Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2000 Freightliner Century, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH DUAL LEAF SPRING TYPE AIR RIDE SUSPENSIONS AND VEHICLES BUILT WITH SINGLE LEAF SPRING TYPE AIR RIDE SUSPENSIONS. REAR SUSPENSION SPRINGS CAN FRACTURE THROUGH THE CENTER BOLT HOLE AFTER VEHICLE ASSEMBLY. Remedy: FOR VEHICLES EQUIPPED WITH SINGLE LEAF SPRINGS, DEALERS WILL REMOVE AND REPLACE ALL SPRINGS. FOR VEHICLES EQUIPPED WITH DUAL LEAF SPRINGS, DEALERS WILL INSPECT FOR CRACKED SPRINGS AND REPLACE IF CRACKED.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH EATON AUTOSHIFT GEN II TRANSMISSION ASSEMBLIES. DUE TO A SOFTWARE PROBLEM IN THE TRANSMISSION ASSEMBLIES, THE TRANSMISSION WILL SELECT THE WRONG GEAR. Remedy: DEALERS WILL REPLACE THE AUTOSHIFT TRANSMISSIONS.
VEHICLE DESCRIPTION: VEHICLES EQUIPPED WITH CERTAIN HALDEX BRAKE SYSTEM TWO AND FOUR PORT RELAY VALVES. THE VALVE MAY STICK OPEN WHEN A HIGH-PRESSURE APPLICATION IS RELEASED. Remedy: DEALERS WILL REPLACE THESE VALVES. OWNER NOTIFICATION BEGAN OCTOBER 17, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FREIGHTLINER AT 1-800-547-0712.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH TRW TIE ROD ENDS ON CERTAIN MERITOR AXLES. THE TIE ROD AND DRAG LINK BALL STUD ENDS CONTAIN BEARINGS THAT ARE BELOW THE SPECIFIED CASE DEPTH AND/OR HARDNESS. Remedy: DEALERS WILL REMOVE AND REPLACE ALL AFFECTED TIE RODS AND DRAG LINKS WITH DIFFERENT DESIGNED ENDS. OWNER NOTIFICATION BEGAN NOVEMBER 8, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FREIGHTLINER AT 1-800-547-0712.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS AND SCHOOL BUS CHASSIS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL. Remedy: DEALERS WILL REPLACE THE ABS ECU.
ON CERTAIN TRUCKS EQUIPPED WITH TRUCK HUB UNITS MANUFACTURED BY SKF EXCLUSIVELY FOR USE ON ARVINMERITOR'S FF98X SERIES NON-DRIVE STEER AXLES, THE HUB UNIT BEARINGS CAN WEAR PREMATURELY. Remedy: DEALERS WILL REPLACE BOTH FRONT HUBS. OWNER NOTIFICATION IS EXPECTED TO BEGIN ON OR BEFORE SEPTEMBER 20, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FREIGHTLINER AT 1-800-547-0712.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, manufacturing defects in the front axle unitized hubs may cause premature spalling of the wheel bearings. This condition will lead to eventual breakdown of the bearing and potential loss of vehicle control amidst the presence of warning signals such as activation of ABS warning light, steering wheel vibration, brake drag, noise and vehicle pull. Correction: Dealer will replace both front wheel hubs.
The TRW tie rod and drag link ball stud ends contain bearings that are below the specified case depth and/or hardness. This can lead to premature wear out and a possible separation of the ball stud from the socket and loss of steering control. Correction: All affected tie rods and drag links with different design ends will be replaced.
On certain vehicles, the TRW tie rod and drag link ball stud ends contain bearing that are below the specified case depth and/or hardness. This can lead to premature wear out and a possible separation of the ball stud from the socket and loss of steering control. Correction: All affected tie rods and drag links with different design ends will be replaced. Note: this supercedes recall FL268.
On certain vehicles, the Bendix ABS ECU misinterprets certain signals from wheel ends which can result in the temporary loss of braking capability on one or more wheel positions for several seconds. This response results from either an ABS cable that has chafed through the insulation and contacted a rotating part or a misaligned tone ring that has been damaged by contacting other components. Correction: ABS ECU will be replaced with a new ECU with upgraded software capable of detecting and properly responding to erroneous signals.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles equipped with Eaton Autoshift transmissions, incorrect software in these transmissions could cause a condition whereby in certain circumstances, when reverse is selected the transmission engages 2nd gear. Incorrect gear engagement can result in a crash without prior warning. Correction: Suspect software will be reprogrammed.
On certain vehicles, the rear suspension springs may fracture through the center bolt hole after vehicle assembly. If undetected, the rear end of the spring may separate from the vehicle causing a hazardous road debris situation. Correction: Inspect for cracked springs and replace if cracked.