Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1998 Chevrolet Tahoe, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE. Remedy: HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES. Remedy: HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.
VEHICLE DESCRIPTION: LIGHT DUTY EXTENDED-CAB PICKUP TRUCKS AND 4-DOOR UTILITY TRUCKS. THE LOWER STEERING SHAFT TO STEERING GEAR PINCH BOLT IS "FINGER LOOSE" OR MISSING ALLOWING THE BOLT TO LOOSEN AND FALL OUT. THE STEERING SHAFT YOKE CAN WEAR CAUSING AN OFF CENTER STEERING WHEEL. Remedy: DEALERS ARE ARRANGING TO HAVE THE VEHICLES INVOLVED TOWED TO THE DEALERSHIP AND ALTERNATE TRANSPORTATION IS BEING ARRANGED FOR OWNERS. DEALERS WILL THEN INSPECT THE VEHICLE FOR THE PRESENCE OF A PINCH BOLT AND TORQUE THIS BOLT TO PROPER SPECIFICATIONS.
VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND MULTI-PURPOSE PASSENGER VEHICLES. ONE OR BOTH FRONT BRAKE ROTOR/HUBS WERE BUILT WITH AN OUT-OF-SPECIFICATION GRAY IRON THAT CAN FAIL DURING THE LIFE OF THE VEHICLE. Remedy: DEALERS WILL INSPECT THE ROTORS FOR A CORE DATE OF "287" AND, IF FOUND, REPLACE THE ROTOR.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain C1500, TAhoe and Yukon vehicles, the rear brake front pipe may contact the the left front fender wheelhouse inner panel just above the chassis frame. This could eventually wear a hole in the brake pipe which would result in brake fluid loss and reduced braking effectiveness. Correction: Rear brake pipe positioning clip will be relocated, brake pipe will be inspected for wear and replaced if necessary.
On certain vehicles, the lower steering shaft to steering gear pinch bolt may be "finger loose" or missing. A "finger loose" bolt could continue to loosen and fall out. With the bolt missing, the steering shaft yoke could wear and jump spines on the steering gear shaft causing an off centre steering wheel. Relative movement between the chassis and cab could cause the steering shaft to separate from the steering gear resulting in loss of steering control. Correction: Dealers will inspect for the presence of a pinch bolt and ensure it is torqued to specification.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain