Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1995 Chevrolet Cavalier, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN CK MOTORSPORTS COMBINATION HEADLIGHTS, CLEAR CORNER, BUMPER, AND SIDE MARKER LIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON THE PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT. Remedy: CK MOTORSPORT WILL NOTIFY OWNERS AND REPLACE THE NONCOMPLIANT LAMPS FREE OF CHARGE. THE RECALL BEGAN ON JULY 1, 2006. OWNERS MAY CONTACT CK MOTORSPORT AT 1-909-610-7211.
DORMAN PRODUCTS IS RECALLING 3,900 INTERMEDIATE STEERING SHAFTS DORMAN PART NOS. 425-151, 425-152, AND 425-153, (SOLD UNDER DORMAN'S "OE SOLUTIONS" BRAND NAME), BALKAMP #'S 7-3057, 7-3058, 7-3059 (SOLD UNDER THE "NAPA" BRAND NAME), AND PLATINUM PARTS #'S 2425151, 2425152, AND 2425153 MANUFACTURED DURING THE MONTH OF SEPTEMBER 2007. THESE REPLACEMENT STEERING SHAFTS CAN BE USED ON THE VEHICLES LISTED ABOVE. THE WELD CONNECTING THE INNER TUBE TO THE OUTER TUBE MAY BE DEFECTIVE. Remedy: DORMAN WILL NOTIFY OWNERS AND REPLACE THE STEERING SHAFTS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 16, 2008. OWNERS MAY CONTACT DORMAN TOLL FREE AT 1-800-523-2492.
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT. Remedy: PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.
ON CERTAIN PASSENGER VEHICLES. IF THE ENGINE FAILS TO START AND THE DRIVER HOLDS THE KEY IN THE "START" POSITION FOR AN EXTENDED PERIOD, HIGH CURRENT FLOWS THROUGH THE IGNITION SWITCH, AND SOMETIMES PRODUCES ENOUGH HEAT TO MELT INTERNAL SWITCH PARTS. Remedy: DEALERS WILL INSTALL A RELAY KIT IN THESE VEHICLES TO PREVENT HIGH CURRENT FROM FLOWING THROUGH THE IGNITION SWITCH. OWNER NOTIFICATION BEGAN MARCH 27, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CHEVROLET AT 1-800-222-1020, PONTIAC AT 1-800-762-2737, BUICK AT 1-800-521-7300, OR OLDSMOBILE AT 1-800-442-6537.
THESE VEHICLES HAVE BEEN BUILT WITH WELDS MISSING FROM THE FRONT SUSPENSION LOWER CONTROL ARM ASSEMBLIES CAUSING EXCESSIVE LOADS ON THE EXISTING WELDS. Remedy: DEALERS WILL INSPECT BOTH LEFT-HAND AND RIGHT-HAND FRONT SUSPENSION LOWER CONTROL ARM ASSEMBLIES AND REPLACE ALL CONTROL ARM ASSEMBLIES FOUND WITH OMITTED WELDS.
SOME WELDS WERE OMITTED FROM THE BODY LOCK PILLAR, OR "B" PILLAR. THIS DOES NOT COMPLY WITH FMVSS NO.208, "OCCUPANT CRASH PROTECTION." Remedy: ALL VEHICLES IN THIS RECALL CAMPAIGN HAVE BEEN REPURCHASED AND REPLACED WITH A COMPARABLE VEHICLE.
THE FRONT AND/OR REAR HAZARD WARNING LAMPS (FOUR-WAY FLASHERS) DO NOT FLASH WHEN THE HAZARD SWITCH IS ACTIVATED. THIS FAILS TO COMPLY WITH FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." Remedy: DEALERS OR VEHICLE OWNERS WILL INSPECT FOR PROPER FUNCTION OF THE HAZARD WARNING LAMPS. IF NECESSARY, DEALERS WILL REPLACE THE HAZARD LAMP SWITCH.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain passenger vehicles if the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts. If the switch is damaged, a fire could occur in the steering column, even with the engine off and the key removed. Correction: Dealers will install a relay kit in these vehicles to prevent high current from flowing through the ignition switch.
Note: Certain 1997-99 vehicles in Ontario, Quebec and the Atlantic provinces and 1995-99 vehicles in all other provinces and territories. Moisture may enter the Powertrain Control Module (PCM) as a result of corrosion after extended exposure to road salt. This can lead to symptoms including illumination of the "Check Engine" light or the engine running rough. If these symptoms are ignored the engine may stall and may not be able to be restarted. Correction: Dealers will seal the Powertrain Control Module (PCM) in a protective shield/cover assembly.
On certain vehicles located in Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland, Moisture entering the Powertrain Control Module (PCM) as a result of corrosion can cause illumination of the "Check Engine" light or cause the engine to run rough. If these symptoms are ignored, the engine may stall and may not be able to be restarted. Correction: Dealers will inspect, clean and/or replace the Powertrain Control Module (PCM), then seal the PCM in a protective shield/cover assembly.
THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 108 - LIGHTING EQUIPMENT. VEHICLES MAY EXHIBIT A CONDITION IN WHICH THE FRONT AND/OR REAR HAZARD WARNING LAMPS (FOUR-WAY FLASHERS) DO NOT FLASH WHEN THE HAZARD SWITCH IS ACTIVATED. CORRECTION: VEHICLES WILL BE INSPECTED AND HAZARD LAMP SWITCH REPLACED IF NECESSARY.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
THESE VEHICLES MAY HAVE BEEN BUILT WITH WELDS OMITTED FROM THE FRONT SUSPENSION LOWER CONTROL ARM ASSEMBLIES. THIS CONDITION COULD CAUSE EXCESSIVE LOADS ON EXISTING CONTROL ARM WELDS, AND COULD RESULT IN SEPARATION OF THE FRONT BUSHING-SLEEVE SUBASSEMBLY FROM THE CONTROL ARM. THIS COULD RESULT IN REDUCED STEERING CONTROL AND A CRASH WITHOUT PRIOR WARNING. CORRECTION: SUSPENSION LOWER CONTROL ARMS WILL BE INSPECTED AND THOSE FOUND WITH OMITTED WELDS WILL BE REPLACED.