Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2001 International 4700 LP, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
ON CERTAIN SCHOOL AND TRANSIT BUSES BUILT WITH BOSCH ZERO OFFSET PIN SLIDE (ZOPS) HYDRAULIC DISC BRAKES, THE ZOPS HYDRAULIC DISC BRAKES MAY EXPERIENCE CALIPERS STICKING IN THE APPLIED POSITION, WHICH CAN RESULT IN EXCESSIVE OR ABNORMAL HEAT GENERATION AT ONE OR MORE OF THE BRAKES. Remedy: INTERNATIONAL WILL NOTIFY ITS CUSTOMERS AND REPAIR THE BUSES FREE OF CHARGE. THE RECALL BEGAN OCTOBER 29, 2004.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, the TRW Model 410M Electronic Control Unit (ECU) can misinterpret particular false wheel speed signals generated from any of the following conditions: An incorrect gap between the sensor and tone ring, a chaffed sensor wire, connector corrosion, sensor vibration or quality of harness and pin-outs. If one of these conditions occurs, the ECU could not distinguish between an actual low friction event on road surface and a low amplitude sensor signal and would activate the ABS brakes, instead of deactivating the ABS in response to a false signal. The driver would experience a hard brake pedal during the middle to end of a braking event and a decrease in deceleration at the end of the stop. The driver may experience an unexpected extended stopping distance, which could result in a collision. The ABS warning indicator light may not come on to warn the driver of a system malfunction. Correction: Dealers will replace the ABS ECU. Note: This Recall supersedes Recall 2002165.
On certain vehicles, the Bosch Zero Offset Pin Slide (ZOPS) hydraulic disc brakes may experience calipers sticking in the applied position, which can result in excessive or abnormal heat generation at one or more of the brakes. In bus applications, the combination of the following factors may collectively result in an unreasonable risk to motor vehicle safety: potential fire at a wheel end, high incident rates of stuck calipers, and evacuation and containment concerns relating to multiple passengers. Correction: Dealers will affect repairs. This is an expansion of Recall 2003053.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain