Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2003 Holiday Rambler Vacationer, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN MOTOR HOMES BUILT ON WORKHORSE CHASSIS AND EQUIPPED WITH ACTIA CORPORATE INSTRUMENT CLUSTER FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 101, 'CONTROLS AND DISPLAYS,' AND NO. 105, 'HYDRAULIC AND ELECTRIC BRAKE SYSTEMS.' IF THE BRAKE FAIL INPUT FALLS BELOW A VOLTAGE OF 1.5V, THE BRAKE FAILURE LAMP AND ALARM WILL BE ACTIVATED. ALSO ACTIVATION OF THE ABS TELLTALE WHEN THE ABS IS NOT PROPERLY FUNCTIONING DOES NOT ALWAYS OCCUR. Remedy: WORKHORSE IS CONDUCTING THIS RECALL (PLEASE SEE 04V195000) AND WILL REPROGRAM THE INSTRUMENT PANEL CLUSTER FREE OF CHARGE. OWNERS MAY CONTACT WORKHORSE AT 1-877-246-7731 OR MONACO AT 1-800-685-6545.
ON CERTAIN CLASS A MOTOR H0MES BUILT WITH GASOLINE ENGINES, THE FRAME EXTENSION LOWER FLANGE MAY CRACK ALLOWING THE HITCH TO BEND AND POSSIBLY SEPARATE FROM THE MOTOR HOME. Remedy: DEALERS WILL ADD AN ADDITION OF TWO PIECES OF ANGLE STEEL TO THE FRAME EXTENSION AND HITCH MOUNTING POINT IN ORDER TO REINFORCE THE FRAME EXTENSION FLANGE FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 15, 2007. OWNERS MAY CONTACT MONACO AT 877-466-6226. NOTE: THE ENDING MANUFACTURING DATE FOR INDIANA BUILT MOTOR HOMES IS MARCH 8, 2002 WHILE THE OREGON BUILT MOTOR HOMES WERE BUILT THROUGH NOVEMBER 2002. THE FEDERAL ID LABEL LOCATED ON THE WALL NEXT TO THE DRIVER'S SEAT SPECIFIES IN WHICH STATE THE MOTOR HOME WAS BUILT.
ON CERTAIN CLASS A MOTOR HOMES, THE FLOOR TRUSS NETWORK SUPPORT SYSTEM HAS A POTENTIAL TO WEAKEN CAUSING INTERNAL AND EXTERNAL FEATURES TO BECOME MISALIGNED. THE AFFECTED VEHICLES ARE 1999 - 2003 CLASS A MOTOR HOMES MANUFACTURED ON F53 20,500 POUND GROSS VEHICLE WEIGHT RATING (GVWR), FORD CHASSIS, AND 2000-2003 CLASS A MOTOR HOMES MANUFACTURED ON W-22 22,000 POUND GVWR, WORKHORSE CHASSIS. Remedy: DEALERS WILL INSPECT THE FLOOR TRUSS NETWORK SUPPORT SYSTEM, REINFORCE THE EXISTING STRUCTURE, AND REPAIR, AS NEEDED, THE FLOOR TRUSS NETWORK SUPPORT. OWNER NOTIFICATION BEGAN NOVEMBER 5, 2002. OWNERS SHOULD CONTACT MONACO AT 1-800-685-6545.
CERTAIN MOTOR HOME CHASSIS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC AND ELECTRIC BRAKE SYSTEMS." THE BRAKE SYSTEM WARNING INDICATOR MAY NOT FUNCTION AS REQUIRED BY STANDARD. Remedy: DEALERS WILL REPAIR THE BRAKE WARNING LAMP CIRCUIT. OWNER NOTIFICATION BEGAN MAY 7, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT MONACO COACH AT 1-877-477-6226.
ON CERTAIN MOTOR HOMES, THE BRAKE ASSEMBLIES EXHIBIT ELEVATED TEMPERATURES THAT CAN LEAD TO CATASTROPHIC DETERIORATION OF THE WHEEL END COMPONENTS SUCH AS BEARINGS, RACES, SPINDLES, KNUCKLES, SEALS, HUBS, ROTORS, PATCH BOLTS, CALIPERS, BRAKE PADS, AND ABS SENSORS. Remedy: DEALERS WILL INSPECT THE FRONT AND REAR BRAKE CALIPERS FOR CORROSION AND REPLACE OR REBUILD THE CALIPERS AS NECESSARY. THE RECALL BEGAN ON AUGUST 18, 2004. OWNERS SHOULD CONTACT MONACO AT 1-800-685-6545.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain motorhomes, the frame extension lower flange may crack allowing the hitch to bend down or fail. Hitch failure could allow the towed unit to separate from the towing vehicle. Correction: Dealers will install two pieces of angle steel; one to each side of the frame extension.
Certain Workhorse Custom Chassis equipped vehicles fail to comply with CMVSS 101 and 105. Specifically the instrument cluster ABS telltale and other brake warning signals fail to conform to the Federal Safety Standards. Incorrect software may fail to illuminate the warning lamps for brake failures. This would result in the driver not knowing when a brake failure had occurred and result in an accident. Correction: Dealers will reprogram the instrument cluster.
On certain motorhomes, the brake assemblies exhibit elevated temperatures that can lead to catastrophic deterioration of the wheel end components such as bearings, races, spindles, knuckles, seals, hubs, rotors, patch bolts, calipers, brake pads and ABS sensors. This could result in loss of control, and/or the potential for a fire. Correction: Dealers will inspect the front and rear brake calipers for corrosion and replace or rebuild the calipers as necesary.
On certain vehicles, the brake system warning indicator will not illuminate when the ignition is in the start position or when the brake fluid is low. Correction: The brake warning indicator bulb from the right side indicator position must be transferred to the left side indicator position of the instrument cluster and the wire harness must be modified.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain