Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1995 Dodge RAM, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
K2 MOTOR IS RECALLING 1,921 AFTERMARKET HEADLAMPS OF VARIOUS MODELS SOLD FOR USE ON THE ABOVE LISTED VEHICLES. THESE HEADLAMPS ARE MISSING THE AMBER SIDE REFLEX REFLECTOR WHICH FAILS TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." Remedy: K2 MOTOR WILL NOTIFY OWNERS AND OFFER A FULL REFUND. THE RECALL BEGAN ON DECEMEBER 17, 2008. OWNERS MAY CONTACT K2 MOTOR AT 1-909-839-2992.
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.
CERTAIN AAI MOTORSPORTS COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LIST PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." Remedy: AAI MOTORSPORTS WILL NOTIFY OWNERS AND REPLACE THE LAMPS FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 1, 2006. OWNERS MAY CONTACT AAI MOTORSPORTS AT 909-923-9188.
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.
VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS. THE AFFECTED VEHICLES WERE BUILT WITH AN IGNITION SWITCH AND WIRING THAT COULD OVERHEAT. HIGH ELECTRICAL CURRENT LOADS PASS THROUGH THE SWITCH WHEN THE BLOWER MOTOR IS OPERATED ON HIGH FOR AN EXTENDED PERIODS OF TIME. Remedy: DEALERS WILL INSTALL A RELAY AND OVERLAY HARNESS.
VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS. (2500 AND 3500 SERIES 4X4 REGULAR CAB PICKUP PRODUCED BEFORE MARCH 21, 1995; 2500 AND 3500 SERIES 4X4 CLUB CAB PICKUP PRODUCED BEFORE JUNE 8, 1995; AND 3500 SERIES 4X2/4X4 CHASSIS CAB TRUCKS PRODUCED BEFORE JUNE 21, 1995). THE FRONT SUSPENSION SPRING/SHOCK TOWERS CAN CRACK AND EVENTUALLY SEPARATE FROM THE VEHICLE FRAME. THE SHOCK TOWER COULD DAMAGE THE REAR WHEEL BRAKE LINES RESULTING IN LOSS OF REAR BRAKE SYSTEM PRESSURE. Remedy: DEALERS WILL INSPECT THE SPRING/SHOCK TOWER AND ANY VEHICLES EXHIBITING CRACKING WILL HAVE THE TOWER REPLACED. VEHICLES THAT ARE DO NOT SHOW ANY CRACKING WILL HAVE A WELD-ON REINFORCEMENT ADDED.
ON CERTAIN PICKUP TRUCKS ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE FOLLOWING "SALT BELT" STATES: MAINE, NEW HAMPSHIRE, VERMONT, MASSACHUSETTS, RHODE ISLAND, CONNECTICUT, NEW YORK, NEW JERSEY, PENNSYLVANIA, DELAWARE, MARYLAND, THE DISTRICT OF COLUMBIA, WEST VIRGINIA, OHIO, INDIANA, MICHIGAN, ILLINOIS, WISCONSIN, MINNESOTA, IOWA, AND MISSOURI. CORROSION OF THE RETURN SPRING ON THE HOOD SECONDARY LATCH COULD CAUSE THE MECHANISM TO BIND IN THE "RELEASE POSITION." Remedy: DEALERS WILL REPLACE THE SECONDARY HOOD LATCH. OWNER NOTIFICATION BEGAN SEPTEMBER 17, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
VEHICLE DESCRIPTION: PICKUP TRUCKS EQUIPPED WITH DIESEL ENGINES. THE THROTTLE CABLE COULD UNRAVEL (FRAY) OR BREAK RESULTING IN LOSS OF THROTTLE CONTROL. Remedy: DEALERS WILL INSPECT AND REPLACE THE THROTTLE CABLE AND UPPER BELL CRANK LEVER. OWNER NOTIFICATION BEGAN AUGUST 3, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
VEHICLE DESCRIPTION: PICKUP TRUCKS EQUIPPED WITH MANUAL TRANSMISSION, V10 ENGINES AND FOUR-WHEEL-DRIVE TRANSFER CASES. UNDER SUSTAINED MAXIMUM RATED VEHICLE LOAD, WHILE DRIVING UP A STEEP GRADE IN FOUR-WHEEL-DRIVE LOW RANGE IN HOT AMBIENT CONDITIONS, THE LOCAL EXHAUST TEMPERATURE PROXIMATE TO THE HYDRAULIC CLUTCH LINE CAN GENERATE LINE TEMPERATURES THAT EXCEED THE TEMPERATURE LIMIT OF THE CLUTCH LINE MATERIAL. IF THIS CONDITION OCCURS AND THE CLUTCH IS DEPRESSED, THE LINE COULD RUPTURE. Remedy: DEALERS WILL REPLACE THE HYDRAULIC CLUTCH ASSEMBLY.
IF THE PLASTIC PINS AND METAL CLIP THAT RETAIN THE LOWER STEERING SHAFT IN THE UPPER SHAFT BREAK, THE LOWER STEERING SHAFT CAN SEPARATE FROM THE UPPER SHAFT. Remedy: DEALERS WILL ADD A RESTRAINING SLEEVE TO THE INTERMEDIATE STEERING SHAFT TO LIMIT THE AMOUNT OF AXIAL STEERING COLUMN SHAFT MOVING IN THE EVENT THE PLASTIC PINS AND METAL CLIP ARE BROKEN.
WHILE MAKING A TURN, THE EXTRA KEYS ON A VEHICLE OPERATOR'S KEY RING CAN BECOME TEMPORARILY LODGED IN THE SCREW ACCESS HOLES IN THE BACK COVER OF THE STEERING WHEEL. Remedy: DEALERS WILL REPLACE THE STEERING WHEEL BACK COVER WITH A REDESIGNED COVER.
VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS EQUIPPED WITH GASOLINE ENGINES. THE FUEL TANK MOUNTED ROLLOVER VALVE CAN ALLOW LIQUID FUEL TO LEAK ONTO THE GROUND UNDER CERTAIN VEHICLE OPERATING CONDITIONS. Remedy: DEALERS WILL REPLACE THE FUEL TANK ROLLOVER VALVE WITH A FLOAT TYPE ROLLOVER VALVE.
VEHICLE DESCRIPTION: PICKUP TRUCKS EQUIPPED WITH DIESEL ENGINES. THE ENGINE DRIVEN VACUUM PUMP CAN ALLOW ENGINE OIL INTO THE VACUUM HOSES DUE TO THE ABSENCE OF AN INTERNAL CHECK VALVE. THE OIL CAN CAUSE THE HOSE TO DETERIORATE AND PARTIALLY COLLAPSE, REDUCING THE VACUUM SUPPLY TO THE BRAKE BOOSTER. Remedy: DEALERS WILL ADD A VACUUM PUMP CHECK VALVE TO THE VACUUM PUMP. IN ADDITION, THE VACUUM HOSE CONNECTED TO THE VACUUM PUMP WILL BE REPLACED WITH A HOSE THAT IS ENGINE OIL RESISTANT.
THE SECONDARY HOOD LATCH ROD CAN BIND ON THE GUIDE BRACKET AND PREVENT ENGAGEMENT OF THE SECONDARY LATCH. Remedy: DEALERS WILL REPLACE THE SECONDARY HOOD LATCH BRACKET.
UNDER CERTAIN HIGH LOAD OPERATING CONDITIONS, THE TRANSMISSION FLUID TEMPERATURE CAN EXCEED THE MELTING POINT OF THE MATERIAL USED IN THE CONNECTOR TO RETAIN THE FLUID LINE TO THE TRANSMISSION. Remedy: DEALERS WILL REPLACE THE HIGH TEMPERATURE SIDE OF THE TRANSMISSION FLUID COOLER LINE CONNECTOR FITTINGS WITH CONNECTORS THAT INCORPORATE A STAINLESS STEEL RETAINER.
VEHICLE DESCRIPTION: VAN AND WAGON MODEL PASSENGER VEHICLES. IF WATER/ROAD SALT GETS ON THE INTERIOR FLOOR OF THE VEHICLE IN THE PROXIMITY OF THE AIR BAG ELECTRONIC CONTROL MODULE (AECM), THE AECM CAN CORRODE. THE RESULTING CORROSION CAN CAUSE THE DRIVER SIDE AIR BAG TO DEPLOY INADVERTENTLY. Remedy: DEALERS WIL REPLACE THE AECM WITH AN AECM THAT IS SEALED FROM MOISTURE INTRUSION.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain diesel pickup trucks, the throttle cable can unravel (fray) or break, which could result in loss of throttle control and loss of power. Correction: Original throttle control cable and upper bell crank lever will be replaced on affected vehicles.
On certain pickup trucks located in Ontario, Quebec and the Maritime provinces, corrosion of the hood secondary latch return spring may cause the hood secondary latch to become inoperative, possibly allowing the hood to open unexpectedly if the primary hood latch mechanism is not engaged. Such an occurrence could block driver vision and result in possible loss of control and a crash. Correction: A new secondary hood latch that incorporates a stainless steel spring will be installed on affected vehicles.
Certain pickup trucks were built with an ignition switch and wiring that may overheat under certain operating conditions. High electrical current loads pass through the switch when the blower motor is operated on high for an extended period of time. The extensive current load can cause the ignition switch and wiring to overheat, possibly resulting in a vehicle fire. Correction: Vehicles will have a relay and overlay harness installed. In addition, the ignition switch and wiring will be inspected and replaced as necessary.
On certain pickup trucks equipped with a diesel or V-10 engine, the front suspension spring/shock towers may crack and eventually separate from the vehicle frame. If the left side tower cracking goes undetected by the operator and separates from the frame, the shock tower may damage the rear wheel brake lines. If this happens, this may result in reduced system pressure creating the potential for increased stopping distances. Correction: Spring/shock towers will be inspected and vehicles exhibiting cracking will have the towers replaced with a tower that incorporates reinforcement. Vehicles that do not exhibit cracking will have a weld on reinforcement added.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
On certain 4 x 4 pickups equipped with an 8.0 litre V10 engine, Under certain heavy duty applications, such as driving up a steep grade in four wheel drive with a full load, the local exhaust temperature proximate to the hydraulic clutch line may generate line temperatures that exceed the temperature limit of the clutch line material. If this operating condition occurs and the clutch is depressed, the line may rupture and fluid may ignite on the hot exhaust potentially causing a vehicle fire. Correction: The hydraulic clutch line will be altered to prevent line melting due to exhaust system heat transfer.
On certain Ram 3500 vehicles, the headlamp switches used in this truck series operate under a high current load which results in switch internal temperatures above the 100 degree centigrade limit for the internal lubing grease. This heat will cause the grease to break down and increase the resistance in the switch resulting in eventual switch failure. Correction: Headlamp switches will be replaced and a relay will be included in the park lamp wiring circuit causing the headlamps or park lamps to go out.
Certain vehicles may not comply with CMVSS 1105 - evaporative emissions. The evaporative canister may allow migration of its contents (charcoal) through the purge system and into the engine. Missing charcoal may cause the vehicle to fail evaporative emissions testing. Correction: An improved evaporative canister and purge solenoid will be installed.
Certain Ram 3500 vehicles do not comply with CMVSS 1101 - emission device. The Vehicle emission warranty statement in the engine warranty manuals does not include the powertrain control module and the catalyst in the list of warranted emission control components. Correction: Owners will be sent a warranty manual insert with the correct information.
On certain vehicles, the fuel tank mounted rollover valve may allow liquid fuel to leak onto the ground under certain conditions. In the presence of an ignition source, a fire could occur. Correction: The fuel tank rollover valve will be replaced with a float type rollover valve.
Certain vehicles do not comply with CMVSS 1103 - exhaust emissions. The elbow containing the crankcase ventilation orifice was installed on the wrong valve cover resulting in improper metering of crankcase gases being returned to the combustion chamber. Correction: Breather elbows will be reversed from one side of the engine to the other side.
On certain vehicles, the engine driven vacuum pump may introduce engine oil into the vacuum hoses due to the absence of an internal check valve. The oil may cause the hose to deteriorate and partially collapse, reducing the vacuum supply to the brake booster. Correction: A vacuum pump check valve will be added at the vacuum pump and the vacuum hose connected to the pump will be replaced with one that is resistant to engine oil.
On certain vehicles, the transmission fluid temperature could exceed the melting point of the connector which retains the fluid line to the transmission. Should this occur, the fluid line may become disconnected from the transmission and fluid may spray onto the exhaust manifold, possibly resulting in a fire. Correction: The connector fittings on the high temperature side of the transmission fluid cooler line will be replaced with connectors incorporating a stainless steel retainer.
On certain vehicles, the plastic pins and metal clip that retain the steering column lower shaft could break, causing the lower shaft to separate from the upper shaft. This would result in loss of steering control and a possible crash without prior warning. Correction: A restraining sleeve will be added to the intermediate shaft to limit the amount of axial steering column shaft movement possible in the event the plastic pins and metal clip are broken.
On certain vehicles, the secondary hood latch rod may bind on the guide bracket and prevent secondary latch engagement. If this condition occurs simultaneously with a not engaged primary latch, the hood may not be properly restrained. Correction: Hood latch bracket will be replaced with one that is not susceptible to binding.