Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1997 International Harvester 4700, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH BOSTROM DRIVER SEAT MODELS 910, 910SC, OR 914 AND INTERNATIONAL'S PARKING BRAKE CODE 04036, IF SOMEONE OUTSIDE THE CAB ADJUSTS/SLIDES THE DRIVER'S SEAT TO ITS MOST FORWARD POSITION, WITH THE PARKING BRAKE SET, THE SEAT WILL CONTACT AND RELEASE THE PARKING BRAKE LEVER. Remedy: DEALERS WILL INSTALL A STOP-BRACKET ON THE SEAT TRACK TO LIMIT THE TRAVEL OF THE SEAT SO THAT THE SEAT CANNOT RELEASE THE PARKING BRAKE LEVER. OWNER NOTIFICATION BEGAN ON MARCH 31, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT INTERNATIONAL AT 1-800-448-7825.
THE DRIVE AXLE HOUSINGS CONSIST OF A PLATE STEEL CENTER SECTION AND TWO FORGED SPINDLES, ONE OF WHICH IS WELDED TO EACH END OF THE CENTER SECTION. EACH SPINDLE CONTAINS A KEYWAY SLOT IN WHICH THE LOCKING TAB FOR THE WHEEL BEARING NUT LOCKING MECHANISM IS INSERTED. THE LENGTH OF THE KEYWAY SLOT MAY NOT BE LONG ENOUGH TO ACCOMMODATE THE TAB CAUSING THE TAB TO BE DEFORMED OR DAMAGED DURING INSTALLATION. Remedy: DEALERS WILL REPLACE THE DRIVE AXLE HOUSING NUTS WITH A CONVENTIONAL WHEEL NUT HARDWARE SYSTEM.
VEHICLE DESCRIPTION: SCHOOL BUSES AND HEAVY DUTY TRUCKS EQUIPPED WITH REAR AXLE ASSEMBLIES PRODUCED BY DANA SPICER. CERTAIN REAR AXLE ASSEMBLIES WERE IMPROPERLY HEAT TREATED WHICH COULD ALLOW PINION BREAKAGE AT THE PINION THREADS. Remedy: DEALERS WILL REPLACE THE REAR AXLE CARRIER/PINION ASSEMBLY.
THE STEERING COLUMN USED WAS INCORRECTLY MANUFACTURED. THE TUBE PORTION OF THE STEERING COLUMN HAS A WELDED END WITH A SPECIFIED LENGTH OF 5.5 INCHES. A 3.5 INCH WELDED END WAS USED BY MISTAKE. WITH THE SHORTER END, IT IS POSSIBLE THERE IS INSUFFICIENT ENGAGEMENT OF THE MALE END INTO THE TUBE PORTION AND SEPARATION OF THE COLUMN COULD OCCUR. Remedy: DEALERS WILL REPLACE THE INCORRECTLY BUILT STEERING COLUMN WITH A NEW CORRECTLY BUILT STEERING COLUMN.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain