Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1999 Ford Expedition, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN AFTERMARKET FUEL FILTERS SOLD UNDER THE PUROLATOR BRAND NAME, P/N F65277, SHIPPED FROM JANUARY 16 THROUGH JUNE 2, 2006, FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. DUE TO INCORRECT DESIGN, THE QUICK CONNECTORS MAY NOT FULLY SEAT WITH THE TUBE INTERFACE, EVEN THOUGH THE PERSON MAKING THE CONNECTION MAY BELIEVE THAT THE QUICK CONNECTOR IS FULLY ATTACHED. Remedy: UFI WILL NOTIFY OWNERS AND REPLACE THE FILTERS FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 4, 2006. OWNERS MAY CONTACT UFI FILTERS USA AT 800-230-5876.
CERTAIN MAXZONE HEADLIGHT ASSEMBLIES, DEPO BRAND, P/NOS. 331-1129L-ASN AND 331-1129R-ASN, SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR THE ABOVE LISTED PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE PHOTOMETRIC REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT. Remedy: MAXZONE WILL NOTIFY OWNERS AND OFFER REIMBURSEMENT FOR ANY NONCOMPLIANT HEADLIGHTS. THE RECALL BEGAN ON JULY 28, 2006. OWNERS MAY CONTACT MAXZONE AT 909-822-3288.
ON CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH SPEED CONTROL, THE SPEED CONTROL DEACTIVATION SWITCH MAY OVERHEAT, SMOKE, OR BURN. Remedy: BY LETTER DATED SEPTEMBER 12, 2005, OWNERS WERE INSTRUCTED TO RETURN THEIR VEHICLES TO THEIR DEALERS TO HAVE THE SPEED CONTROL DEACTIVATION SWITCH DISCONNECTED. OWNERS WHO HAVE HAD THEIR SPEED CONTROL DEACTIVATED ARE BEING NOTIFIED THAT PARTS WILL BE AVAILABLE AND ADVISED TO MAKE AN APPOINTMENT TO RECONNECT THE SPEED CONTROL BEGINNING IN FEBRUARY 2006. OWNERS WHO DID NOT HAVE THEIR SPEED CONTROL DEACTIVATED ARE BEING NOTIFIED TO HAVE THEIR SYSTEM REMEDIED BEGINNING IN FEBRUARY 2006. OWNERS ARE URGED TO AVAIL THEMSELVES OF THE FREE DISCONNECT SERVICE AS SOON AS POSSIBLE BECAUSE OF THE SIGNIFICANT RISK OF FIRE. OWNERS MAY CONTACT FORD AT 1-800-392-3673. (NOTE: ALSO SEE RECALLS 05V017 AND 06V286)
CERTAIN AAI MOTORSPORTS COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LIST PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." Remedy: AAI MOTORSPORTS WILL NOTIFY OWNERS AND REPLACE THE LAMPS FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 1, 2006. OWNERS MAY CONTACT AAI MOTORSPORTS AT 909-923-9188.
VEHICLE DESCRIPTION: MULTI-PURPOSE VEHICLES. THE TRAILER HITCH ASSEMBLY TO THE FRAME ATTACHING BOLTS COULD LOSE THE CLAMP LOAD. Remedy: DEALERS WILL REPLACE THE TRAILER HITCH MOUNTING BOLTS AND NUT PLATES.
VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES EQUIPPED WITH FOUR-WHEEL-DRIVE (4X4), 17" CHROME STEEL WHEELS. THE CLAMP LOAD CAN BE LOST ON THE WHEEL LUGS DUE TO INSUFFICIENT WHEEL CONTACT AREA WITH THE HUB. IN SOME CASES, THE CONTACT AREA CAN DEFORM, RESULTING IN A LOSS OF LUG NUT TORQUE. Remedy: DEALERS WILL RE-TORQUE THE WHEEL LUGS TO PROPER SPECIFICATIONS AND ALSO INSTALL A LABEL THAT SPECIFIES THAT THE WHEEL LUGS BE TORQUED TO 110 LB-FT ANY TIME THE WHEEL IS REMOVED.
THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. EQUIPMENT DESCRIPTION: FORD IS REPLACING ALL FIRESTONE WILDERNESS AT 15, 16, AND 17 INCH TIRES MOUNTED ON FORD TRUCKS AND SUVS. FORD REPORTS TREAD SEPARATION CAN OCCUR DUE TO A COMBINATION OF THE SENSITIVITY OF THE TIRE DESIGN TO STRESS, AGING, AND MANUFACTURING DIFFERENCES BETWEEN PLANTS. FORD IS REPLACING THESE TIRES TO PREVENT POSSIBLE PREMATURE TIRE FAILURE. VEHICLE DESCRIPTION: THE VEHICLES LISTED BELOW MAY HAVE BEEN ORIGINALLY EQUIPPED WITH FIRESTONE WILDERNESS AT TIRES OR MAY HAVE HAD WILDERNESS AT TIRES INSTALLED DURING THE FIRESTONE RECALL LAUNCHED IN AUGUST 2000. CERTAIN 1991 THROUGHT 2002 FORD EXPLORER CERTAIN 2001 THROUGHT 2002 EXPLORER SPORT, AND SPORT TRAC CERTAIN 1997 THROUGH 2002 MERCURY MOUNTAINEER CERTAIN 1991 THROUGH 2001 RANGER CERTAIN 1999 THROUGH 2001 EXPEDITION CERTAIN 1991 THROUGH 1994, AND 1997 MODEL YEAR F-SERIES CERTAIN 1991 THROUGH 1994 BRONCO NOTE: BOTH ORIGINAL EQUIPMENT AND REPLACEMENT TIRES ARE AFFECTED. Remedy: THE REPLACEMENT/REIMBURSEMENT PROGRAM FOR THIS CAMPAIGN EXPIRED ON MARCH 31, 2002. HOWEVER, CUSTOMERS CAN CONTACT FORD AT 1-877-917-3673 OR GO ON-LINE TO WWW.FORD.COM FOR POSSIBLE ASSISTANCE.
VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. THESE VEHICLES MAY HAVE A MISSING OR PARTIALLY INSTALLED RETAINER CLIP THAT HOLDS THE MASTER CYLINDER PUSH ROD TO THE BRAKE PEDAL ARM. Remedy: DEALERS WILL INSPECT THESE VEHICLES TO SEE IF THE RETAINER CLIP WAS INSTALLED, AND REPAIR, IF NECESSARY.
VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. THE FUEL LINE ASSEMBLIES MAY HAVE BEEN DAMAGED BY THE SUPPLIER DURING MANUFACTURING, ALLOWING LEAKAGE. Remedy: DEALERS WILL INSPECT THESE VEHICLES AND, IF NECESSARY, REPLACE THE FRONT AND REAR FUEL LINE ASSEMBLIES.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, the speed control deactivation switch may overheat, smoke, or burn, potentially resulting in an underhood fire. The condition may occur either when the vehicle is parked or when it is in operation. Correction: Initially as an interim repair, owners will be instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected. As soon as replacement parts are available, owners will be instructed to return to the dealers for installation of a new switch or fused wiring harness.
On certain vehicles, Ford has issued a scheduled maintenance guide update which specifies that every 20 000 kms, the steering linkage, which includes tie-rod ends, should be inspected. The vehicle owner is asked to place the tie-rod end inspection procedure supplied with this maintenance guide update in the vehicle's glove box for reference and safekeeping. The vehicle owner is to provide the inspection procedure to their repair facility to help properly identify worn tie-rod ends. Performing the vehicle scheduled maintenance, including maintenance inspections, is the responsibility of the vehicle owner. Failure to replace worn tie-rod ends may eventually result in a tie-rod end separation that could adversely affect steering control. If the inspection reveals that a tie-rod end is worn and must be replaced, the repair will be at the owner's expense unless the vehicle is still covered by the basic vehicle warranty, or has an extended service plan coverage that includes these components.
On certain vehicles, the daytime running lamp circuit contains a resistor that is corroding. If this occurs, the resistive element can open, resulting in a loss of daytime running lamp (DRL) function. If DRL function is lost, there may be reduced vehicle conspicuity, which could increase the risk of a vehicle crash. Correction: Dealers will install a sealed daytime running lamp resistor.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles, the trailer hitch assembly attachment bolts may lose clamp load. If the operator does not notice the condition due to rattle or other looseness of the trailer hitch assembly, there is a potential for the trailer hitch to separate from the vehicle. Correction: Trailer hitch mounting bolts and nut plates will be replaced with higher strength mounting bolts and nut plates installed at a higher torque and including an adhesive patch.
Certain vehicles equipped with 17 inch chrome steel wheels may lose clamp load on the wheel due to insufficient wheel contact area with the hub. In some cases the contact area may deform, resulting in a loss of lug nut torque. Loss of lug nut torque could cause vibration or separation of a wheel and tire from the vehicle, which could potentially result in loss of vehicle control and a crash without prior warning. Correction: Dealers will retorque the wheel lug nuts to 110 lb-ft. and install a label on the road wheels that specifies that the wheel lug nuts be torqued to 110 lb-ft any time the wheel is removed.
Certain vehicles have fuel line assemblies that could have been damaged by the supplier during manufacturing and could develop a leak. Fuel leakage in the presence of an ignition source may potentially result in a fire. Correction: vehicles will be inspected and front and rear fuel line assemblies will be replaced if necessary.
Certain vehicles may have a missing or partially installed retainer clip that holds the master cylinder push rod to the brake pedal arm. Improperly installed or missing retainers can cause the brake pedal arm to disengage from the master cylinder pushrod and result in loss of service braking without prior warning. Correction: Vehicles will be inspected to verify that the pushrod retainer was installed and ensure correct installation.