Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2003 Hyundai Tiburon, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
HYUNDAI IS RECALLING 160,904 MY 2001-2003 ELANTRA AND MY 2003 TIBURON VEHICLES ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WEST VIRGINIA, WISCONSIN, AND THE DISTRICT OF COLUMBIA. ROAD SALT USED DURING THE WINTER MONTHS IN THESE JURISDICTIONS MAY RESULT IN INTERNAL CORROSION AND THINNING OF THE STEEL IN THE FRONT LOWER CONTROL ARMS. THE CORROSION MAY PROGRESS TO THE POINT WHERE THE LOWER CONTROL ARM'S UPPER AND LOWER PANELS BECOME PERFORATED. A PERFORATED FRONT LOWER CONTROL ARM MAY FRACTURE BETWEEN ITS BALL JOINT ATTACHMENT AND THE FORWARD AND REARWARD PIVOT ATTACHMENTS TO THE CHASSIS. Remedy: DEALERS WILL INSPECT THE FRONT LOWER CONTROL ARMS FOR CORROSION DAMAGE. IF SPECIFIED LEVELS OF INTERNAL CORROSION DAMAGE ARE FOUND, THE FRONT LOWER CONTROL ARMS WILL BE REPLACED WITH NEW FRONT LOWER CONTROL ARMS INCORPORATING ADDITIONAL HOLES IN THE UPPER AND LOWER PANELS. IF THE FRONT LOWER CONTROL ARMS DO NOT REQUIRE REPLACEMENT, THE DEALER WILL ADD DRAINAGE HOLES TO THE FRONT LOWER CONTROL ARMS AND WILL TREAT THE FRONT LOWER CONTROL ARMS WITH RUST-PROOFING MATERIALS TO ARREST THE INTERNAL CORROSION PROCESS. THESE PROCEDURES WILL BE PERFORMED FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 17, 2009. OWNERS MAY CONTACT THE HYUNDAI CUSTOMER ASSISTANCE CENTER AT 1-800-633-5151.
CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY" A VALVE ON THE FUEL TANK ASSEMBLY MAY NOT CLOSE PROPERLY. IF A VEHICLE ROLLS OVER AND THE FUEL TANK ASSEMBLY VALVE IS NOT PROPERLY CLOSED, FUEL SPILLAGE MAY OCCUR. Remedy: DEALERS WILL INSTALL AN ADDITIONAL FUEL TANK ASSEMBLY VALVE. THE RECALL BEGAN ON OCTOBER 5, 2004. OWNERS SHOULD CONTACT HYUNDAI DE PUERTO RICO AT 1-800-981-0188.
ON CERTAIN PASSENGER VEHICLES, THE REAR BRAKE TUBES PASS BEHIND THE FRONT SUSPENSION CROSSMEMBER. TWO STEERING GEARBOX MOUNTING BRACKETS ARE WELDED TO THE CROSSMEMBER. ON VEHICLES EQUIPPED WITH AN ANTILOCK BRAKE SYSTEM (ABS), THE REAR BRAKE TUBES COULD CONTACT BOTH STEERING GEARBOX MOUNTING BRACKETS. ON VEHICLES THAT ARE NOT EQUIPPED WITH ABS, THE REAR BRAKE TUBES MAY CONTACT ONLY THE LEFT MOUNTING BRACKET. CONTACT BETWEEN THE REAR BRAKE TUBES AND THE STEERING BRACKETS COULD CAUSE WEAR AND CORROSION THAT COULD RESULT IN BRAKE FLUID LEAKAGE. Remedy: DEALERS WILL REPOSITION THE REAR BRAKE TUBES SO THEY DO NOT CONTACT THE MOUNTING BRACKETS, INSTALL BRAKE TUBE CLIPS TO CONTROL THE LOCATION OF THE REAR BRAKE TUBES, AND APPLY ANTI-CORROSION MATERIAL TO THE TUBES IN THE AREAS WHERE CONTACT WITH THE MOUNTING BRACKETS MAY HAVE OCCURRED. OWNER NOTIFICATION BEGAN ON OCTOBER 13, 2003. OWNERS SHOULD CONTACT HYUNDAI AT 1-800-633-5151.
ON CERTAIN SPORT UTILITY VEHICLES, THE DRIVER SEAT BELT BUCKLE WIRING COULD BE DAMAGED BY INTERFERENCE WITH THE DRIVER SEAT CUSHION HEIGHT ADJUSTER MECHANISM. DAMAGED DRIVER SEAT BELT BUCKLE WIRING COULD CAUSE THE SEAT BELT WARNING LAMP OR THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS) AIR BAG WIRING LAMP TO ILLUMINATE. IT COULD ALSO CAUSE THE AIR BAG FUSE (CAVITY NUMBER 5) TO OPEN, PREVENTING AIR BAG DEPLOYMENT. DAMAGED DRIVER SEAT BELT BUCKLE WIRING COULD CAUSE THE SEAT BELT WARNING LAMP OR THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS) AIR BAG WIRING LAMP TO ILLUMINATE. IT COULD ALSO CAUSE THE AIR BAG FUSE (CAVITY NUMBER 5) TO OPEN, PREVENTING AIR BAG DEPLOYMENT. Remedy: DEALERS WILL INSTALL A NEW DRIVER SEAT BELT BUCKLE, IF NECESSARY, AND WILL PLACE A PROTECTIVE COVER OVER THE DRIVER SEAT BELT BUCKLE WIRING TO PREVENT DAMAGE FROM OCCURRING. OWNER NOTIFICATION BEGAN SEPTEMBER 23, 2003. OWNERS SHOULD CONTACT HYUNDAI OF PUERTO RICO AT 1-899-981-0188.
ON CERTAIN SPORT UTILITY VEHICLES, THE FRONT PASSENGER AIR BAG IS MOUNTED BENEATH THE RIGHT PORTION OF THE INSTRUMENT PANEL'S PADDED SURFACE. TEAR LINES ARE FORMED INTO THE UNDERSIDE OF THE INSTRUMENT PANEL'S PADDED SURFACE DURING THE PRODUCTION PROCESS OF THE INSTRUMENT PANEL TOP PAD. THESE TEAR LINES ALLOW A PORTION OF THE INSTRUMENT PANEL SURFACE TO FOLD UPWARD IF THE PASSENGER AIR BAG DEPLOYS. Remedy: HYUNDAI WILL REPLACE THE INSTRUMENT PANEL. OWNER NOTIFICATION BEGAN ON OCTOBER 13, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HYUNDAI OF AMERICA AT 1-800-633-5151, OR IF THE VEHICLE IS LOCATED IN PUERTO RICO, HYUNDAI OF PUERTO RICO AT 1-800-981-0188.
ON CERTAIN PASSENGER VEHICLES, THE DRIVER SEAT BELT BUCKLE WIRING COULD BE DAMAGED BY INTERFERENCE WITH THE DRIVER SEAT CUSHION HEIGHT ADJUSTER MECHANISM. Remedy: DEALERS WILL INSTALL A NEW DRIVER SEAT BELT BUCKLE, IF NECESSARY, AND WILL PLACE A PROTECTIVE COVER OVER THE DRIVER SEAT BELT BUCKLE WIRING TO PREVENT DAMAGE FROM OCCURRING. OWNER NOTIFICATION BEGAN ON MARCH 24, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HYUNDAI AT 1-800-633-5151.
SOME PASSENGER VEHICLES CONTAIN A FUEL TANK ASSEMBLY VALVE THAT MAY NOT CLOSE PROPERLY. IF A VEHICLE WITH A FUEL TANK ASSEMBLY VALVE THAT IS NOT PROPERLY CLOSED WERE TO ROLL OVER, FUEL SPILLAGE MAY OCCUR. Remedy: DEALERS WILL INSTALL AN ADDITIONAL FUEL TANK ASSEMBLY VALVE. OWNER NOTIFICATION BEGAN ON JUNE 30, 2004. OWNERS SHOULD CONTACT HYUNDAI AT 1-800-633-5151.
ON CERTAIN PASSENGER VEHICLES, THE LEFT LOWER INSTRUMENT PANEL BRACKET WAS NOT INSTALLED. Remedy: DEALERS WILL INSPECT THE VEHICLES TO DETERMINE IF THE BRACKET HAS BEEN INSTALLED. IF THE BRACKET HAS NOT BEEN INSTALLED, THE DEALER WILL INSTALL THE LEFT LOWER INSTRUMENT PANEL BRACKET. OWNER NOTIFICATION BEGAN MARCH 4, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HYUNDAI AT 1-800-633-5151.
ON CERTAIN PASSENGER VEHICLES, THE BRAKE TUBES FOR THE REAR BRAKES CAN CONTACT THE STEERING GEARBOX MOUNTING BRACKETS. Remedy: DEALERS WILL REPOSITION THE REAR BRAKE TUBES, INSTALL BRAKE TUBE CLIPS, AND APPLY ANTI-CORROSION MATERIAL TO THE REAR BRAKE TUBES. OWNER NOTIFICATION BEGAN JANUARY 22, 2004. OWNERS SHOULD CONTACT HYUNDAI OF PUERTO RICO AT 1-800-633-5151.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles operated in areas of heavy road salt usage (Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island, and Newfoundland & Labrador), road salt can collect in the outboard portion of the front lower control arm and may result in internal corrosion leading to thinning of the steel in the lower control arms. In severe cases, the corrosion may progress to the point where the lower control arm's upper and lower panels become perforated. A perforated front lower control arm may fracture between its ball joint attachment and the forward and rearward pivot attachments to the chassis. This could result in a loss of vehicle control and a crash causing property damage, personal injury or death. Correction: Dealers will inspect and, if necessary, replace the front lower control arms. Should the control arms not require replacement, drainage holes will be added, as well as treatment with rust-proofing material to arrest the corrosion process.
On certain vehicles, the fuel tank assembly valve may not close properly. If a vehicle with a fuel tank assembly valve that is not properly closed were to roll over, fuel spillage could occur. Fuel spillage in the presence of an ignition source may result in a fire. Correction: Dealer will install an additional fuel tank assembly valve.
On certain vehicles, the thickness of the instrument panel pad at the tear lines is 0.74mm, which is thicker than the specified 0.4 =/- 0.05mm. The thicker material at the tear line inhibits the ability of the instrument panel surface to fold upward if the passenger airbag deploys. This may adversely affect the deployment of the passenger airbag. Correction: Dealer will replace the instrument panel.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles, the rear brake tubes may contact the steering gear box mounting brackets resulting in rear brake tube wear and corrosion. Severe rear brake tube wear and corrosion may result in brake fluid leakage reducing braking capability. Correction: Dealer will reposition the rear brake tubes, install clips to control the position of the tubes and apply anti-corrosion material where contact with the steering gear box mounting brackets may have occurred.
On certain vehicles, the driver seat belt buckle wiring may be damaged by interference with the driver seat cushion height adjuster mechanism. Damaged driver seat belt buckle wiring may cause the seat belt warning lamp and the Supplemental Restraint System (SRS) airbag warning lamp to illuminate. It could also cause the airbag fuse to open, preventing airbag deployment and increasing the risk of injury during a collision where deployment is intended. Correction: Dealers will protect the wiring, and if necessary, replace the driver seat belt buckle.