Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1998 GMC C Series, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, a short in the electric outside rearview mirror switch could develop. If this were to occur, it could result in an inoperative switch, heat damage to the driver's door, and/or ignition of components in the driver's door and a subsequent vehicle fire without prior warning. Correction: Dealer will install a fused jumper harness to the electric outside rearview mirror switch.
Certain vehicles equipped with auto-apply park brakes may exhibit an unintended brake apply at speed due to a solenoid coil failure or some may exhibit a failure to release and/or be slow to apply or release due to water contamination. Correction: Dealers will seal the joint between the park brake reservoir and the pump assembly with Room-Temperature-Vulcanizing (RTV) sealant or inspect and replace any 10 volt park solenoids with a 12 volt solenoid.
On certain C1500, TAhoe and Yukon vehicles, the rear brake front pipe may contact the the left front fender wheelhouse inner panel just above the chassis frame. This could eventually wear a hole in the brake pipe which would result in brake fluid loss and reduced braking effectiveness. Correction: Rear brake pipe positioning clip will be relocated, brake pipe will be inspected for wear and replaced if necessary.
On certain crew cab pick ups, the front inner corner of the fuel tank may contact the body sill and over time wear a hole in or crack the fuel tank at the point of contact. This condition could result in fuel leakage and in the presence of an ignition source, a fire could occur. Correction: Tank will be inspected for wear and a spacer will be installed between the fuel tank and the front crossmember, or if necessary, the fuel tank will be replaced.
Certain vehicles do not comply with CMVSS 1103 - Exhaust Emissions. Vehicles may been built with the ignition coil wire too close to metal brackets or the transmission fluid fill tube (M/L van only). If the coil wire is too close to these metal objects, arcing may occur and cause failure of the wires which can in turn lead to a stalling/no start condition and/or catalytic converter failures. Correction: coil wire will be repositioned to assure adequate clearance from metal brackets and/or transmission fluid fill tubes.
On certain vehicles, the lower steering shaft to steering gear pinch bolt may be "finger loose" or missing. A "finger loose" bolt could continue to loosen and fall out. With the bolt missing, the steering shaft yoke could wear and jump spines on the steering gear shaft causing an off centre steering wheel. Relative movement between the chassis and cab could cause the steering shaft to separate from the steering gear resulting in loss of steering control. Correction: Dealers will inspect for the presence of a pinch bolt and ensure it is torqued to specification.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain