Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2002 Kenworth T600, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
ON CERTAIN TRUCKS EQUIPPED WITH JOST INTERNATIONAL JSK 37U SERIES FIFTH WHEELS, A FATIGUE CRACK CAN DEVELOP IN THE BRACKET PIN WELD UNDER CERTAIN LOADING CONDITIONS. Remedy: DEALERS WILL REPLACE THE BRACKET PINS AND REPAIR INSTRUCTIONS FREE OF CHARGE. PETERBILT'S OWNER NOTIFICATION BEGAN JUNE 20, 2003. KENWORTH'S OWNER NOTIFICATION BEGAN JUNE 12, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT PETERBILT AT 940-591-4201 OR KENWORTH 425-828-5440.
ON CERTAIN VEHICLES EQUIPPED WITH BENDIX TC-7 TRAILER CONTROL HAND-OPERATED VALVE WITH PUSH-TO-CONNECT FITTINGS. THE DELIVERY PORT IN THE VALVE BODY MAY BE PARTIALLY BLOCKED DUE TO A PROBLEM DURING THE MOLDING PROCESS. Remedy: PACCAR WILL NOTIFY ITS CUSTOMERS AND INSPECT AND REPLACE, IF NECESSARY, THE HAND VALVE FREE OF CHARGE. OWNER NOTIFICATION BEGAN OCTOBER 18, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT PETERBILT AT 940-591-4201.
ON CERTAIN HEAVY DUTY TRUCKS, THE MAIN CAB WIRING HARNESS WAS INCORRECTLY CONNECTED TO THE 50 AMP CIRCUIT BREAKER INSTEAD OF THE 135 AMP BREAKER. Remedy: DEALERS WILL INSPECT THE VEHICLES AND THE WIRING WILL BE CORRECTED IF NECESSARY. OWNER NOTIFICATION BEGAN SEPTEMBER 16, 2003. OWNERS SHOULD CONTACT KENWORTH AT 1-425-828-5440.
CERTAIN TRUCKS EQUIPPED WITH TRAILER CONNECTIONS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARDS (FMVSS) NO. 121, "AIR BRAKE SYSTEMS," AND NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THE SUPPLIER REMOVED A RUBBER GROMMET FROM THE TRAILER LIGHT LINE CONNECTOR. THE VEHICLES ARE EXPERIENCING CORROSION AT THE 7-WAY TRAILER CONNECTION. THIS CAUSES INTERMITTENT FLASHING/FLICKERING OF THE TRAILER LIGHTS. Remedy: DEALERS WILL INSTALL THE MISSING GROMMET ON ALL AFFECTED CHASSIS. IF A CONNECTOR IS FOUND DEFECTIVE, IT WILL BE REPLACED WITH A NEW CONNECTOR. OWNER NOTIFICATION IS BEGAN ON MARCH 14, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT KENWORTH AT 1-425-828-5440.
ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH VERTICAL TAIL PIPES, THE FRAME ACCESS GRABHANDLE IS MOUNTED TOO HIGH. Remedy: DEALERS WILL INSPECT THE GRABHANDLE LOCATION AND IF DETERMINED TO BE MOUNTED TOO HIGH, THE HANDLE WILL BE RELOCATED TO THE PROPER HEIGHT. OWNER NOTIFICATION BEGAN JULY 29, 2003. OWNERS SHOULD CONTACT KENWORTH AT 1-425-828-5440.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, the optional battery-mounted 50 amp and/or 60 amp circuit breaker had been wired incorrectly. If enough accessories are being used simultaneously during operation of these vehicles, this error in wiring can cause the cab power and engine to shut down prematurely without warning and could result in loss of vehicle control. Correction: Dealer will correct the electrical wiring if defect is found.
On certain vehicles, the grabhandles were mounted too high and may limit the ability to maintain 3-points of contact at all times. This condition may cause a person to slip and/or fall and could lead to personal injury. Correction: Dealer will relocate the handle to the proper height.
On certain vehicles, fatigue cracks can initiate in the weld joining the bracket pin to its mounting flange on the fifth wheel assembly. Weld failures could lead to the loss of the pin and the potential separation of the fifth wheel top plate from its mounting structure without warning. Correction: Dealers will replace the bracket pins.
On certain vehicles a rubber grommet from the trailer light line connector is missing. Kenworth chassis equipped with trailer connections are experiencing corrosion at the 7-way trailer connector with the light line because of the missing grommet, which causes intermittent flashing/flickering of the trailer lights. The elimination of this grommet allowed water to enter the connection and begin corroding, which can cause a short and/or possible fire hazard. Correction: Dealer will install the missing grommet and if a connector is found defective, it will be replaced.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles, the delivery port inside Bendix trailer hand control brake valves may be partially blocked due to a problem during the molding process. Such a blockage may slow the delivery and exhaust of air to and from the trailer brakes when they are operated by this hand control valve which may result in delayed trailer brake application and release. Correction: The dealer will inspect and replace defective valves.
Certain heavy duty trucks. The driveline u-joint fasteners at the output yoke of the transmission were improperly tightened. Under-tightened fasteners can lead to the driveline becoming detached from the vehicle resulting in property damage or personal injury. Correction: Dealers will tighten the driveline fasteners to the proper specification.