Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1998 Volvo WG, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL. Remedy: DEALERS WILL REPLACE THE ABS ECU.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH HALDEX MANIFOLD DASH VALVES (MDV) USED IN TRACTOR AND TRAILER PARKING BRAKES. THESE VALVES DO NOT MEET THE REQUIREMENTS OF FMVSS NO. 121, "AIR BRAKE SYSTEMS." A LOSS OF THE ISOLATION OF THE TWO BRAKE SYSTEM CIRCUITS CAN RESULT IN THE LOSS OF SERVICE BRAKES WHEN THERE IS ANOTHER FAILURE OF ONE OF THE TWO BRAKE CIRCUITS. Remedy: DEALERS WILL REPLACE THE SUSPECT VALVES.
CERTAIN HEAVY DUTY CLASS 8 TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THE TWO TAIL LAMPS, BACK-UP LAMP,AND LICENSE TAG LAMP WERE MOUNTED ON INSUFFICIENTLY RIGID MOUNTS. Remedy: DEALERS WILL ATTACH THE TWO TAIL LAMPS, BACK-UP LAMP, AND THE LICENSE TAP LAMP ON STIFFER BRACKETS. OWNER NOTIFICATION BEGAN OCTOBER 31, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT VOLVO TRUCKS AT 1-800-528-6586.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AFTERMARKET ALUMINUM DUAL WHEELS, 22.5X8.25, ONE-PIECE, TUBELESS, SUPPLIED BY ACCURIDE/AKW. CERTAIN DESIGN REVISIONS COMBINED WITH PROCESS CONDITIONS CAUSED FATIGUE CRACKS IN THESE WHEELS. Remedy: ACCURIDE/AKW WILL REPLACE THESE WHEELS.
VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCKS. THE AIR SUSPENSION CONTROL VALVE SUPPLY LINE WAS NOT PLUMBED THROUGH AN AIR PRESSURE PROTECTION VALVE. IN THE EVENT OF A FAILURE, THERE WOULD BE LOSS OF AIR PRESSURE IN THE 'B' SYSTEM AIR RESERVOIR THAT SUPPLIES AIR PRESSURE FOR THE FRONT STEER AXLE BRAKES. Remedy: DEALERS WILL INSTALL THE NECESSARY AIR PRESSURE PROTECTION VALVE.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH A FAL 8.0 FRONT STEER AXLE. THE UPPER STEERING ARM CAN FAIL WITHOUT WARNING. Remedy: DEALERS WILL INSPECT THE UPPER STEERING ARM AND REPLACE IT, IF REQUIRED.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, the ABS ECU misinterprets certain signals from wheel ends which can result in the temporary loss of braking capability on one or more wheel positions for several seconds. This response results from either an ABS cable that has chafed through the insulation and contacted a rotating part or a misaligned tone ring that has been damaged by contacting other components. Correction: ABS ECU will be replaced with a new ECU with upgraded software capable of detecting and properly responding to erroneous signals.
On certain vehicles, the double check valve disc incorporated into the brake manifold dash valve can become brittle over time and crack. If this condition exists and there is a single point failure in either the primary or secondary air system, loss of all service braking could result without warning with the potential for a vehicle crash. Correction: Manifold dash valve will be replaced.
On certain vehicles, the front steer axle upper steering arm on may fail without warning, creating the potential for a vehicle crash. Correction: Suspect steering arms will be replace on affected vehicles.
On certain vehicles, the air ride suspension control valve supply line is not plumbed through an air pressure protection valve. In the event of an air suspension bag failure, there will be loss of air pressure in the "b" system which supplies air pressure to the front steer axle brakes. This could result in loss of front steer axle brakes and increased stopping distances. Correction: Air pressure protection valve will be installed.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain