATURES, EXCESSIVE FRICTION CAN OCCUR IN THE ACCELERATOR PEDAL ASSEMBLY. Remedy: DEALERS WILL REPLACE THE ACCELERATOR PEDAL ASSEMBLY.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
NOTE: INCLUDES CAPRICE POLICE SEDANS, TAXI CABS AND SPECIAL SERVICE WAGONS; FLEETWOOD HEARSE AND LIMOUSINE. THE LOWER CONTROL ARM BALL JOINT ATTACHMENT MAY BE LOOSE. THIS CONDITION CAN CAUSE THE LOWER CONTROL ARM BALL JOINT TO LOOSEN, FATIGUE AND SEPARATE FROM THE FRONT SUSPENSION KNUCKLE. IF SEPARATION WERE TO OCCUR WITH THE VEHICLE IN MOTION, LOSS OF VEHICLE CONTROL COULD OCCUR, WHICH COULD RESULT IN A VEHICLE CRASH. CORRECTION: FRONT LOWER CONTROL ARM BALL JOINT ATTACHMENT NUTS WILL BE INSPECTED FOR PROPER TORQUE. IF THE BALL JOINT HAS LOOSENED FROM THE KNUCKLE, BOTH THE BALL JOINT AND KNUCKLE WILL BE REPLACED.
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 102 - TRANSMISSION SHIFT CONTROL SEQUENCE. A MISADJUSTED TRANSMISSION SHIFT CONTROL LINKAGE MAY ALLOW THE TRANSMISSION TO BE SHIFTED OUT OF THE "P"(PARK) POSITION WITH THE IGNITION KEY REMOVED. IN THE EVENT OF THIS CONDITION OCCURRING, THE VEHICLE MAY ROLL FROM ITS PARKED POSITION AND CAUSE POTENTIAL DAMAGE AND/OR INJURY. CORRECTION: SHIFT CONTROL LINKAGE SYSTEM WILL BE ADJUSTED.
Certain vehicles do not comply with CMVSS 124 - Accelerator Control Systems. At low temperatures there may be excessive movement friction in the accelerator pedal assembly. In the event of a failure of a throttle return spring the engine speed may not decrease to the level anticipated by the driver when the foot is lifted from the accelerator pedal. Loss of accelerator control could result in a vehicle crash without prior warning. Correction: Accelerator pedal assembly will be replaced.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain