1995 Volvo 850

Recalls, inspection results and owner complaints for the 1995 Volvo 850, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.

Recalls (US model-wide)

We checked recall campaigns for this vehicle, or for its model where the register works by model.

Source: NHTSA (US Department of Transportation) · US public domain

What we found

2004-07-30Recall 04V368000: FUEL SYSTEM, GASOLINE:STORAGE
Details
ON CERTAIN PASSENGER VEHICLES, AFTER PROLONGED EXPOSURE TO HEAT, THE FUEL TANK MAY SEEP OR LEAK FUEL AT THE POINTS WHERE THE HEAT SHIELD IS ATTACHED. Remedy: VOLVO WILL INSPECT THE FUEL TANK AND REPLACE IT IF ANY EVIDENCE OF FUEL SEEPAGE OR LEAKAGE IS FOUND. ALL VEHICLES WILL RECEIVE NEW REINFORCEMENT BUSHINGS AT THE HEAT SHIELD ATTACHMENT POINTS TO PREVENT FUTURE LEAKS. THIS RECALL WILL BE CONDUCTED AS A SAFETY RECALL IN THE HOT WEATHER STATES OF ALABAMA, ARKANSAS, ARIZONA, CALIFORNIA, FLORIDA, GEORGIA, HAWAII, LOUISIANA, MISSISSIPPI, NEVADA, NEW MEXICO, NORTH CAROLINA, OKLAHOMA, SOUTH CAROLINA, TENNESSEE, TEXAS, AND UTAH, AND AS A SERVICE RECALL IN THE OTHER 33 STATES AND THE DISTRICT OF COLUMBIA. THE RECALL BEGAN ON SEPTEMBER 24, 2004. OWNERS MAY CONTACT VOLVO AT 1-800-458-1552.
1995-03-10Recall 95V050000: EQUIPMENT:MECHANICAL:ACCESSORY SCISSOR/SCREW/BOTTLE JACK/LIFT
SOME OF THE JACKS SUPPLIED WITH THE VEHICLES DO NOT HAVE THE NECESSARY LOAD CAPACITY. Remedy: DEALERS WILL INSPECT AND REPLACE SUSPECT JACKS WITH A JACK MEETING THE LOAD REQUIREMENTS FOR THESE CARS.
1996-08-20Recall 96E025000: ENGINE AND ENGINE COOLING:ENGINE:GASOLINE
Details
ENGINE BLOCK HEATERS INSTALLED AS ACCESSORIES. THE BLOCK HEATER CONTACT SURFACE DOES NOT MATCH CORRECTLY WITH THE ENGINE BLOCK AS INTENDED. THE BLOCK HEATER COULD COME LOOSE FROM THE ENGINE BLOCK, AND IF BEING USED, COULD POSSIBLY OVERHEAT CAUSING DAMAGE IF IT COMES IN CONTACT WITH OTHER ENGINE COMPARTMENT COMPONENTS. Remedy: DEALERS WILL INSPECT THE BLOCK HEATER AND SECURE THE BOLTS USED TO INSTALL THE HEATER. IN SOME CASES, THE SURFACE TOLERANCES MAY BE SO INAPPROPRIATE THAT THE HEATER WOULD NEED TO BE REPLACED WITH A HEATER OF A MODIFIED DESIGN.