Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 1999 Freightliner Business Class, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH DUAL LEAF SPRING TYPE AIR RIDE SUSPENSIONS AND VEHICLES BUILT WITH SINGLE LEAF SPRING TYPE AIR RIDE SUSPENSIONS. REAR SUSPENSION SPRINGS CAN FRACTURE THROUGH THE CENTER BOLT HOLE AFTER VEHICLE ASSEMBLY. Remedy: FOR VEHICLES EQUIPPED WITH SINGLE LEAF SPRINGS, DEALERS WILL REMOVE AND REPLACE ALL SPRINGS. FOR VEHICLES EQUIPPED WITH DUAL LEAF SPRINGS, DEALERS WILL INSPECT FOR CRACKED SPRINGS AND REPLACE IF CRACKED.
ON CERTAIN TRUCKS EQUIPPED WITH MERITOR BRAND 12" X 4" DCM DRUM PARKING BRAKE, THE BOLTS USED TO ATTACH THE PARKING BRAKE ASSEMBLY TO THE FLANGE YOKE ARE TOO LARGE AND CAN INTERFERE WITH THE PROPER ENGAGEMENT OF THE BRAKING SYSTEM AND POSSIBLY DISENGAGE. Remedy: DEALERS WILL REPLACE THE ATTACHING BOLTS WITH THE CORRECT SIZE BOLTS FREE OF CHARGE. OWNER NOTIFICATION IS EXPECTED TO BEGIN DURING OCTOBER 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FREIGHTLINER AT 1-800-547-0712.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE BRAKE PEDAL PUSH ROD THAT ACTIVATES THE SERVICE BRAKES COULD FRACTURE. Remedy: DEALERS WILL REPLACE THE BRAKE PEDAL PUSH ROD.
ON CERTAIN TRUCKS EQUIPPED WITH TRUCK HUB UNITS MANUFACTURED BY SKF EXCLUSIVELY FOR USE ON ARVINMERITOR'S FF98X SERIES NON-DRIVE STEER AXLES, THE HUB UNIT BEARINGS CAN WEAR PREMATURELY. Remedy: DEALERS WILL REPLACE BOTH FRONT HUBS. OWNER NOTIFICATION IS EXPECTED TO BEGIN ON OR BEFORE SEPTEMBER 20, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FREIGHTLINER AT 1-800-547-0712.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS AND SCHOOL BUS CHASSIS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL. Remedy: DEALERS WILL REPLACE THE ABS ECU.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles equipped with Cummins ISB diesel engine, the fuel lift pump could fail to transfer fuel appropriately creating an engine stall condition. Should the engine stall while the vehicle is in use, a possible vehicle crash could occur. Correction: Dealers will replace the fuel lift pump.
On certain vehicles, manufacturing defects in the front axle unitized hubs may cause premature spalling of the wheel bearings. This condition will lead to eventual breakdown of the bearing and potential loss of vehicle control amidst the presence of warning signals such as activation of ABS warning light, steering wheel vibration, brake drag, noise and vehicle pull. Correction: Dealer will replace both front wheel hubs.
On certain vehicles, fatigue cracks can initiate in the weld joining the bracket pin to its mounting flange on the fifth wheel assembly. Weld failures could lead to the loss of the pin and the potential separation of the fifth wheel top plate from its mounting structure without warning. Correction: Dealers will replace the bracket pins.
On certain vehicles, the 12" X 4" DCM Drum Parking Brake Assemblies were fastened to the brake flange yoke with 1.25" attaching bolts. These bolts may interfere with the actuator strut in the parking brake assembly. Such interference could prevent the brake from being properly engage and disengaged. Correction: Dealers will replace bolts.
The TRW tie rod and drag link ball stud ends contain bearings that are below the specified case depth and/or hardness. This can lead to premature wear out and a possible separation of the ball stud from the socket and loss of steering control. Correction: All affected tie rods and drag links with different design ends will be replaced.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles, the brake pedal push rod that activates the service brakes may fracture. This could result in a vehicle crash without prior warning. Correction: Brake pedal push rod will be replaced with one of a larger diameter.
On certain vehicles, the Bendix ABS ECU misinterprets certain signals from wheel ends which can result in the temporary loss of braking capability on one or more wheel positions for several seconds. This response results from either an ABS cable that has chafed through the insulation and contacted a rotating part or a misaligned tone ring that has been damaged by contacting other components. Correction: ABS ECU will be replaced with a new ECU with upgraded software capable of detecting and properly responding to erroneous signals.
On certain vehicles, the rear suspension springs may fracture through the center bolt hole after vehicle assembly. If undetected, the rear end of the spring may separate from the vehicle causing a hazardous road debris situation. Correction: Inspect for cracked springs and replace if cracked.