Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2003 Four Winds Windsport, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN MOTOR HOMES BUILT ON WORKHORSE CHASSIS AND EQUIPPED WITH ACTIA CORPORATE INSTRUMENT CLUSTERS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NOS. 101 "CONTROLS AND DISPLAYS" AND 105 "HYDRAULIC AND ELECTRIC BRAKE SYSTEMS." IF THE BRAKE FAIL INPUT FALLS BELOW A VOLTAGE OF 1.5V, THE BRAKE FAILURE LAMP AND ALARM WILL BE ACTIVATED. ALSO ACTIVATION OF THE ABS TELLTALE WHEN THE ABS IS NOT PROPERLY FUNCTIONING DOES NOT ALWAYS OCCUR. Remedy: WORKHORSE IS CONDUCTING THE OWNER NOTIFICATION AND REMEDY FOR THIS CAMPAIGN AND REPROGRAM THE INSTRUMENT PANEL CLUSTER FREE OF CHARGE. OWNERS MAY CONTACT WORKHORSE AT 1-877-246-7731 OR FOUR WINDS AT 574-266-1111.
FOUR WINDS IS RECALLING 684 MY 2002-2006 INFINITY, MY 2002-2007 WINDESPORT, MY 2004-2008 HURRICANE, MY 2006-2007 MEGALLAN AND MY 2008 FUN MOVER MOTOR HOMES EQUIPPED WITH AXLES THAT INCLUDE BOSCH ZOPS OR ZOHT PIN SLIDE HYDRAULIC DISC BRAKES. WHEN COMBINED WITH OCCASIONAL OR SEASONAL VEHICLE OPERATION MAY EXPERIENCE CALIPERS STICKING IN THE APPLIED POSITION. THIS CAN RESULT IN ABNORMAL HEAT GENERATION AT THE WHEEL END CAUSING BRAKE DRAG. THE DRIVER WOULD NORMALLY HAVE WARNING OF THE BRAKE DRAG IF UNDETECTED BY THE DRIVER. Remedy: DEALERS WILL INSPECT AND REPLACE THE NECESSARY COMPONENTS FREE OF CHARGE. WORKHORSE IS HANDLING THE REMEDY FOR THIS CAMPAIGN PLEASE SEE 09V-110. WORKHORSE WILL CONDUCT THE OWNER AND DEALER NOTIFICATION. OWNERS MAY CONTACT WORKHORSE AT 1-877-246-7731.
ON CERTAIN TRAVEL TRAILERS EQUIPPED WITH SAMSUNG MICROWAVE OVENS, THESE OVENS WERE PRODUCED WITH A DEFECTIVE PANEL. AN ELECTRICAL SHORT CAN OCCUR BETWEEN CIRCUIT PATTERNS ON THE MEMBRANE PANEL, ESPECIALLY OVERLAPPED BY A "JUMPER" OR JUMP WIRE. THIS MAY CAUSE THE OVEN TO ACTIVATE WITHOUT PRESSING ANY KEY PADS. Remedy: SAMSUNG WILL NOTIFY CUSTOMERS AND REPAIR THE PANEL FREE OF CHARGE. IN THE MEANTIME, CONSUMERS SHOULD UNPLUG THEIR MICROWAVE, IF POSSIBLE. IF THE CONSUMER IS UNABLE TO UNPLUG THE MICROWAVE, THEY SHOULD LEAVE THE DOOR AJAR UNTIL THE PANEL IS REPLACED. CONSUMERS SHOULD NEVER USE THE MICROWAVE OVEN FOR STORAGE OR LEAVE ANY TOWELS, PAPER, CLOTH OR OTHER PRODUCTS IN THE MICROWAVE AFTER USE. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT SAMSUNG AT 800-932-3837 OR FOUR WINDS AT 1-219-266-1111.
CERTAIN MOTOR HOME CHASSIS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC AND ELECTRIC BRAKE SYSTEMS." THE BRAKE SYSTEM WARNING INDICATOR MAY NOT FUNCTION AS REQUIRED BY STANDARD. Remedy: DEALERS WILL REPAIR THE BRAKE WARNING LAMP CIRCUIT. OWNER NOTIFICATION BEGAN MAY 13, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FOUR WINDS AT 1-219-266-1111.
CERTAIN MOTORHOMES WERE MANUFACTURED WITH A 20/15 AMP CIRCUIT BREAKER AND SHOULD HAVE BEEN MANUFACTURED WITH A 15/15 AMP CIRCUIT BREAKER. Remedy: DEALERS WILL REPLACE THE INCORRECT BREAKER WITH THE CORRECT BREAKER. THE RECALL BEGAN APRIL 29, 2004. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FOUR WINDS AT 1-574-266-1111.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain motorhomes, the brake calipers may stick in the applied position. This can result in abnormal heat generation at the wheel end which, if undetected, could eventually lead to soft brake pedal condition due to brake fluid boil. Extended stopping distances may result in a vehicle crash causing property damage, personal injury or death. Correction: Dealers will affect repairs.
On certain motorhomes, incorrect software programmed into the instrument panel cluster may not allow certain driver warnings, required by CMVSS 101 and 105, to be displayed. As a result of this incorrect software, the instrument cluster may fail to illuminate warning lamps indicating brake system failure. Correction: Dealers will reprogram the instrument panel cluster.
On certain motorhomes, the front brake caliper slides could bind, which may lead to performance issues such as overheated brake components and potentially fire, burn or smoke incidents. Overheated brakes could result in increased stopping distance and possible collision with bystanders, a fixed object or another vehicle which may cause serious injuries or even death. Correction: Dealers will service the front brake calipers.
Certain motorhomes equipped with the slide out option were manufactured with a 20/15 amp breaker instead of a 15/15 amp breaker. The use of the incorrect breaker size may cause the failure of the breaker to trip when the circuit is overloaded, which could result in a fire and could cause death or injury to the occupants. Correction: Dealer will replace the 20/15 amp breaker with the correct 15/15 amp breaker.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
On certain recreational vehicles equipped with a Samsung microwave oven, an electrical short can occur in the microwave oven's membrane panel keypad causing the oven to activate without pressing any keypads. This could result in excessive heat, smoke or possibly a fire. Correction: Samsung will notify its customers and repair the membrane panel keypad. In the meantime, consumers should unplug their microwave ovens, if possible. If the consumer is unable to unplug the microwave, they should leave the door ajar until the membrane panel keypad is replaced.
On certain vehicles, the brake system warning indicator will not illuminate when the ignition is in the start position or when the brake fluid is low. Correction: The brake warning indicator bulb from the right side indicator position must be transferred to the left side indicator position of the instrument cluster and the wire harness must be modified.