Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1995 Mercury Mystique, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
FEDERAL MOGUL IS RECALLING 6,903 AFTERMARKET BALL JOINT ASSEMBLIES SHIPPED BETWEEN NOVEMBER 9, 2007 AND MARCH 26, 2008, WHICH MAY HAVE BEEN PACKAGED WITH INCORRECT NUTS. THE PART NUMBERS PACKAGED WITH INCORRECT NUTS ARE: K7147, K7329, K8683, AND 104353. THESE PARTS WERE MADE FOR USE ON THE VARIOUS VEHICLES LISTED ABOVE. Remedy: FEDERAL MOGUL WILL NOTIFY OWNERS AND REPLACE THE PARTS FREE OF CHARGE. THE RECALL BEGAN ON MAY 22, 2008. OWNERS CAN CONTACT FEDERAL MOGUL AT 877-489-6659.
CERTAIN AFTERMARKET BRAKE HYDRAULIC MASTER CYLINDERS SOLD AS REPLACEMENT BRAKE CYLINDERS FOR CERTAIN FORD, DAIMLERCHRYSLER, AND JEEP PASSENGER VEHICLES. THESE BRAKE CYLINDERS WERE SOLD UNDER THE BRAND NAMES OF NAPA, RAYBESTOS, AIMCO, AC DELCO, CARQUEST, BENDIX, AND WAGNER. ONLY PRODUCTS THAT WERE MANUFACTURED FROM JULY 27, 2005 THROUGH JANUARY 17, 2006 (DATE CODES 0529 THROUGH 0602) ARE SUBJECT TO THIS RECALL. WHEN SUBJECT TO VERY COLD TEMPERATURES, AN INTERNAL SEAL IN THE MASTER CYLINDER COULD LOSE FLEXIBILITY AND MAY CAUSE BRAKE FLUID TO LEAK. Remedy: AFFINIA (BRAKE PARTS, INC.) WILL REPLACE THE SUBJECT BRAKE HYDRAULIC MASTER CYLINDERS FREE OF CHARGE. THE RECALL BEGAN ON MARCH 20, 2006. OWNERS CAN CONTACT AFFINA GROUP CUSTOMER SERVICE AT 1-800-323-0354.
VEHICLE DESCRIPTION: 1995 PASSENGER VEHICLES EQUIPPED WITH THE 2.0L AND 2.5L ENGINES, AND 1996 VEHICLES EQUIPPED WITH 2.5L ENGINES. TIGHTENING OF THE ENGINE COOLING FAN MOTOR BEARINGS, UP TO AND INCLUDING MOTOR STALL, CAN RESULT IN INCREASED MOTOR TORQUE AND HIGHER THAN NORMAL MOTOR CURRENT AND ACCOMPANYING HIGH MOTOR TEMPERATURES. Remedy: DEALERS WILL INSTALL A POSITIVE TEMPERATURE COEFFICIENT DEVICE IN-LINE WITH EACH FAN MOTOR. FORD WILL ALSO EXTEND THE WARRANTY ON THE ENGINE COOLING FAN ASSEMBLY TO A TOTAL OF 8 YEARS OF SERVICE OR 100,000 MILES FROM THE WARRANTY START DATE, WHICHEVER OCCURS FIRST. IF THE VEHICLE ALREADY HAS MORE THAN 100,000 MILES, THIS COVERAGE WILL LAST UNTIL JULY 31, 2001.
THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: 1995-1997 FORD CONTOUR AND MERCURY MYSTIQUE VEHICLES. THE HEATER BLOWER RESISTOR COULD OVERHEAT CAUSING THE ATTACHED ELECTRICAL CONNECTOR TO MELT. Remedy: FORD WILL PROVIDE ADDITIONAL WARRANTY COVERAGE FOR THE HEATER BLOWER SWITCH FOR 10 YEARS FROM ORIGINAL DATE OF SALE OF THE VEHICLE OR 150,000 MILES, WHICHEVER COMES FIRST. DEALERS WILL INSTALL A NEW HEATER BLOWER RESISTOR AND A NEW WIRE JUMPER HARNESS FREE OF CHARGE.
THE PASSENGER SIDE AIR BAG HAS AN INFLATOR BODY THAT CRACKED DURING FORMING OF THE CURL THAT RETAINS THE IGNITER PLUG IN THE END OF THE INFLATOR. ALSO THE IGNITER END CAP CAN SEPARATE FROM THE INFLATOR. Remedy: DEALERS WILL REMOVE AND REPLACE THE PASSENGER SIDE AIR BAG MODULE.
THE FUEL TANK FILLER PIPE OPENING REINFORCEMENT, CONSTRUCTED FROM TWO SEPARATELY MOLDED PIECES, CAN LEAK AT THE WELD. Remedy: DEALERS WILL REPLACE THE FUEL TANK ASSEMBLIES WITH UNITS CONTAINING ONE-PIECE MOLDED REINFORCEMENTS.
CRACKS HAVE BEEN FOUND IN THE FRONT SAFETY BELT OUTBOARD ANCHOR TABS DUE TO A COMBINATION OF HYDROGEN EMBRITTLEMENT OF THE TAB AND STRESS INTRODUCED DURING ATTACHMENT OF THE ANCHOR TAB TO THE SEAT FRAME. THIS DOES NOT CONFORM WITH THE REQUIREMENTS OF FMVSS NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." Remedy: DEALERS WILL INSPECT AND INSTALL AN ANCHOR TAB REINFORCEMENT OR REPLACEMENT OF THE COMPLETE FRONT SEAT BELT ASSEMBLY IF AN ANCHOR TAB IS FOUND TO HAVE FRACTURED.
A METAL SHIELD ON THE OUTSIDE OF THE PLASTIC FUEL FILLER PIPE CAN DEVELOP A STATIC ELECTRICAL CHARGE DURING REFUELING OF THE VEHICLE. Remedy: DEALERS WILL INSPECT AND, IF NECESSARY, MODIFY THE VEHICLES BY ADDING A GROUND STRAP BETWEEN THE FILLER PIPE SHIELD AND THE BODY.
THE FUEL TANK FILLER PIPE OPENING REINFORCEMENT CAN LEAK AT THE WELD. Remedy: DEALERS WILL INSPECT AND, AS APPROPRIATE, REPLACE THE FUEL TANKS.
VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH THE TRACTION CONTROL OPTION. THE THROTTLE CABLES WERE DAMAGED DURING VEHICLE ASSEMBLY LEADING TO FRAYING OR SEPARATION OF THE THROTTLE CABLE. Remedy: DEALERS WILL REPLACE THE THROTTLE CABLE WITH A REVISED DESIGN THAT IS LESS SUSCEPTIBLE TO BENDING OR KINKING DURING INSTALLATION.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FLOOR SHIFT AUTOMATIC TRANSMISSION CONTROL CAN BE DAMAGED IF SUBJECTED TO CERTAIN INTERIOR CLEANING PRODUCTS. THE GEAR POSITION INDICATOR CAN DETERIORATE AND NOT CORRECTLY INDICATE THE ACTUAL GEAR POSITION. Remedy: DEALERS WILL REPLACE THE AUTOMATIC TRANSMISSION FLOOR SHIFT CONTROL.
THE GLASS TEMPERING PROCESS ON THE RIGHT HAND REAR DOOR WINDOWS WAS NOT CORRECTLY PERFORMED. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 205, "GLAZING MATERIALS." Remedy: DEALERS WILL REPLACE THE RIGHT REAR DOOR GLASS.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles equipped with 2.5 litre V6 engines, tightening of the engine cooling fan motor bearings, up to and including motor stall, can result in increased motor torque and higher than normal motor current and accompanying high motor temperatures. Overheating of the cooling fan motor due to excessive current can result in smoke and odors from bearing grease, insulation and other internal motor components. If electrical current continues to be applied to the motor, internal motor components could ignite possibly igniting other engine compartment components. Correction: Dealers will install a Positive Temperature Coefficient device (a solid state resettable fuse-like device) in-line with each fan motor.
On certain vehicles, the floor shift automatic transmission control may be damaged if subjected to certain vehicle interior cleaning products. If exposed to these products, the transmission gear position indicator may deteriorate and not correctly indicate the actual gear position. If this occurs, the shifter will continue to operate normally, but there is the potential for incorrect gear selection. Correction: Automatic transmission floor shift control will be replaced.
NOTE: VEHICLES EQUIPPED WITH 2.5 LITRE ENGINES. THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. PREMATURE FAILURE OF THE CATALYST SUBSTRATE MATERIAL IN THE CATALYST AND EXHAUST MANIFOLD ASSEMBLIES (LIGHT-OFF CATALYSTS) CAN RESULT IN RESTRICTED EXHAUST GAS FLOW, LOSS OF POWER AND EXHAUST EMISSION LEVELS IN EXCESS OF THOSE SPECIFIED IN THE STANDARD. CORRECTION: LEFT AND RIGHT HAND LIGHT-OFF CATALYSTS WILL BE REPLACED. UNDERBODY CATALYST WILL BE INSPECTED AND REPLACED IF NECESSARY.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
NOTE: ONLY VEHICLES EQUIPPED WITH THE TRACTION CONTROL OPTION ARE INVOLVED. THE THROTTLE CABLES ON THESE VEHICLES MAY HAVE BEEN DAMAGED DURING VEHICLE ASSEMBLY. THIS MAY LEAD TO FRAYING OR SEPARATION OF THE THROTTLE CABLE, WHICH COULD PREVENT THE ENGINE FROM RETURNING TO IDLE. THIS COULD ADVERSELY AFFECT VEHICLE CONTROL. CORRECTION: THROTTLE CABLE WILL BE REPLACED WITH A REVISED DESIGN VERSION.
THE FUEL TANK FILLER PIPE OPENING REINFORCEMENT, FABRICATED FROM TWO SEPARATELY MOULDED PIECES SPIN WELDED TOGETHER, MAY EVENTUALLY LEAK FUEL AT THE WELD JOINT. FUEL LEAKAGE IN THE PRESENCE OF AN IGNITION SOURCE, COULD POTENTIALLY RESULT IN A FIRE. CORRECTION: FUEL TANK ASSEMBLIES WILL BE REPLACED WITH ONES CONTAINING ONE PIECE MOULDED REINFORCEMENTS.
THESE VEHICLES MAY NOT COMPLY WITH THE REQUIREMENTS OF C.M.V.S.S 210 - SEAT BELT ASSEMBLY ANCHORAGES. THE HARDWARE THAT ATTACHES THE OUTBOARD ENDS OF THE FRONT SAFETY BELTS TO THE FRONT SEAT FRAMES MAY BE CRACKED OR FRACTURED. IF SO. THE LOAD THAT THE SAFETY BELT COULD SUSTAIN WOULD BE BELOW THAT SPECIFIED BY THE STANDARD. CORRECTION: REINFORCEMENT PLATES WILL BE INSTALLED TO THE ATTACHMENT HARDWARE OF BOTH OUTBOARD FRONT SAFETY BELTS. IF THE ATTACHMENT HARDWARE IS FRACTURED, A NEW SAFETY BELT WILL BE INSTALLED.
DEFECT: THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. CORRECTION: POWERTRAIN CONTROL MODULE WILL BE REPLACED ON AFFECTED VEHICLES.
THE PASSENGER SIDE SUPPLEMENTAL RESTRAINT SYSTEM (AIR BAG) MAY HAVE A CRACKED INFLATOR BODY. IF THE VEHICLE IS INVOLVED IN A DEPLOYMENT LEVEL CRASH, THE PASSENGER SIDE AIR BAG MAY NOT INFLATE PROPERLY WHICH COULD RESULT IN REDUCED OCCUPANT PROTECTION. IN ADDITION, THE IGNITER PLUG COULD SEPARATE FROM THE INFLATOR, WHICH COULD RESULT IN THE RELEASE OF HOT GASES AND COULD IGNITE FLAMMABLE MATERIAL OR POTENTIALLY CAUSE PERSONAL INJURY. CORRECTION: VEHICLES WILL BE INSPECTED AND A NEW PASSENGER SIDE AIR BAG MODULE WILL BE INSTALLED IF NECESSARY.
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 205 - GLAZING MATERIALS. IMPROPERLY TEMPERED GLASS WAS INSTALLED IN THE RIGHT HAND REAR DOOR. CORRECTION: RIGHT HAND REAR DOOR GLASS WILL BE REPLACED ON AFFECTED VEHICLES.
THE FUEL FILLER OPENING REINFORCEMENT (AN INTEGRAL PART OF THE FUEL TANK ASSEMBLY) MAY LEAK FUEL. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD RESULT. CORRECTION: FUEL TANK WILL BE REPLACED ON AFFECTED VEHICLES.