Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1995 International Harvester 3800, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
THE FRONT WHEEL HUB CAN DEVELOP CRACKS AT THE WHEEL MOUNTING STUDS. WHEN MOUNTED TO THE HUB, THE HYDRAULIC BRAKE DISC ROTOR DOES NOT PROPERLY SUPPORT THE HUB AT THE WHEEL STUDS CAUSING EXCESSIVE STRESS AND FATIGUE CRACKS IN THE HUB. Remedy: DEALERS WILL INSTALL NEW, REDESIGNED HUBS ON THESE VEHICLES.
FOUR COMPRESSION BACKPLATE RETAINING FASTENERS ON THE TURBO-CHARGER WERE TORQUED ONLY HAND TIGHT. THIS ALLOWS THE FASTENERS TO LOOSEN, AND CAUSES OIL TO LEAK INTO THE COMPRESSOR AIR SIDE OF THE TURBO-CHARGER WHICH, WHEN COUPLED WITH THE HEAT PRECIPITATED BY THE COMPRESSOR AND THE MIXING ACTION OF THE COMPRESSOR WHEEL, CAN RESULT IN AN AIR/OIL MIXTURE THAT FUELS THE ENGINE. Remedy: REPLACE THE SUSPECT TURBO-CHARGER WITH A NEW TURBO-CHARGER.
THESE BUSES WERE BUILT WITH AN ADDITIONAL 3/4 INCH THICK PLYWOOD FLOOR AND EXTRA THICK FLOOR MATS FOR INCREASED INSULATION DURING COLD WEATHER. THE BOTTOM EDGE OF THE ACCELERATOR PEDAL, WHEN DEPRESSED, CAN COME IN CONTACT WITH THE HEAD OF A BOLT SECURING THE TRANSMISSION COVER TO THE FLOOR. THE ENGINE THROTTLE MAY NOT RETURN TO THE IDLE POSITION. Remedy: DEALERS WILL REMOVE 1/2 INCH FROM THE BOTTOM OF THE ACCELERATOR PEDAL.
THE WIRING FROM THE ELECTRONIC CONTROL UNIT WAS CONNECTED TO THE WRONG WHEEL SENSOR OR TO THE WRONG BRAKE MODULATOR VALVE. IT IS POSSIBLE THAT EITHER OR BOTH WIRING MAY HAVE OCCURRED AT EITHER THE FRONT OR REAR AXLE OR BOTH AXLES. Remedy: DEALERS WILL INSPECT THE ABS WIRING AND, IF NECESSARY, PROPERLY CONNECT.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain