Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2000 Dodge Dakota, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.
ON CERTAIN SPORT UTILITY VEHICLES AND PICKUP TRUCKS EQUIPPED WITH FOUR-WHEEL DRIVE (4X4), IF MOISTURE LEAKS INTO THE FRONT SUSPENSION UPPER BALL JOINT, EVACUATION OF THE LUBRICANT AND CORROSION OF THE JOINT MAY CAUSE THE JOINT TO WEAR OVER AN EXTENDED PERIOD OF TIME. THIS COULD CAUSE A CLUNKING NOISE IN THE FRONT SUSPENSION, WHICH MAY NOT ALWAYS BE HEARD BY THE VEHICLE OCCUPANTS. Remedy: DEALERS WILL REPLACE THE FRONT SUSPENSION UPPER BALL JOINTS. THIS SAFETY IMPROVEMENT CAMPAIGN BEGAN ON DECEMBER 21, 2004. OWNERS CAN CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.
SKF IS RECALLING 2,805 HUB UNITS, PART NO. BR930361, SOLD AS A SERVICE PART FOR 1997-2004 DODGE DAKOTA VEHICLES AND 1999-2003 DODGE DURANGO VEHICLES EQUIPPED WITH 2-WHEEL DRIVE & REAR AXLE ABS. DUE TO A SPECIFICATION ERROR, THE ROTOR PILOT FOR THE HUB UNIT MAY BE TOO LONG. THIS RESULTS IN THE WHEEL TO NOT BE SEATED FULLY AGAINST THE HUB FLANGE FACE DURING MOUNTING. Remedy: SKF WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE HUB UNITS FREE OF CHARGE. THE RECALL BEGAN ON NOVEMBER 5, 2008. OWNERS MAY CONTACT SKF VSM NORTH AMERICA CUSTOMER SERVICE AT 1-800-644-8999.
CERTAIN REPLACEMENT K&N FUEL PERFORMANCE KITS, P/NOS. 57-1509, 57-1511, 57-1511-1, 57-1517, 57-1517-1, 57-1527, AND 57-1530. ALSO, A SMALL PERCENTAGE OF THESE KITS WERE SOLD UNDER THE MOPAR PERFORMANCE PARTS BRAND NAME (P/NOS. P5007069 AND P5007070). ALL KITS WERE MANUFACTURED FROM APRIL 20, 1999, THROUGH SEPTEMBER 23, 2004. THESE ASSEMBLIES WERE MANUFACTURED AS REPLACEMENT EQUIPMENT FOR CERTAIN DODGE PICKUP TRUCKS AND SUVS. A SMALL PIECE OF MATERIAL FROM THE TUBE WALL COULD BE SUCKED INTO THE ENGINE THROTTLE BODY, WHICH COULD CAUSE THE THROTTLE TO BECOME JAMMED IN THE OPEN POSITION. Remedy: K&N WILL PROVIDE OWNERS WITH A FREE REPAIR KIT ALONG WITH REPAIR INSTRUCTIONS. THE RECALL BEGAN ON APRIL 20, 2006.
CERTAIN AFTERMARKET AIRTEX ELECTRIC FUEL PUMPS INSTALLED FOR USE AS REPLACEMENT EQUIPMENT FOR CERTAIN 1997-2004 JEEP WRANGLER; 1997-2001 JEEP CHEROKEE; 1997-2004 JEEP GRAND CHEROKEE; AND 2000-2003 DODGE DAKOTA VEHICLES. THE PLASTIC ELECTRICAL GROMMET CONNECTORS AT THE TOP OF THE FUEL PUMP MODULE ARE NOT COMPATIBLE WITH AUTOMOTIVE FUELS AND MAY DEGRADE CAUSING A POTENTIAL LEAK PATH FOR FUEL. Remedy: AIRTEX WILL NOTIFY ITS CUSTOMERS AND WILL REPLACE THE AFFECTED FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON JANUARY 25, 2006. OWNERS MAY CONTACT AIRTEX CUSTOMER SERVICE DEPARTMENT AT 1-800-880-3056.
VEHICLE DESCRIPTION: PICKUP TRUCKS. SOME VEHICLES MAY HAVE BEEN BUILT WITH INADEQUATE CLEARANCE BETWEEN THE REAR AXLE VENT HOSE AND THE BRAKE HOSE. Remedy: DEALERS WILL INSPECT THE REAR BRAKE HOSE FOR EVIDENCE OF WEAR. WORN BRAKE HOSES WILL BE REPLACED. THE REAR VENT HOSE WILL BE SHORTENED BY 3 INCHES AND A CLIP WILL BE INSTALLED TO ASSURE CLEARANCE BETWEEN THE AXLE VENT LINE AND BRAKE HOSE IS MAINTAINED.
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT. Remedy: PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.
CERTAIN AJ MOTORSPORT COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT. Remedy: AJ MOTORSPORT WILL NOTIFY OWNERS AND OFFER REIMBURSEMENT FOR THE LAMPS. THE RECALL BEGAN ON JULY 31, 2006. OWNERS MAY CONTACT AJ MOTORSPORT AT 626-618-2026.
VEHICLE DESCRIPTION: PICKUP TRUCKS EQUIPPED WITH 4.7L ENGINE AND AUTOMATIC TRANSMISSIONS. THE AUTOMATIC TRANSMISSION MAY EXPEL FLUID FROM THE FILL TUBE DURING NORMAL TEMPERATURE OPERATION. Remedy: DEALERS WILL SHORTEN THE VENT HOSE AND ASSURE ADEQUATE CLEARANCE.
VEHICLE DESCRIPTION: PICKUP TRUCKS BUILT WITH 2.5L ENGINES. SOME VEHICLES MAY HAVE BEEN BUILT WITH INADEQUATE CLEARANCE BETWEEN THE LEFT FRONT BRAKE TUBE AND THE POWER STEERING HOSE. Remedy: DEALERS WILL INSPECT THE BRAKE TUBE AND POWER STEERING HOSE FOR WEAR. IF WEAR IS EVIDENT, THE BRAKE TUBE AND/OR POWER STEERING HOSE WILL BE REPLACED. A POWER STEERING STANDOFF BRACKET WILL BE INSTALLED ON ALL VEHICLES TO ENSURE THAT ADEQUATE CLEARANCE BETWEEN THE BRAKE TUBE AND POWER STEERING HOSE IS MAINTAINED.
VEHICLE DESCRIPTION: PICKUP TRUCKS. SOUND DEADENER MATERIAL INSIDE THE STEERING WHEEL COULD BECOME DETACHED FROM THE COVER AND HOUSING. NOTE: THE RAM PICKUP TRUCKS WERE BUILT AT THE WARREN ASSEMBLY PLANT ("S" IN THE 11TH VIN POSITION) FROM MAY 16, 2000 THROUGH OCTOBER 23, 2000; ST. LOUIS NORTH ASSEMBLY PLANT ("J" IN THE 11TH VIN POSITION) FROM MAY 19, 2000 THROUGH OCTOBER 23, 2000; LAGO ALBERTO ASSEMBLY PLANT ("M" IN THE 11TH VIN POSITION) FROM MAY 23, 2000 THROUGH OCTOBER 23, 2000; AND SALTILLO ASSEMBLY PLANT ("G" IN THE 11TH VIN POSITION) FROM MAY 23, 2000 THROUGH OCTOBER 23, 2000. IMPORTANT: VEHICLES THAT HAVE ALREADY HAD THE PROPER CLOCKSPRING INSTALLED, ACCORDING TO WARRANTY RECORDS, HAVE BEEN EXCLUDED FROM THIS RECALL. IN ADDITION, 1997-2000 MODEL YEAR VEHICLES THAT HAVE HAD A SUSPECT REPLACEMENT CLOCKSPRING INSTALLED, ACCORDING TO WARRANTY RECORDS, HAVE BEEN ADDED TO THIS RECALL. Remedy: DEALERS WILL REPLACE THE CLOCKSPRING ASSEMBLY. OWNER NOTIFICATION BEGAN JUNE 18, 2001. ALSO SOME 1997-200 MODEL YEAR VEHICLES THAT, ACCORDING TO WARRANTY RECORDS, HAVE HAD A SUSPECT REPLACEMENT CLOCKSPRING INSTALLED, WILL ALSO BE INCLUDED IN THIS CAMPAIGN. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain four wheel drive vehicles, if moisture leaks into the front suspension upper ball joint, evacuation of the lubricant and corrosion of the joint may cause the joint to wear progressively over an extended period of time. A worn upper ball joint could separate, causing a loss of vehicle control which may result in a crash. Correction: Dealers will replace the upper ball joints with a revised assembly having improved sealing integrity. Two wheel drive models will be covered by an extended warranty of 10 years or 160,000 kms.
Certain Quad Cab pickup trucks. The front outboard lower seat belt anchor bolts may not be tightened correctly. An improperly tightened seat belt anchor may not provide the anticipated level of occupant restraint in a crash. Correction: Dealers will inspect the driver and passenger side lower seat belt anchor bolts and tighten to specification.
Certain pickup trucks equipped with 4.7L engine and automatic transmissions. The automatic transmission may expel fluid from the fill tube during normal temperature operation. The transmission fluid could come into contact with the hot exhaust system and ignition of the transmission fluid could result. Correction: Dealers will shorten the vent hose and assure adequate clearance.
On certain vehicles, the sound deadener material internal to the air bag clock spring may detach rendering the air bag inoperative. Correction: Dealers will replace the clockspring.
On certain vehicles, the rear axle vent hose could contact the rear brake hose which eventually could wear a hole in the brake hose. Perforation of the rear brake hose will result in a loss of braking force at the rear wheels. Correction: Rear brake hoses will be inspected for evidence of wear. Worn brake hoses will be replaced. The rear axle vent hose will be shortened by 8 cm and a clip will be installed to assure the clearance between the axle vent line and the brake hose is maintained.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
Certain vehicles may have been built with inadequate clearance between the left front brake tube and the power steering hose. This could result in the power steering hose contacting and wearing a hole in the brake tube. Perforation of the left front brake tube will result a partial brake system failure and a loss of braking force at the front wheels. Correction: Brake tube and power steering hose will be inspected for wear and replaced if necessary. A power steering stand off bracket will also be installed to ensure adequate clearance between the brake tube and the power steering hose.