Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1996 International Harvester 9200, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AIR BRAKE HALDEX AUTOMATIC SLACK ADJUSTERS, LONG STROKE BRAKE CHAMBERS, AND DANA BRAKES. THE AUTOMATIC SLACK ADJUSTER ANCHOR BRACKETS CAN FAIL DUE TO FATIGUE FRACTURE AND COMPLETELY SEPARATE, CAUSING THE SLACK ADJUSTERS TO FUNCTION AS MANUAL SLACK ADJUSTERS. Remedy: DEALERS WILL INSTALL A NEW BRACKET ON EACH SUSPECT SLACK ADJUSTER. OWNER NOTIFICATION BEGAN FEBRUARY 22, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT INTERNATIONAL AT 1-800-448-7825.
ON CERTAIN CONVENTIONAL TRUCKS EQUIPPED WITH PRO-SLEEPER BERTHS, WATER INTRUSION CAN BE FOUND IN THE BUNK CONTROL PANEL AREA AND POOL IN THE TOPS OF THE DOME LIGHT, TV/VCR, AND OR REFRIGERATOR POWER SWITCHES. Remedy: DEALERS WILL INSTALL A WATER SHIELD OVER THE BACK OF THE ENTIRE BUNK CONTROL PANEL. OWNER NOTIFICATION BEGAN ON JULY 16, 2004. OWNERS SHOULD CONTACT INTERNATIONAL AT 1-800-448-7825.
THE EQUALIZING BEAM SHAFT OF THE TANDEM AXLE SUSPENSION WERE MANUFACTURED FROM AS-ROLLED SAE4140 STEEL RATHER THAN THE SPECIFIED ANNEALED SAE4140. THESE SHAFTS CAN FRACTURE INSIDE THE BEAM AT THE TOE OF THE WELD. Remedy: OWNER NOTIFICATION IS BEING CONDUCTED BY NEWAY ANCHORLOK. DEALERS WILL INSPECT AND REPLACE ALL SUSPENSION SUSPENSION BEAMS WITH SUSPENSION BEAMS CONTAINING APPROPRIATE SHAFTS.
THE DRIVELINE COULD HAVE LITTLE TORQUE OR NO TORQUE ON THE DRIVELINE NUT THAT RETAINS THE YOKE AT THE CENTER BEARING OR BEARINGS IF THE VEHICLE IS EQUIPPED WITH MULTIPLE CENTER BEARINGS. Remedy: DEALERS WILL DISCONNECT THE DRIVELINE AT THE REAR OF THE CENTER BEARING(S), TORQUE THE YOKE NUT AND RECONNECT THE DRIVELINE.
STRAPS HOLDING THE SLEEPER UPPER BUNK IN THE RAISED POSITION CAN RELEASE WITHOUT WARNING. Remedy: DEALERS WILL MODIFY THE ATTACHMENT OF THE UPPER BUNK RESTRAINING STRAP TO THE UPPER BUNK AND REAR WALL OF THE SLEEPER AND INSTALL A NEW REDESIGNED BUNK RESTRAINING STRAP.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain