Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1996 International Harvester 3800, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
VEHICLE DESCRIPTION: SCHOOL BUSES EQUIPPED WITH THE INTERNATIONAL I6 ELECTRONIC ENGINE AND AN EXTRA THICK BUS BODY FLOOR. THE ACCELERATOR PEDAL TO FLOOR CLEARANCE IS APPROXIMATELY 1.2 INCHES WITH A STANDARD BUS BODY FLOOR. HOWEVER, SOME CUSTOMERS ORDERED AN ADDITIONAL 3/4 INCH THICK FLOOR AND EXTRA THICK FLOOR MATS TO SERVE AS INSULATION IN COLD CLIMATES. WHEN THIS EXTRA FLOORING IS USED, THE BOTTOM EDGE OF THE ACCELERATOR PEDAL, WHEN DEPRESSED, CAN COME IN CONTACT WITH THE FLOOR. Remedy: DEALERS WILL INSPECT THE FLOORING ON THESE BUSES TO INSURE THERE IS A MINIMUM OF 1/4 INCH CLEARANCE. ON BUSES WITH LESS THAN 1/4 INCH CLEARANCE, THE DEALER WILL REMOVE THE PEDAL AND CUT OFF THE BOTTOM OF THE PAD TO OBTAIN THE PROPER CLEARANCE.
THE FRONT WHEEL HUB CAN DEVELOP CRACKS AT THE WHEEL MOUNTING STUDS. WHEN MOUNTED TO THE HUB, THE HYDRAULIC BRAKE DISC ROTOR DOES NOT PROPERLY SUPPORT THE HUB AT THE WHEEL STUDS CAUSING EXCESSIVE STRESS AND FATIGUE CRACKS IN THE HUB. Remedy: DEALERS WILL INSTALL NEW, REDESIGNED HUBS ON THESE VEHICLES.
THE WIRING FROM THE ELECTRONIC CONTROL UNIT WAS CONNECTED TO THE WRONG WHEEL SENSOR OR TO THE WRONG BRAKE MODULATOR VALVE. IT IS POSSIBLE THAT EITHER OR BOTH WIRING MAY HAVE OCCURRED AT EITHER THE FRONT OR REAR AXLE OR BOTH AXLES. Remedy: DEALERS WILL INSPECT THE ABS WIRING AND, IF NECESSARY, PROPERLY CONNECT.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain