Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2000 Ford F-650, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL. Remedy: DEALERS WILL REPLACE THE ABS ECU. OWNER NOTIFICATION BEGAN MARCH 20, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-800-392-3673.
VEHICLE DESCRIPTION: MEDIUM DUTY TRUCKS EQUIPPED WITH HYDROMAX HYDRAULIC BRAKE SYSTEMS. THE PARK BRAKE WARNING LAMP CIRCUITRY DOES NOT INCLUDE A PROVISION FOR A PARK BRAKE WARNING LAMP CHECK FUNCTION. THEREFORE, THESE VEHICLES DO NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 105, "HYDRAULIC BRAKE SYSTEMS." Remedy: DEALERS WILL INSTALL A REVISED MODULE WHICH INCORPORATES THE PARK BRAKE CHECK LAMP FUNCTION.
TRUCKS EQUIPPED WITH ALLISON 1000 OR 2400 SERIES TRANSMISSIONS. THESE TRANSMISSIONS CAN EXPERIENCE PARK PAWL TO REAR COVER INTERFERENCE DUE TO AN OUT OF FLATNESS CONDITION. Remedy: ALLISON TRANSMISSION IS CONDUCTING THE OWNER NOTIFICATION AND REMEDY FOR THIS CAMPAIGN. DEALERS WILL REMOVE THE TRANSMISSION FROM THE VEHICLE, REPLACE THE PARK PAWL, AND REINSTALL THE TRANSMISSION IN THE VEHICLE. OWNER NOTIFICATION IS EXPECTED TO BEGIN DURING SEPTEMBER 2000. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT ALLISON AT 1-800-252-5283 OR FORD AT 1-800-392-3673.
CERTAIN MEDIUM DUTY PICKUP TRUCKS EQUIPPED WITH AIR BRAKES THAT INCLUDE THE OPTIONAL TRAILER PACKAGE FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 121, "AIR BRAKE SYSTEMS." THE AIR BRAKE LINES CONNECTED TO THE TRACTOR PROTECTION VALVE ARE MISROUTED. Remedy: DEALERS WILL RE-ROUTE THE AIR LINES CONNECTED TO THE TRACTOR PROTECTION VALVE. OWNER NOTIFICATION BEGAN JANUARY 31, 2002. OWNERS WHO DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-800-248-0186.
VEHICLE DESCRIPTION: TRUCKS EQUIPPED WITH DRAG LINK ASSEMBLIES CONTAINING 24-DL MODEL BALL SOCKETS AND MANUFACTURED BY TRW. CERTAIN OF THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW-SPECIFICATION CASE DEPTH AND/OR HARDNESS, WHICH CAN LEAD TO PREMATURE WEAR OF THE SOCKET. Remedy: DEALERS WILL REPLACE THE DEFECTIVE DRAG LINKS. OWNER NOTIFICATION BEGAN JUNE 12, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-800-392-3673 OR TRW CUSTOMER SERVICE AT 1-866-280-3287.
VEHICLE DESCRIPTION: PASSENGER CARS, SPORT UTILITY VEHICLES, AND LIGHT AND MEDIUM DUTY PICKUP TRUCKS. A SWITCH LOCATED IN THE PLASTIC COVER OF THE WIPER MOTOR GEAR CASE COULD MALFUNCTION AND OVERHEAT, POTENTIALLY RESULTING IN LOSS OF INTERMITTENT WIPER FUNCTION, LOSS OF WIPER PARK FUNCTION, COMPLETE LOSS OF WIPER FUNCTION, OR IGNITION OF THE PLASTIC COVER MATERIAL. SWITCH MALFUNCTION IS MOST LIKELY TO OCCUR WHEN THE INTERMITTENT SETTING OF THE WIPERS IS BEING USED, OR WHEN SNOW OR ICE OBSTRUCTS THE BLADES FROM RETURNING TO THE "PARKED" POSITION AT THE BOTTOM OF THE WINDSHIELD. THESE VEHICLES WERE BUILT AT THE FOLLOWING ASSEMBLY PLANTS: ATLANTA PLANT FROM 2/11/00 THROUGH 7/31/00; CHICAGO PLANT FROM 2/14/00 THROUGH 8/4/00; KANSAS CITY PLANT FROM 2/26/00 TO 9/4/00; KENTUCKY TRUCK PLANT FROM 2/18/00 TO 8/31/00; MICHIGAN TRUCK PLANT FROM 2/23/00 THROUGH 8/3/00; NORFOLK PLANT FROM 2/21/00 THROUGH 7/27/00; WAYNE STAMPING AND ASSEMBLY PLANT FROM 2/25/00 THROUGH 8/15/00; AND WIXOM PLANT FROM 2/15/00 THROUGH 8/8/00. Remedy: DEALERS WILL INSPECT THE DATE CODE ON THE WIPER MOTOR. MOTORS BUILT WITH THE SUSPECT TIME FRAME WILL HAVE THE WIPER MOTOR GEAR CASE COVER REPLACED. OWNER NOTIFICATION BEGAN AUGUST 20, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-866-436-7332.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Certain vehicles may have improperly heat treated drag link assemblies which can lead to premature wear of the ball socket. If this condition occurs, the driver can lose partial control of the right front wheel, possibly resulting in a crash. Correction: Dealers will replace the defective drag links.
On certain vehicles, the tie rod and drag link ball stud ends contain bearing that are below the specified case depth and/or hardness. This can lead to premature wear out and a possible separation of the ball stud from the socket and loss of steering control. Correction: All affected tie rods and drag links will be replaced. Note: Duplicate file, see 2000-310.
On certain vehicles, the tie rod ends and/or drag link assembly ends may have insufficient hardness in the ball stud. this could result in premature wear and, potentially, separation of the ball stud from its socket. If this occurs, there could be a reduction in or loss of steering control which in turn could result in a vehicle crash. Correction: Dealers will replace the affected tie rod ends and/or drag link assemblies.
On certain vehicles, the ABS ECU misinterprets certain signals from wheel ends which can result in the temporary loss of braking capability on one or more wheel positions for several seconds. This response results from either an ABS cable that has chafed through the insulation and contacted a rotating part or a misaligned tone ring that has been damaged by contacting other components. Correction: ABS ECU will be replaced with a new ECU with upgraded software capable of detecting and properly responding to erroneous signals.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Certain vehicles do not comply with the requirements of CMVSS 105 - Hydraulic Brake Systems. The park brake warning lamp circuitry does not include a provision for a park brake warning lamp check function. Correction: Electronic control module will be replaced on affected vehicles.