Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1995 Freightliner FL-70, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
THE BRAKE CHAMBER MOUNTING STUDS CAN LOOSEN OR PULL THROUGH DUE TO FATIGUE IN THE BRAKE CHAMBER HOUSING CAUSED BY FOUNDATION BRAKE CHATTER. Remedy: DEALERS WILL CHANGE THE BRAKE LINING MATERIALS, REPLACE THE WING BRACKET WITH A REINFORCED BRACKET AND INSTALL BRAKE CHAMBERS WITH REINFORCED CHAMBER HOUSING AND LARGER (1/2") MOUNTING STUDS.
THE PARKING BRAKE LEVER MAY NOT TRAVEL FAR ENOUGH OVER CENTER TO ASSURE THAT IT REMAINS IN THE PROPER POSITION ALLOWING THE VEHICLE TO ROLL AWAY WHILE PARKED. Remedy: DEALERS WILL REMOVE AND REPLACE THE PARKING BRAKE LEVER WITH A LEVER THAT REQUIRES A 25 LB. EFFORT TO RELEASE.
VEHICLE DESCRIPTION: VANS AND TRUCKS EQUIPPED WITH AN OPTIONAL AUTOMATIC TRANSMISSION SHIFT LEVER THAT INCLUDES A PARK BRAKE POSITION. THE TRANSMISSION SHIFTER/PARK BRAKE LEVER CAN BIND BEFORE FULLY ENGAGING IN THE PARK BRAKE POSITION CAUSING A FALSE PARK CONDITION. Remedy: DEALERS WILL INSTALL A SPACER PLATE IN THE SHIFTER AND INSPECT FOR THE PRESENCE OF AN "E" CLIP THAT DETAINS THE DETENT PIN.
AIR SYSTEM BLOCKAGE IN THE AIR DRYER OCCURS DEGRADING THE MOISTURE REMOVING CAPABILITIES OF THE DRYER WHEN THE VEHICLE IS OPERATED IN A COLD ENVIRONMENT AND MOISTURE ACCUMULATES AND FREEZES IN THE AIR DRYER OR IN THE LINE BETWEEN THE DRYER AND THE AIR SYSTEM RESERVOIR. THE AIR DRYER CAN BECOME OVER PRESSURIZED CAUSING THE AIR DRYER CARTRIDGE TO SEPARATE FROM THE MOUNTING BASE. Remedy: DEALERS WILL EQUIP AIR SYSTEMS WITH A PRESSURE RELIEF VALVE TO BE LOCATED BETWEEN THE COMPRESSOR AND THE AIR DRYER. THIS PRESSURE RELIEF VALVE IS INTENDED TO VENT IF EXCESSIVE PRESSURE DEVELOPS IN THE AIR DRYER.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
DEFECT: THE MECHANICAL PARKING BRAKE LEVER MAY NOT TRAVEL FAR ENOUGH OVER CENTER TO ASSURE THAT IT REMAINS IN THE APPLIED POSITION. IF THE VEHICLE WAS JARRED THE BRAKE LEVER COULD RELEASE, RESULTING IN A POSSIBLE ROLLAWAY. CORRECTION: REMOVE AND REPLACE THE PARKING BRAKE LEVER WITH A BRAKE LEVER THAT HAS 10 DEGREES OVER CENTER TRAVEL AND REQUIRES A 25 LB. EFFORT TO RELEASE.
NOTE: VEHICLES EQUIPPED WITH ROCKWELL WABCO SYSTEM SAVER 1000 AIR DRYERS. IN AIR BRAKE SYSTEMS REQUIRING A LARGE VOLUME OF AIR TO PASS THROUGH THE DRYER IN A SHORT PERIOD OF TIME, THE DRYER CANNOT REMOVE ALL OF THE MOISTURE FROM THE AIR. IN A COLD ENVIRONMENT THIS MOISTURE MAY FREEZE AND EFFECTIVELY BLOCK THE AIR LINES DOWNSTREAM OF THE DRYER RESULTING IN AN AIR PRESSURE BUILD UP IN THE DRYER. THIS AIR PRESSURE MAY EVENTUALLY CAUSE THE DRYER CARTRIDGE TO SEPARATE FROM THE DRYER. THE SEPARATED CARTRIDGE MAY CAUSE BODILY INJURY TO ANYONE STANDING NEAR THE DRYER AT THE INSTANT OF SEPARATION. CORRECTION: PRESSURE RELIEF VALVES WILL BE INSTALLED IN THE DRYER OUTLET PORTS ON THE AFFECTED VEHICLES.
THESE VEHICLES ARE EQUIPPED WITH 12" AND 16" FRONT BRAKE CHAMBERS MOUNTED ON ROCKWELL FOUNDATION BRAKES. THE BRAKE CHAMBER MOUNTING STUDS MAY LOOSEN OR PULL THROUGH DUE TO FATIGUE IN THE BRAKE CHAMBER HOUSING CAUSED BY FOUNDATION BRAKE CHATTER. CORRECTION: BRAKE LINING MATERIALS WILL BE CHANGED. THE WING BRACKET WILL BE REPLACED WITH A REINFORCED BRACKET AND BRAKE CHAMBERS WITH REINFORCED CHAMBER HOUSINGS AND LARGER MOUNTING STUDS WILL BE INSTALLED.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain