Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2002 Nissan Frontier, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.
NISSAN IS RECALLING CERTAIN MODEL YEAR 2002-2004 FRONTIER VEHICLES MANUFACTURED FROM JULY 9, 2001 THROUGH OCTOBER 20, 2004, AND MODEL YEAR 2002-2004, XTERRA VEHICLES MANUFACTURED FROM JULY 9, 2001, THROUGH JANUARY 6, 2005. OVER TIME CORROSION MAY FORM IN THE LOWER STEERING COLUMN JOINT AND LIMIT MOVEMENT OF THE JOINT. THE LIMITED MOVEMENT OF THIS JOINT MAY CREATE EXCESSIVE LOAD ON THE LOWER STEERING COLUMN SHAFT. IF THE VEHICLE CONTINUES TO BE DRIVEN IN THIS CONDITION, IT MAY LEAD TO CRACKING OF THE SHAFT DURING LOW SPEED MANEUVERS THAT REQUIRE LARGE STEERING INPUTS. Remedy: THE STEERING COLUMN SHAFT AND JOINT WILL BE REPLACED WITH A SHAFT OF A DIFFERENT DESIGN. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE RECALL BEGAN ON DECEMBER 13, 2010. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
CERTAIN ANZO COMBINATION HEADLAMP ASSEMBLIES SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES. SOME COMBINATION LAMPS ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS WHICH FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." Remedy: ANZO WILL NOTIFY OWNERS AND REPLACE THE HEADLAMPS FREE OF CHARGE. THE RECALL BEGAN MAY 9, 2006. OWNERS MAY CONTACT ANZO USA AT 909-468-3688.
CERTAIN TRADESONIC COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT. Remedy: TRADESONIC WILL NOTIFY OWNERS AND REPLACE THE LAMPS FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN DURING JULY 2006. OWNERS MAY CONTACT TRADESONIC AT 626-934-8884.
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.
ON CERTAIN PICKUP TRUCKS EQUIPPED WITH SIX CYLINDER ENGINES AND SPORT UTILITY VEHICLES EQUIPPED WITH FOUR OR SIX CYLINDER ENGINES, THE FUEL PUMP TERMINAL ON THE FUEL-SENDING UNIT CAN DEVELOP A CRACK IN THE PLASTIC MOLDING. THIS CAN CAUSE THE TERMINAL STRIP TO CORRODE UNDER SOME ENVIRONMENTAL CONDITIONS. Remedy: IN THE FOLLOWING STATES, DEALERS WILL REPLACE THE FUEL-SENDING UNIT. THESE STATES ARE CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, KENTUCKY, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, TENNESSEE, VERMONT, VIRGINIA, WEST VIRGINIA, WISCONSIN, AND THE DISTRICT OF COLUMBIA. IN THE OTHER STATES, THE DEALER WILL INSPECT THE FUEL PUMP TERMINAL ON THE SENDING UNIT FOR CORROSION. IF CORROSION IS PRESENT, THE DEALER WILL REPLACE THE UNIT. IF THERE IS NOT CORROSION, THE DEALER WILL APPLY SEALANT TO THE TERMINAL HOUSING TO HELP PREVENT CORROSION IN THE FUTURE. OWNER NOTIFICATION BEGAN ON JUNE 28, 2004. OWNERS SHOULD CONTACT NISSAN AT 1-800-647-7261.
ON CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES, WATER MAY ENTER THE REAR AXLE HOUSING DUE TO INADEQUATE SEALING OF THE ANTI-LOCK BRAKING SYSTEM (ABS) SENSOR. Remedy: DEALERS WILL INSPECT THE REAR AXLE FOR WATER INTRUSION AND ANY AFFECTED COMPONENTS WILL BE REPLACED. THE ABS SENSOR WILL BE RESEALED TO PREVENT WATER INTRUSION. OWNER NOTIFICATION BEGAN DECEMBER 10, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT NISSAN AT 1-800-647-7261.
ON CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH A SUPERCHARGER, UNDER CERTAIN CONDITIONS, SUCH AS FULL THROTTLE IN LOW GEAR WHEN THE ENGINE IS NOT FULLY WARMED UP AND AT COLD AMBIENT TEMPERATURE, THE AMOUNT OF INTAKE AIR FLOW THROUGH THE AIR FLOW METER MAY EXCEED THE MAXIMUM PRESET DIAGNOSIS LIMIT VALUE. Remedy: DEALERS WILL REPROGRAM THE ELECTRONIC CONTROL MODULE. OWNER NOTIFICATION BEGAN JANUARY 15, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT NISSAN AT 1-800-647-7261.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, corrosion may form in the lower steering column joint and limit the movement of the joint. Limited movement of this joint may create excessive load on the lower steering column shaft and, if the vehicle continues to be driven in this condition, may lead to cracking of the shaft during low speed manoeuvres that require large steering inputs. In an extreme case, the shaft may break which would result in loss of steering control and could result in a crash. Correction: Dealers will replace the affected column shafts and joints.
Certain Hidden Hitch brand accessory trailer hitches P/N 64-3528 installed by Nissan dealers on 2002 to 2004 Frontier vehicles. With continued use, load forces may cause a side bracket of the trailer hitch to fatigue and eventually break, possibly allowing the towed unit to separate from the towing vehicle. Correction: Dealers will replace all suspect Hidden Hitch brand hitches originally installed by Nissan dealers in Canada.
On certain vehicles, the fuel pump terminal on the fuel sending unit can develop a crack. When exposed to heavy concentrations of road salt in the winter, if road salt enters the crack, the terminal strip will corrode and eventually could break due to corrosion. This will cause the fuel pump to stop operating and will result in not being able to start the engine or cause the engine to stop running without warning. Correction: Dealer will replace the fuel sender unit.
On certain supercharged vehicles, the amount of intake air flow through the air flow meter may exceed the maximum preset diagnosis limit value which would cause the engine control system to go into the failsafe mode. Under this condition, the malfunction indicator lamp will illuminate and engine speed will not exceed 2400 rpm's regardless of throttle position. Correction: Dealer will reprogram the electronic control module (ECM).
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
On certain four wheel drive vehicles, water may enter the rear axle housing due to inadequate sealing of the ABS sensor in the axle housing. This may result in corrosion and eventually failure of the wheel bearing. If this occurs, the wheel assembly could separate from the vehicle. Correction: Dealer will inspect the rear axle for water intrusion and replace any affected components. The ABS sensor will be resealed to prevent water intrusion.