Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1997 Dodge Dakota, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.
SKF IS RECALLING 2,805 HUB UNITS, PART NO. BR930361, SOLD AS A SERVICE PART FOR 1997-2004 DODGE DAKOTA VEHICLES AND 1999-2003 DODGE DURANGO VEHICLES EQUIPPED WITH 2-WHEEL DRIVE & REAR AXLE ABS. DUE TO A SPECIFICATION ERROR, THE ROTOR PILOT FOR THE HUB UNIT MAY BE TOO LONG. THIS RESULTS IN THE WHEEL TO NOT BE SEATED FULLY AGAINST THE HUB FLANGE FACE DURING MOUNTING. Remedy: SKF WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE HUB UNITS FREE OF CHARGE. THE RECALL BEGAN ON NOVEMBER 5, 2008. OWNERS MAY CONTACT SKF VSM NORTH AMERICA CUSTOMER SERVICE AT 1-800-644-8999.
CERTAIN AFTERMARKET BRAKE HYDRAULIC MASTER CYLINDERS SOLD AS REPLACEMENT BRAKE CYLINDERS FOR CERTAIN FORD, DAIMLERCHRYSLER, AND JEEP PASSENGER VEHICLES. THESE BRAKE CYLINDERS WERE SOLD UNDER THE BRAND NAMES OF NAPA, RAYBESTOS, AIMCO, AC DELCO, CARQUEST, BENDIX, AND WAGNER. ONLY PRODUCTS THAT WERE MANUFACTURED FROM JULY 27, 2005 THROUGH JANUARY 17, 2006 (DATE CODES 0529 THROUGH 0602) ARE SUBJECT TO THIS RECALL. WHEN SUBJECT TO VERY COLD TEMPERATURES, AN INTERNAL SEAL IN THE MASTER CYLINDER COULD LOSE FLEXIBILITY AND MAY CAUSE BRAKE FLUID TO LEAK. Remedy: AFFINIA (BRAKE PARTS, INC.) WILL REPLACE THE SUBJECT BRAKE HYDRAULIC MASTER CYLINDERS FREE OF CHARGE. THE RECALL BEGAN ON MARCH 20, 2006. OWNERS CAN CONTACT AFFINA GROUP CUSTOMER SERVICE AT 1-800-323-0354.
VEHICLE DESCRIPTION: PICKUP TRUCKS WITH A 131 INCH WHEELBASE. SOME OF THESE VEHICLES MAY HAVE BEEN BUILT WITH INADEQUATE CLEARANCE BETWEEN THE FUEL LINE AND THE CAB UNDERBODY. Remedy: DEALERS WILL INSPECT THE VEHICLES FOR PROPER CLEARANCE. FUEL LINES THAT EXHIBIT INADEQUATE CLEARANCE WILL BE REPLACED WITH A REDESIGNED FUEL LINE THAT WILL ASSURE PROPER CLEARANCE.
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT. Remedy: PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.
CERTAIN AJ MOTORSPORT COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT. Remedy: AJ MOTORSPORT WILL NOTIFY OWNERS AND OFFER REIMBURSEMENT FOR THE LAMPS. THE RECALL BEGAN ON JULY 31, 2006. OWNERS MAY CONTACT AJ MOTORSPORT AT 626-618-2026.
CERTAIN REPLACEMENT K&N FUEL PERFORMANCE KITS, P/NOS. 57-1509, 57-1511, 57-1511-1, 57-1517, 57-1517-1, 57-1527, AND 57-1530. ALSO, A SMALL PERCENTAGE OF THESE KITS WERE SOLD UNDER THE MOPAR PERFORMANCE PARTS BRAND NAME (P/NOS. P5007069 AND P5007070). ALL KITS WERE MANUFACTURED FROM APRIL 20, 1999, THROUGH SEPTEMBER 23, 2004. THESE ASSEMBLIES WERE MANUFACTURED AS REPLACEMENT EQUIPMENT FOR CERTAIN DODGE PICKUP TRUCKS AND SUVS. A SMALL PIECE OF MATERIAL FROM THE TUBE WALL COULD BE SUCKED INTO THE ENGINE THROTTLE BODY, WHICH COULD CAUSE THE THROTTLE TO BECOME JAMMED IN THE OPEN POSITION. Remedy: K&N WILL PROVIDE OWNERS WITH A FREE REPAIR KIT ALONG WITH REPAIR INSTRUCTIONS. THE RECALL BEGAN ON APRIL 20, 2006.
VEHICLE DESCRIPTION: PICKUP TRUCKS. SOME VEHICLES MAY HAVE BEEN BUILT WITH INADEQUATE CLEARANCE BETWEEN THE REAR AXLE VENT HOSE AND THE BRAKE HOSE. Remedy: DEALERS WILL INSPECT THE REAR BRAKE HOSE FOR EVIDENCE OF WEAR. WORN BRAKE HOSES WILL BE REPLACED. THE REAR VENT HOSE WILL BE SHORTENED BY 3 INCHES AND A CLIP WILL BE INSTALLED TO ASSURE CLEARANCE BETWEEN THE AXLE VENT LINE AND BRAKE HOSE IS MAINTAINED.
VEHICLE DESCRIPTION: PICKUP TRUCKS BUILT WITH 2.5L ENGINES. SOME VEHICLES MAY HAVE BEEN BUILT WITH INADEQUATE CLEARANCE BETWEEN THE LEFT FRONT BRAKE TUBE AND THE POWER STEERING HOSE. Remedy: DEALERS WILL INSPECT THE BRAKE TUBE AND POWER STEERING HOSE FOR WEAR. IF WEAR IS EVIDENT, THE BRAKE TUBE AND/OR POWER STEERING HOSE WILL BE REPLACED. A POWER STEERING STANDOFF BRACKET WILL BE INSTALLED ON ALL VEHICLES TO ENSURE THAT ADEQUATE CLEARANCE BETWEEN THE BRAKE TUBE AND POWER STEERING HOSE IS MAINTAINED.
VEHICLE DESCRIPTION: PICKUP TRUCKS. SOUND DEADENER MATERIAL INSIDE THE STEERING WHEEL COULD BECOME DETACHED FROM THE COVER AND HOUSING. NOTE: THE RAM PICKUP TRUCKS WERE BUILT AT THE WARREN ASSEMBLY PLANT ("S" IN THE 11TH VIN POSITION) FROM MAY 16, 2000 THROUGH OCTOBER 23, 2000; ST. LOUIS NORTH ASSEMBLY PLANT ("J" IN THE 11TH VIN POSITION) FROM MAY 19, 2000 THROUGH OCTOBER 23, 2000; LAGO ALBERTO ASSEMBLY PLANT ("M" IN THE 11TH VIN POSITION) FROM MAY 23, 2000 THROUGH OCTOBER 23, 2000; AND SALTILLO ASSEMBLY PLANT ("G" IN THE 11TH VIN POSITION) FROM MAY 23, 2000 THROUGH OCTOBER 23, 2000. IMPORTANT: VEHICLES THAT HAVE ALREADY HAD THE PROPER CLOCKSPRING INSTALLED, ACCORDING TO WARRANTY RECORDS, HAVE BEEN EXCLUDED FROM THIS RECALL. IN ADDITION, 1997-2000 MODEL YEAR VEHICLES THAT HAVE HAD A SUSPECT REPLACEMENT CLOCKSPRING INSTALLED, ACCORDING TO WARRANTY RECORDS, HAVE BEEN ADDED TO THIS RECALL. Remedy: DEALERS WILL REPLACE THE CLOCKSPRING ASSEMBLY. OWNER NOTIFICATION BEGAN JUNE 18, 2001. ALSO SOME 1997-200 MODEL YEAR VEHICLES THAT, ACCORDING TO WARRANTY RECORDS, HAVE HAD A SUSPECT REPLACEMENT CLOCKSPRING INSTALLED, WILL ALSO BE INCLUDED IN THIS CAMPAIGN. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
THE ELECTRICAL CIRCUIT DESIGN ALLOWS THE POTENTIAL FOR AN INADVERTENT AIR BAG DEPLOYMENT UPON VEHICLE IGNITION SHUT DOWN. Remedy: DEALERS WILL REPLACE THE AIR BAG ELECTRONIC CONTROL MODULE WITH A NEWLY DESIGNED MODULE.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, the rear axle vent hose could contact the rear brake hose which eventually could wear a hole in the brake hose. Perforation of the rear brake hose will result in a loss of braking force at the rear wheels. Correction: Rear brake hoses will be inspected for evidence of wear. Worn brake hoses will be replaced. The rear axle vent hose will be shortened by 8 cm and a clip will be installed to assure the clearance between the axle vent line and the brake hose is maintained.
On certain vehicles with 131" wheel base, inadequate clearance between the fuel line and the cab underbody could eventually wear a hole in the fuel line resulting in loss of fuel. Leaking fuel, in the presence of an ignition source, could ignite and result in a vehicle fire. Correction: Vehicles will be inspected for proper fuel line clearance. Fuel lines with inadequate clearance will be replaced with a redesigned fuel line.
NOTE: VEHICLES WITH 3.9 LITRE ENGINE AND AUTOMATIC TRANSMISSION. THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 1101 - EMISSION DEVICE. VEHICLES WERE BUILT WITH AN INCORRECT UNDERHOOD EMISSION INFORMATION (VECI) LABEL. THE LABELS INCORRECTLY IDENTIFY THE VEHICLE AS CERTIFIED TO CALIFORNIA STANDARDS. CORRECTION: OWNERS WILL BE SUPPLIED WITH CORRECT LABELS AND INSTALLATION INSTRUCTIONS.
THE CIRCUIT DESIGN IN THE AIR BAG ELECTRONIC CONTROL MODULE MAY ALLOW THE POTENTIAL FOR INADVERTENT AIR BAG DEPLOYMENT UPON VEHICLE IGNITION SHUT DOWN. CORRECTION: THE AIR BAG ELECTRONIC CONTROL MODULE WILL BE REPLACED WITH A MODULE THAT INCORPORATES THE LATEST PRODUCTION REDESIGNED CIRCUIT TO PREVENT THIS CONDITION.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain