Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1996 Pontiac Sunfire, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
DORMAN PRODUCTS IS RECALLING 3,900 INTERMEDIATE STEERING SHAFTS DORMAN PART NOS. 425-151, 425-152, AND 425-153, (SOLD UNDER DORMAN'S "OE SOLUTIONS" BRAND NAME), BALKAMP #'S 7-3057, 7-3058, 7-3059 (SOLD UNDER THE "NAPA" BRAND NAME), AND PLATINUM PARTS #'S 2425151, 2425152, AND 2425153 MANUFACTURED DURING THE MONTH OF SEPTEMBER 2007. THESE REPLACEMENT STEERING SHAFTS CAN BE USED ON THE VEHICLES LISTED ABOVE. THE WELD CONNECTING THE INNER TUBE TO THE OUTER TUBE MAY BE DEFECTIVE. Remedy: DORMAN WILL NOTIFY OWNERS AND REPLACE THE STEERING SHAFTS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 16, 2008. OWNERS MAY CONTACT DORMAN TOLL FREE AT 1-800-523-2492.
ON CERTAIN PASSENGER VEHICLES. IF THE ENGINE FAILS TO START AND THE DRIVER HOLDS THE KEY IN THE "START" POSITION FOR AN EXTENDED PERIOD, HIGH CURRENT FLOWS THROUGH THE IGNITION SWITCH, AND SOMETIMES PRODUCES ENOUGH HEAT TO MELT INTERNAL SWITCH PARTS. Remedy: DEALERS WILL INSTALL A RELAY KIT IN THESE VEHICLES TO PREVENT HIGH CURRENT FROM FLOWING THROUGH THE IGNITION SWITCH. OWNER NOTIFICATION BEGAN MARCH 27, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CHEVROLET AT 1-800-222-1020, PONTIAC AT 1-800-762-2737, BUICK AT 1-800-521-7300, OR OLDSMOBILE AT 1-800-442-6537.
CERTAIN DELPHI AFTERMARKET FUEL PUMP MODULES / MODULE RESERVOIR ASSEMBLIES (MRA) THAT WERE SOLD FOR USE ON THE ABOVE LISTED VEHICLES. DURING PRODUCTION THE MRAS VENT AND FUEL RETURN TUBES WERE REVERSED. THIS CONDITION CAN RESULT IN THE VEHICLE NOT RUNNING CORRECTLY (IDLE ROUGH AND/OR STALL) DUE TO AN OVERLY RICH FUEL BLEND OR THE VEHICLE'S EVAPORATIVE EMISSION CARBON CANISTER MAY LEAK FUEL. Remedy: DELPHI WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE MRAS FREE OF CHARGE. THE RECALL BEGAN ON MARCH 20, 2007. OWNERS CAN CONTACT DELPHI AT 1-877-335-7443.
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT. Remedy: PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.
CERTAIN PASSENGER VEHICLES AND MINI VANS HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE AND SOME OTHER RETAINERS USED IN VEHICLES ASSEMBLED BETWEEN JANUARY 1, 1996 AND OCTOBER 31, 1997, COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE. Remedy: DEALERS WILL INSTALL A NEW LOWER PINION BEARING UNLESS INSPECT OF THE EXISTING BEARING INDICATES THAT REPLACEMENT OF THE GEAR ASSEMBLY IS NECESSARY. OWNER NOTIFICATION BEGAN JANUARY 24, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CHEVROLET AT 1-800-222-1020, PONTIAC AT 1-800-762-2737, OR OLDSMOBILE AT 1-800-442-6537.
THE FRONT AND/OR REAR HAZARD WARNING LAMPS (FOUR-WAY FLASHERS) DO NOT FLASH WHEN THE HAZARD SWITCH IS ACTIVATED. THIS FAILS TO COMPLY WITH FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." Remedy: DEALERS OR VEHICLE OWNERS WILL INSPECT FOR PROPER FUNCTION OF THE HAZARD WARNING LAMPS. IF NECESSARY, DEALERS WILL REPLACE THE HAZARD LAMP SWITCH.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. ONE OF THE REAR SUSPENSION TRAILING ARM BOLTS CAN FATIGUE AND BREAK. Remedy: DEALERS WILL REPLACE THE REAR SUSPENSION TRAILING ARM FASTENERS.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THESE VEHICLES WERE BUILT WITH THE POTENTIAL FOR THE INTERIOR LAMPS TO COME ON UNEXPECTEDLY WHILE THE VEHICLES ARE BEING DRIVEN. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 101, "CONTROLS AND DISPLAYS." Remedy: DEALERS WILL RUN A DIAGNOSTIC TEST ON THE LAMP CONTROL MODULE AND, IF NECESSARY, REPLACE IT.
THE ACCELERATOR CONTROL CABLE COULD HAVE BEEN KINKED DURING ASSEMBLY CAUSING HIGH ACCELERATOR PEDAL EFFORT, STICKING ACCELERATOR CONTROL CABLE, OR A BROKEN ACCELERATOR CONTROL CABLE. Remedy: DEALERS WILL REPLACE THE ACCELERATOR CONTROL CABLE ASSEMBLY.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. BECAUSE OF CERTAIN CALIBRATIONS IN THE AIR BAG'S SENSING AND DIAGNOSTIC MODULE, AN INADVERTENT AIR BAG DEPLOYMENT COULD OCCUR IN A LOW SPEED CRASH OR WHEN AN OBJECT STRIKES THE FLOOR PAN. Remedy: DEALERS WILL RECALIBRATE THE AIR BAG SENSING AND DIAGNOSTIC MODULE.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Certain vehicles, after being exposed to substantial amounts of water, may experience deployment of either the driver or passenger front airbag without a crash. The owner’s manual for these vehicles does not provide specific information about this situation. Inadvertent deployment of the driver and / or passenger front airbag in a non-accident (non-impact) situation may cause damage to the surrounding vehicle environment (windshield / instrument panel), and create expensive vehicle repair, including replacement of the airbag module(s) and the Sensing and Diagnostic Module (SDM). In some instances, inadvertent deployment could cause minor injuries to vehicle occupants. Correction: GM will notify the owners of these 1996 and 1997 vehicles of the potential affect of water accumulating in the vehicle interior on the function of the airbag system (as included in the owner's manuals of 1998 and later model years vehicles).
On certain vehicles, the lower pinion bearings retainer tabs were not crimped properly. These and some other retainers used in vehicles assembled between January 1, 1996 and October 31, 1997 may fail and permit the ball bearings to escape. If the problem were to occur, the driver would have to exert more effort to turn the steering wheel. Correction: Dealers are to inspect the condition of the lower bearing, and replace the lower pinion bearing or the rack and pinion steering gear assembly, if necessary.
On certain passenger vehicles if the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts. If the switch is damaged, a fire could occur in the steering column, even with the engine off and the key removed. Correction: Dealers will install a relay kit in these vehicles to prevent high current from flowing through the ignition switch.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
Note: Certain 1997-99 vehicles in Ontario, Quebec and the Atlantic provinces and 1995-99 vehicles in all other provinces and territories. Moisture may enter the Powertrain Control Module (PCM) as a result of corrosion after extended exposure to road salt. This can lead to symptoms including illumination of the "Check Engine" light or the engine running rough. If these symptoms are ignored the engine may stall and may not be able to be restarted. Correction: Dealers will seal the Powertrain Control Module (PCM) in a protective shield/cover assembly.
On certain vehicles located in Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland, Moisture entering the Powertrain Control Module (PCM) as a result of corrosion can cause illumination of the "Check Engine" light or cause the engine to run rough. If these symptoms are ignored, the engine may stall and may not be able to be restarted. Correction: Dealers will inspect, clean and/or replace the Powertrain Control Module (PCM), then seal the PCM in a protective shield/cover assembly.
Certain vehicles may have a condition which could result in one of the rear suspension trailing arm bolts breaking. If this were to occur while the vehicle was in motion, vehicle control would be affected and a crash could occur without prior warning. Correction: Dealers will replace the rear suspension trailing arm fasteners.
BECAUSE OF CERTAIN CALIBRATIONS IN THE AIR BAG'S COMPUTER, THERE IS AN INCREASED RISK OF AN AIR BAG DEPLOYMENT IN A LOW SPEED CRASH OR WHEN AN OBJECT STRIKES THE FLOOR PAN. CORRECTION: THE SDM MODULE WILL BE RECALIBRATED TO REDUCE THE SENSITIVITY TO SHORT AND MID-DURATION COMMANDED DEPLOYMENTS.
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 101 - CONTROL LOCATION AND IDENTIFICATION. THE INTERIOR LAMPS MAY TURN ON BY THEMSELVES, FIVE TO THIRTY MINUTES AFTER THE VEHICLE IS STARTED AND CANNOT BE TURNED OFF BY THE SWITCH. THE LAMP CONTROL MODULE WILL TURN THEM OFF AFTER THIRTY MINUTES. IF THE INTERIOR LAMPS TURN ON WHILE THE VEHICLE IS BEING DRIVEN AT NIGHT, THE INCREASED GLARE COULD MAKE IT MORE DIFFICULT TO SEE OBJECTS OUTSIDE THE VEHICLE. CORRECTION: LAMP CONTROL MODULE WILL BE TESTED AND REPLACED IF NECESSARY.
THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 108 - LIGHTING EQUIPMENT. VEHICLES MAY EXHIBIT A CONDITION IN WHICH THE FRONT AND/OR REAR HAZARD WARNING LAMPS (FOUR-WAY FLASHERS) DO NOT FLASH WHEN THE HAZARD SWITCH IS ACTIVATED. CORRECTION: VEHICLES WILL BE INSPECTED AND HAZARD LAMP SWITCH REPLACED IF NECESSARY.
Certain vehicles may not comply with CMVSS 1105 - Evaporative Emissions. Fuel injectors may exhibit leakage of fuel vapour due to a stress of the plastic encapsulant. Correction: fuel injectors on affected vehicles will be inspected for involved date codes and replaced if necessary.
THE ACCELERATOR CONTROL CABLE MAY HAVE BEEN DAMAGED (KINKED) DURING VEHICLE ASSEMBLY. A KINKED ACCELERATOR CONTROL CABLE MAY RESULT IN HIGH PEDAL EFFORT, STICKING CABLE, OR BROKEN CABLE. IF THE ACCELERATOR CONTROL CABLE STICKS OR BREAKS, UNWANTED ACCELERATION AND/OR LOSS OF THROTTLE CONTROL MAY RESULT. IF THIS WERE TO OCCUR WHILE THE VEHICLE WAS IN MOTION, A CRASH COULD OCCUR WITHOUT PRIOR WARNING. CORRECTION: DEALERS WILL REPLACE THE ACCELERATOR CONTROL CABLE ASSEMBLY.