Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1997 Dodge RAM, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
K2 MOTOR IS RECALLING 1,921 AFTERMARKET HEADLAMPS OF VARIOUS MODELS SOLD FOR USE ON THE ABOVE LISTED VEHICLES. THESE HEADLAMPS ARE MISSING THE AMBER SIDE REFLEX REFLECTOR WHICH FAILS TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." Remedy: K2 MOTOR WILL NOTIFY OWNERS AND OFFER A FULL REFUND. THE RECALL BEGAN ON DECEMEBER 17, 2008. OWNERS MAY CONTACT K2 MOTOR AT 1-909-839-2992.
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.
CERTAIN AAI MOTORSPORTS COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LIST PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." Remedy: AAI MOTORSPORTS WILL NOTIFY OWNERS AND REPLACE THE LAMPS FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 1, 2006. OWNERS MAY CONTACT AAI MOTORSPORTS AT 909-923-9188.
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.
ON CERTAIN PICKUP TRUCKS EQUIPPED WITH DIESEL ENGINES ONLY, THE THROTTLE LINKAGE JOINTS CAN CORRODE AND CAUSE THE THROTTLE TO BIND OR STICK. Remedy: DEALERS WILL REPLACE THE ROD ENDS AND BALL STUDS. OWNER NOTIFICATION BEGAN JULY 29, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
ON CERTAIN PICKUP TRUCKS ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE FOLLOWING "SALT BELT" STATES: MAINE, NEW HAMPSHIRE, VERMONT, MASSACHUSETTS, RHODE ISLAND, CONNECTICUT, NEW YORK, NEW JERSEY, PENNSYLVANIA, DELAWARE, MARYLAND, THE DISTRICT OF COLUMBIA, WEST VIRGINIA, OHIO, INDIANA, MICHIGAN, ILLINOIS, WISCONSIN, MINNESOTA, IOWA, AND MISSOURI. CORROSION OF THE RETURN SPRING ON THE HOOD SECONDARY LATCH COULD CAUSE THE MECHANISM TO BIND IN THE "RELEASE POSITION." Remedy: DEALERS WILL REPLACE THE SECONDARY HOOD LATCH. OWNER NOTIFICATION BEGAN SEPTEMBER 17, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
VEHICLE DESCRIPTION: PICKUP TRUCKS. SOUND DEADENER MATERIAL INSIDE THE STEERING WHEEL COULD BECOME DETACHED FROM THE COVER AND HOUSING. NOTE: THE RAM PICKUP TRUCKS WERE BUILT AT THE WARREN ASSEMBLY PLANT ("S" IN THE 11TH VIN POSITION) FROM MAY 16, 2000 THROUGH OCTOBER 23, 2000; ST. LOUIS NORTH ASSEMBLY PLANT ("J" IN THE 11TH VIN POSITION) FROM MAY 19, 2000 THROUGH OCTOBER 23, 2000; LAGO ALBERTO ASSEMBLY PLANT ("M" IN THE 11TH VIN POSITION) FROM MAY 23, 2000 THROUGH OCTOBER 23, 2000; AND SALTILLO ASSEMBLY PLANT ("G" IN THE 11TH VIN POSITION) FROM MAY 23, 2000 THROUGH OCTOBER 23, 2000. IMPORTANT: VEHICLES THAT HAVE ALREADY HAD THE PROPER CLOCKSPRING INSTALLED, ACCORDING TO WARRANTY RECORDS, HAVE BEEN EXCLUDED FROM THIS RECALL. IN ADDITION, 1997-2000 MODEL YEAR VEHICLES THAT HAVE HAD A SUSPECT REPLACEMENT CLOCKSPRING INSTALLED, ACCORDING TO WARRANTY RECORDS, HAVE BEEN ADDED TO THIS RECALL. Remedy: DEALERS WILL REPLACE THE CLOCKSPRING ASSEMBLY. OWNER NOTIFICATION BEGAN JUNE 18, 2001. ALSO SOME 1997-200 MODEL YEAR VEHICLES THAT, ACCORDING TO WARRANTY RECORDS, HAVE HAD A SUSPECT REPLACEMENT CLOCKSPRING INSTALLED, WILL ALSO BE INCLUDED IN THIS CAMPAIGN. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
VEHICLE DESCRIPTION: PICKUP TRUCKS EQUIPPED WITH MANUAL TRANSMISSION, V10 ENGINES AND FOUR-WHEEL-DRIVE TRANSFER CASES. UNDER SUSTAINED MAXIMUM RATED VEHICLE LOAD, WHILE DRIVING UP A STEEP GRADE IN FOUR-WHEEL-DRIVE LOW RANGE IN HOT AMBIENT CONDITIONS, THE LOCAL EXHAUST TEMPERATURE PROXIMATE TO THE HYDRAULIC CLUTCH LINE CAN GENERATE LINE TEMPERATURES THAT EXCEED THE TEMPERATURE LIMIT OF THE CLUTCH LINE MATERIAL. IF THIS CONDITION OCCURS AND THE CLUTCH IS DEPRESSED, THE LINE COULD RUPTURE. Remedy: DEALERS WILL REPLACE THE HYDRAULIC CLUTCH ASSEMBLY.
VEHICLE DESCRIPTION: LIGHT DUTY TRUCKS EQUIPPED WITH DIESEL ENGINES. THE EXHAUST PIPE CONTACTS OR IS IN CLOSE PROXIMITY TO THE OUTER DASH PANEL SILENCER PAD. Remedy: DEALERS WILL REMOVE THE DASH SILENCER PAD ADJACENT TO THE EXHAUST PIPE AND REPLACE THIS PAD WITH A THERMAL HEAT SHIELD ON THE EXHAUST PIPE.
UNDER CERTAIN HIGH LOAD OPERATING CONDITIONS, THE TRANSMISSION FLUID TEMPERATURE CAN EXCEED THE MELTING POINT OF THE MATERIAL USED IN THE CONNECTOR TO RETAIN THE FLUID LINE TO THE TRANSMISSION. Remedy: DEALERS WILL REPLACE THE HIGH TEMPERATURE SIDE OF THE TRANSMISSION FLUID COOLER LINE CONNECTOR FITTINGS WITH CONNECTORS THAT INCORPORATE A STAINLESS STEEL RETAINER.
VEHICLE DESCRIPTION: VAN AND WAGON MODEL PASSENGER VEHICLES. IF WATER/ROAD SALT GETS ON THE INTERIOR FLOOR OF THE VEHICLE IN THE PROXIMITY OF THE AIR BAG ELECTRONIC CONTROL MODULE (AECM), THE AECM CAN CORRODE. THE RESULTING CORROSION CAN CAUSE THE DRIVER SIDE AIR BAG TO DEPLOY INADVERTENTLY. Remedy: DEALERS WIL REPLACE THE AECM WITH AN AECM THAT IS SEALED FROM MOISTURE INTRUSION.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain pickup trucks located in Ontario, Quebec and the Maritime provinces, corrosion of the hood secondary latch return spring may cause the hood secondary latch to become inoperative, possibly allowing the hood to open unexpectedly if the primary hood latch mechanism is not engaged. Such an occurrence could block driver vision and result in possible loss of control and a crash. Correction: A new secondary hood latch that incorporates a stainless steel spring will be installed on affected vehicles.
On certain 4 x 4 pickups equipped with an 8.0 litre V10 engine, Under certain heavy duty applications, such as driving up a steep grade in four wheel drive with a full load, the local exhaust temperature proximate to the hydraulic clutch line may generate line temperatures that exceed the temperature limit of the clutch line material. If this operating condition occurs and the clutch is depressed, the line may rupture and fluid may ignite on the hot exhaust potentially causing a vehicle fire. Correction: The hydraulic clutch line will be altered to prevent line melting due to exhaust system heat transfer.
On certain Ram 3500 vehicles, the headlamp switches used in this truck series operate under a high current load which results in switch internal temperatures above the 100 degree centigrade limit for the internal lubing grease. This heat will cause the grease to break down and increase the resistance in the switch resulting in eventual switch failure. Correction: Headlamp switches will be replaced and a relay will be included in the park lamp wiring circuit causing the headlamps or park lamps to go out.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
Certain Ram 3500 vehicles do not comply with CMVSS 1101 - emission device. The Vehicle emission warranty statement in the engine warranty manuals does not include the powertrain control module and the catalyst in the list of warranted emission control components. Correction: Owners will be sent a warranty manual insert with the correct information.
Certain vehicles may not comply with CMVSS 1103 - exhaust emissions. Improper calibration of the Powertrain Control Module may cause an increase in the levels of carbon monoxide (co) emissions to a level in excess of the Standard. Correction: Powertrain Control Module will be reprogrammed.
On certain vehicles, the exhaust pipe may be in contact or close proximity to the outer dash panel silencer pad. It is possible that the pipe can generate sufficient heat to cause the pad material to smolder and may ignite adjacent materials resulting in a vehicle fire. Correction: The outer dash silencer pad adjacent to the exhaust pipe will be removed and replaced by a thermal heat shield on the exhaust pipe.
On certain vehicles, the transmission fluid temperature could exceed the melting point of the connector which retains the fluid line to the transmission. Should this occur, the fluid line may become disconnected from the transmission and fluid may spray onto the exhaust manifold, possibly resulting in a fire. Correction: The connector fittings on the high temperature side of the transmission fluid cooler line will be replaced with connectors incorporating a stainless steel retainer.