Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1998 Chevrolet Monte Carlo, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
General Motors LLC (GM) is recalling certain model year 1998-1999 Chevrolet Lumina and Oldsmobile Intrigue, 1997-2004 Buick Regal and Pontiac Grand Prix, 2000-2004 Chevrolet Impala, and 1998-2004 Chevrolet Monte Carlo vehicles. The affected vehicles were previously repaired under recalls 08V-118, 09V-116, and 15V-201 to address the possibility that engine oil may drip onto the hot exhaust manifold. Remedy: The remedy applied under recalls 08V-118, 09V-116, and 15V-201 did not adequately remove the safety risk. Under the improved remedy, dealers will replace the engines front valve cover and gasket. Vehicles that are covered by recalls 08V-118, 09V-116, or 15V-201 that have not yet received the original remedy will instead receive the improved remedy under the original recall number. The recall began on February 19, 2016. Owners may contact Chevrolet customer service at 1-800-222-1020, Buick customer service at 1-800-521-7300, Oldsmobile customer service at 1-800-442-6537 and Pontiac customer service at 1-800-458-8006. GM's number for this recall is 15757. Note: Until the improved remedy has been applied, owners are advised to park their vehicle outside since the fire risk exists even when the vehicle is unattended.
GENERAL MOTORS IS RECALLING 1,497,516 MY 1997-2003 BUICK REGAL, MY 1998-2003 CHEVROLET LUMINA, MONTE CARLO AND IMPALA, MY 1998-1999 OLDSMOBILE INTRIGUE, MY 1997-2003 PONTIAC GRAND PRIX VEHICLES EQUIPPED WITH A 3.8L V6 NATURALLY ASPIRATED ENGINE. SOME OF THESE VEHICLES HAVE A CONDITION IN WHICH DROPS OF ENGINE OIL MAY BE DEPOSITED ON THE EXHAUST MANIFOLD THROUGH HARD BRAKING. Remedy: DEALERS WILL REPLACE THE ENGINES FRONT VALVE COVER AND FRONT-VALVE-COVER GASKET WITH NEW PARTS OF AN IMPROVED DESIGN AND REMOVE THE ENGINES PLASTIC COVER AND PLASTIC OIL-FILL-TUBE EXTENSION, FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN DURING MAY 2016. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438, OLDSMOBILE AT 1-800-630-6537, AND PONTIAC AT 1-800-620-7668 OR HTTP://WWW.PONTIAC.COM OR HTTP:WWW.GMOWNERCENTER.COM.
CERTAIN DELPHI FUEL PRESSURE REGULATORS, P/NOS. FP10020-11B1, FP10026-11B1, AND FP10027-11B1, SOLD AFTER JANUARY 9, 2007, AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE UNIVERSAL PRESSURE REGULATORS (UPR) WERE PRODUCED WITHOUT AN O'RING AND RETAINER. Remedy: DELPHI WILL NOTIFY OWNERS AND REPLACE THE UPR FREE OF CHARGE. THE RECALL BEGAN ON APRIL 23, 2007. OWNERS CAN CONTACT DELPHI AT 877-411-8770.
THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: 1995-1999 CHEVROLET MONTE CARLO Z34 PASSENGER VEHICLES. THE BRAKING PERFORMANCE IN WET WEATHER OR WET ROAD CONDITIONS IS REDUCED MORE THAN A DRIVER WOULD EXPECT. Remedy: DEALER WILL MODIFY THE FRONT FENDER LINERS TO REMOVE A PORTION OF THE CLOSEOUT PANELS IN THE FRONT WHEEL WELLS AT NO CHARGE TO THE CONSUMER. THIS SERVICE WILL BE AVAILABLE THROUGH AUGUST 2004.
CERTAIN PASSENGER VEHICLES HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE RETAINERS COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE. Remedy: DEALERS WILL INSTALL A NEW LOWER PINION BEARING UNLESS INSPECT OF THE EXISTING BEARING INDICATES THAT REPLACEMENT OF THE GEAR ASSEMBLY IS NECESSARY. OWNER NOTIFICATION BEGAN ON FEBRUARY 5, 2004. OWNERS SHOULD CONTACT BUICK AT 1-866-608-8080; CHEVROLET AT 1-800-630-2438; OLDSMOBILE AT 1-800-630-6537; OR PONTIAC AT 1-800-620-7668.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles equipped with a 3.8L engine, degradation of the front rocker cover gasket may result in eventual oil seepage. Under hard braking, drops of engine oil may be deposited on the exhaust manifold. If the manifold is hot enough and the oil runs below the heat shield, it may ignite into a small flame and, in some instances, the fire may spread to the plastic spark plug wire channel and beyond. An under-hood fire could result in injury and/or property damage. Correction: Dealers will replace the engine’s front valve cover and front-valve-cover gasket with new parts. The engine’s plastic “beauty” cover and plastic oil-fill-tube extension will also be removed, if they haven’t been already. Note: This recall supersedes and is an expansion of recalls 2008-081, 2009-105 and 2015-145. All vehicles having been inspected and/or serviced under the previous recall will require re-inspection and repair.
On certain vehicles equipped with a 3.8L naturally aspirated engine, degradation of the front rocker cover gasket may result in eventual oil seepage. Under hard braking, drops of engine oil may be deposited on the exhaust manifold. If the manifold is hot enough and the oil runs below the heat shield, it may ignite into a small flame and, in some instances, the fire may spread to the plastic spark plug wire channel and beyond. An under-hood fire could result in property damage, personal injury or death. Correction: Dealers will remove the spark plug wire retention channel at the front of the engine and install two new-revised spark plug wire retainers.
On certain vehicles, the lower pinion bearings retainer tabs were not crimped properly. These retainers may fail and permit the ball bearings to escape. If the problem were to occur, the driver would have to exert more effort to turn the steering wheel. Correction: Dealers are to inspect the condition of the lower bearing, and replace the lower pinion bearing or the rack and pinion steering gear assembly, if necessary. This is an extension of recall 02-199
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Certain vehicles do not comply with the requirements of CMVSS 1101 - Emission Device. Emission control labels have an incorrect vacuum hose routing schematic. Correction: Dealers will install a new vehicle emission control label on the radiator support.