Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2000 MCI 102DL3, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
Motor Coach Industries (MCI) is recalling certain model year 2000-2012 D, E, G and J series coaches manufactured January 2000 through June 2011 and equipped with Sure Power battery equalizers containing a particular epoxy sealing, aka 'potting', compound. The specific potting compound used in the subject products for insulation was found to be capable of conducting electricity after being exposed to heat. Remedy: MCI will notify owners, and Sure Power will replace the equalizers, free of charge. Owners may contact MCI at 1-847-285-2000. This campaign is MCI service bulletin 401.
ON CERTAIN MOTOR COACHES, THE BOOST CONNECTOR HOUSING CAN FAIL OVER TIME, EXPOSING THE POSITIVE AND NEGATIVE TERMINALS. Remedy: CUSTOMERS ARE BEING ADVISED TO REMOVE THE BOOST CONNECTOR AND DISCARD IT. CUSTOMERS WILL BE OFFERED A NEW DESIGN BOOST CONNECTOR AS AN ALTERNATIVE AT NO COST. THE RECALL BEGAN ON JANUARY 2, 2007. OWNERS MAY CONTACT MCI AT 1-800-241-2947.
VEHICLE DESCRIPTION: MOTOR HOME CHASSIS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL. Remedy: DEALERS WILL REPLACE THE ABS ECU.
MOTORHOMES EQUIPPED WITH DRAG LINK ASSEMBLIES CONTAINING 20-EDL MODEL BALL SOCKETS AND MANUFACTURED BY TRW. CERTAIN OF THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW-SPECIFICATION CASE DEPTH AND/OR HARDNESS, WHICH CAN LEAD TO PREMATURE WEAR OF THE SOCKET. Remedy: DEALERS WILL REPLACE THE DEFECTIVE DRAG LINKS. OWNER/DISTRIBUTOR NOTIFICATION BEGAN APRIL 18, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT MCI AT 1-800-241-2941 OR TRW CUSTOMER SERVICE AT 1-866-280-3287.
Motor Coach Industries (MCI) is recalling certain 102DL3, 102D3, MC12PTV, E4500, D4000, 102D3ISTV, D4500, J4500, D4000ISTV, D4005, D4505, and J3500 transit buses. Please refer to MCI's recall report for specific model year information. The front door lower curb view glazing material is incorrect. As such, these vehicles fail to conform to Federal Motor Vehicle Safety Standard (FMVSS) number 205, "Glazing Materials." Remedy: MCI will replace the glass, free of charge. Owner notification letters were mailed February 4, 2026. Owners may contact MCI customer service at 1-800-241-2947. MCI's number for this recall is 22-005.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Issue: On certain buses, the wrong glass may have been installed on the lower front entry door panel. As a result, the glass may not meet certain requirements of Canadian regulations. Safety Risk: An incorrect window glass could reduce visibility and increase the risk of a crash. Corrective Action: Motor Coach Industries (MCI) will notify owners by mail and provide you with instructions for how to replace the lower glass panel. Alternatively, you may schedule an appointment to have the lower glass panel replaced at an authorized MCI service center.
On certain coaches, the boost connector's plastic housing may crack, which can allow the positive and negative leads to come in contact. An electrical short could cause a fire, resulting in injuries or death. Correction: Dealers will replace the boost connector with an updated version.
On certain vehicles, the Bendix ABS ECU misinterprets certain signals from wheel ends which can result in the temporary loss of braking capability on one or more wheel positions for several seconds. This response results from either an ABS cable that has chafed through the insulation and contacted a rotating part or a misaligned tone ring that has been damaged by contacting other components. Correction: ABS ECU will be replaced with a new ECU with upgraded software capable of detecting and properly responding to erroneous signals.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain